Bedienungsanleitung Stiga 8211-0007-70

17 Seiten 2.13 mb
Download

Zur Seite of 17

Summary
  • Stiga 8211-0007-70 - page 1

    STIGA PARK DIESEL DIESEL 4WD 8211-000 7-70 BRUKSANVISNING KÄYTTÖOHJEET BRUGSANVISNING BRUKSANVISNING GEBRAUCHSANWEISUNG INSTRUCTIONS FOR USE MODE D’EMPLOI GEBRUIKSAANWIJZING SV .... 7 FI ... 1 7 DA .. 27 NO . 37 DE ... 47 EN ... 5 8 FR .... 68 NL ... 79 ...

  • Stiga 8211-0007-70 - page 2

    2 S T A B C F D E G HI J K 2WD P Q 4WD G HI J K L N O M 2WD R 1 3 5 2 4 6 ...

  • Stiga 8211-0007-70 - page 3

    3 4WD BA Max Max C V U Y W E 7 9 11 8 10 12 ...

  • Stiga 8211-0007-70 - page 4

    4 A B C C P D 0 1 F V 13 15 17 14 16 18 ...

  • Stiga 8211-0007-70 - page 5

    5 G H I J 19 21 23 20 22 24 ...

  • Stiga 8211-0007-70 - page 6

    6 4WD 2WD 25 27 29 26 28 30 ...

  • Stiga 8211-0007-70 - page 7

    58 ENGLISH EN 1 GENERAL This symbol indicates W ARNING . Seri- ous personal injury and/or damage to property may result if the instructions are not followed car efully . Y ou must r ead these instructions for use and the accompanying pamphlet “SAFETY INSTR UCTIONS” car eful- ly , before starting up the machine. 1.1 SYMBOLS The following symbols ...

  • Stiga 8211-0007-70 - page 8

    59 ENGLISH EN 2.4.2 Implement lifter, hydraulic (4:M) (4WD) The hydraulic implement lifter only works when the engine is running and the clutch pedal and parking brake pedal are not depressed. The imple- ment lifter is controlled using the lever (4:M). The lever has the following four positions: Floating position . Move the lever to it s front posi ...

  • Stiga 8211-0007-70 - page 9

    60 ENGLISH EN 2.4.9 Ignition lock (4,5:I) Ignition lock used for starting/stopping the engine. There are 3 positions: 1. Stop position – the engine is short-cir- cuited. The key can be removed. 2. Operating position 3. Start position – the electric start motor is activated when the key is turned to the spring-loaded start position. Once the en- ...

  • Stiga 8211-0007-70 - page 10

    61 ENGLISH EN 2.4.18 Seat (1:T) The seat can be folded and adjusted front- rear . The seat can be adjusted as follows: 1. Move the control lever (1:S) upwards. 2. Set the seat to the desired position. 3. Release the control lever (1:S) to lock the seat. The seat is equipped with a safety switch that is connected to the machine’ s safety system. T ...

  • Stiga 8211-0007-70 - page 11

    62 ENGLISH EN Only fill or top up with fuel outdoors, and never smoke when filling or top- ping up. Fill with fuel before starting the engine. Never remove the fuel cap or fill with fuel while the engine is running or still warm. 4.2 Bleeding The engine’ s fuel system must be bled in the fol- lowing instances: • If the fuel tank has been run dr ...

  • Stiga 8211-0007-70 - page 12

    63 ENGLISH EN 4.6 Start 1. Do not keep your foot on the drive pedal. 2. Put the throttle control at full throttle. 3. Depress the brake pedal fully . 4. Turn the ignition key and start the engine. The engine does not need to be preheated. 5. When starting from cold, do not make the ma- chine work under load immediately , but let the engine run for ...

  • Stiga 8211-0007-70 - page 13

    64 ENGLISH EN 5.2 Preparation All service and all maintenance must be carried out on a stationary machine with the engine switched off. Prevent the machine from r olling by al- ways applying the parking brake. S top the engine. Prevent unintentional starting of the motor by always stopping the motor and disconnecting the negative cable from the bat ...

  • Stiga 8211-0007-70 - page 14

    65 ENGLISH EN The engine must be cold when the con- densation id drained, otherwise there is a risk of fire. Smoking, fires, sparks and other heat sources ar e prohibited in the proximity when the condensation is drained. There is a fire risk. Drain the condensation as follows: 1. Detach the drain hose from the its mounting un- der the rear bumper ...

  • Stiga 8211-0007-70 - page 15

    66 ENGLISH EN 5.10 Steering The steering must be checked/adjusted after 5 hours of operation and thereafter after 100 hours of operation. 5.10.1 Checks Briefly turn the steering wheel back and forth. There must be no mechanical clearance in the steering chains. 5.10.2 Adjustment Adjust the steering chains if required as follows: 1. Put the machine ...

  • Stiga 8211-0007-70 - page 16

    67 ENGLISH EN 3. Disconnect the air filter housing by slacken ing off th e wing nut (23:H). 4. Remove the filter (24: I) by slackening off the ridged nut (24:J). Never direct the flow of compressed air towards the body . The penetration of air into the blood stream can be fatal. 5. Clean of f any dry dirt on the filter by blowing compressed air in ...

  • Stiga 8211-0007-70 - page 17

    www .stiga.com GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS ...

Produzent Stiga Kategorie Automobile

Dokumente, die wir vom Produzenten des Geräts Stiga 8211-0007-70 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Stiga
- Bedienungsanleitungen 8211-0007-70
- Produktkarten Stiga
- Informationsbroschüren
- oder Energieetiketten Stiga 8211-0007-70
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Stiga 8211-0007-70.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Stiga 8211-0007-70, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Stiga 8211-0007-70. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Stiga 8211-0007-70 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Stiga 8211-0007-70, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Stiga 8211-0007-70 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Stiga 8211-0007-70 verständlich ist.

Eine gänzliche Bedienungsanleitung von Stiga sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Stiga 8211-0007-70 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Stiga 8211-0007-70 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Stiga 8211-0007-70, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Stiga 8211-0007-70 - die uns die ersten Schritte während der Nutzung von Stiga 8211-0007-70 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Stiga 8211-0007-70 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Stiga 8211-0007-70 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Stiga 8211-0007-70?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Stiga 8211-0007-70 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Stiga 8211-0007-70 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (1)

Claudia

our cameras are offline and we are unable to restart with the installation as impossible to cancel them from the program