-
Craftsman 104.79212 - page 1
Operator's Manual ® 4-Cycle PROPANE POWERED TRIMMER Models: 104.79212 104.79211 16.4 oz. / 465 g propane bottle not included For assistance with assembly or operation call: 1-800-235-5878 • SAFETY • ASSEMBLY • OPERATION • MAINTENANCE • TROUBLESHOOTING • WARRANTY CAUTION" Before using this product, read this manual and follow ...
-
Craftsman 104.79212 - page 2
CRAFTSMAN 4-CYCLE PROPANE TRIMMER TABLE OF CONTENTS Service and Safety ..................................................................... 2 Safe Operation Rules ................................................................. 3 Understanding your trimmer. ................................................. 4 Assembly ............................. ...
-
Craftsman 104.79212 - page 3
• Never start or run the unit inside a closed room or build ing. Breathing exhaust fumes can be fatal. Operate this unit only in a well ventilated outdoor area. • Wear safety glasses or goggles that meet ANSI Z87.1 standards andare marked as such. Wear ear/hearing protection when operating this unit. Wear a face or dust mask if the operation is ...
-
Craftsman 104.79212 - page 4
SAFETY & INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. WARNING: Indicates danger, warning or caution. May be used in conjunction with oth ...
-
Craftsman 104.79212 - page 5
TOOL KIT Your unit is provided with a tool kit (Fig.l). This tool kit consists of the following: 4 mm Allen Wrench 5 mm Allen Wrench _¢// 8 & 10 mm Wrench _ Four 5 mm Screws (/_ with captive washers I _ FourWashers Straight Shaft models /_j_--k_J include 2 Plate Washers _ Fig. 1 INSTALLING CUTTING ATTACHMENT SHIELD Use the following instructio ...
-
Craftsman 104.79212 - page 6
RECOMENDED OIL TYPE Using the proper type and weight ofoil in the crankcase is extremely important. Check the oil before each use and change the oil regularly. Failure to use the correct oil, or using dirty oil, can cause premature engine wear and failure. Use a high-quality SAE 10W-30 weight oil of API (American Petroleum Institute) service class ...
-
Craftsman 104.79212 - page 7
SAFETY WARNINGS FOR PROPANE UNITS NOTE: Use propane only in containers specifically designed and approved for this unit. Propane is a combustible gas; it is colorless and thus invisible to the naked eye. Propane has a harmless odorant added so that it is possible to smell it. The propane odorant makes the propane smell like sulfer or rotten eggs. I ...
-
Craftsman 104.79212 - page 8
WARNING: Propane is highly flamable, and its vapors can explode if ignited. Take the following precautions. USE THE CORRECT PROPANE CANISTER Always use Propane canisters or "Bottles" that are the correct size. The 17 ounce or 16.4 ounce canisters that are approximately 3-7/8 inch in diameter are the cor - rect canisters (Fig.8). Do not us ...
-
Craftsman 104.79212 - page 9
AVAILABLE CUTTING ATTACHMENTS Brushcutter attachment .................................................. 358.79244 Edger attachment .............................................................. 358.79240 Cultivator attachment ...................................................... 358.79241 Blower attachment ......................................... ...
-
Craftsman 104.79212 - page 10
STARTING INSTRUCTIONS 1. Check the oil level in the crankcase. Refer to Checking the Oil Level ( p.] 2). 2. Turn switch to ON position (Fig.] 4). NOTE: If your unit is equipped with a spring loaded type ON/OFF switch, it will always remain in the ON position. 3. Place trimmer firmly on the ground or a very sturdy work surface. Make sure cutting hea ...
-
Craftsman 104.79212 - page 11
OPERATING YOUR TRIMMER Before operating the unit, stand in the operating position (Fig. 15). Check for the following: • The operator is wearing eye protection and proper clothing. • With a slightly bent right arm, the operator's right hand is holding the shaft grip. • The operator's left arm is straight, and left hand holding the up ...
-
Craftsman 104.79212 - page 12
FREQUENCY MAINTENANCE REQUIRED REFER TO EVERY 10 HOURS CLEAN AND RE-OIL AIRFILTER PAGE 13 EVERY25 HOURSTHEREAFTER CHECKOIL PAGE 13 L%/ERY25HOURS CHECKSPARKPLUG POSIT1ONGAP PAGE 4 EVERY2S HOURS ROCKER ARM CLEARANCE ADJUSTMENT PAGE 16 Perform these required maintenance procedures at the frequency stated in the table. These procedures should also be a ...
-
Craftsman 104.79212 - page 13
CHANGING THE OIL For a new engine, change the oil after the first 10 hours of operation. Change the oil while the engine is still warm but not hot. The oil will flow freely and carry away more impurities. 1. Unplug spark plug wire to prevent accidental starting. 2. Remove the oil fill plug/dipstick. 3. Pour the oil out of the oil fill hole and into ...
-
Craftsman 104.79212 - page 14
CARBURETOR ADJUSTMENT The idle speed of the engine is adjustable. An idle adjust- ment screw is on the rear side of the carburetor (Fig. 21). NOTE: Careless adjustments can seriously damage your unit. Only a Sears or other qualified dealer should make carburetor adjustments. CLEAN AIR FILTER The condition of the air filter is important to the opera ...
-
Craftsman 104.79212 - page 15
LINE REPLACEMENT For Hassle-Free TM Cutting Head Always use Craftsman Hassle Free XTRA QUIET Spiral Line. Choose the line size best suited for the job at hand. Red colored line is designed for cutting grass and small weeds. Black colored line is designed for cutting larger weeds and light brush. NOTE: Before inserting new line into the holes in the ...
-
Craftsman 104.79212 - page 16
ROCKER ARM CLEARANCE ADJUSTMENT 1. Remove the four screws on the engine cover with a phillips head screw driver (Fig. 26). 2. Remove the engine cover. 3. Disconnect the spark plug wire. 4. Clean dirt from around the spark plug. Remove the spark plug by using tool provided, turn counterclock- wise. This requires partial dissasembly of the engine. If ...
-
Craftsman 104.79212 - page 17
CLEANING Use a small brush to clean the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and sol - vents such as kerosene, can damage plastic housing or handle. Wipe offany moisture with soft cloth. STORAGE • Remove propane canister. • Never store the unit with attached pro ...
-
Craftsman 104.79212 - page 18
ENGINE _ ENGINETYPE AIR-COOLED 4-CYCLE DISPLACEMENT 25.4 CC CLUTCH TYPE CENTRIFUGAL OPERATING R.P.M. 6,800-9,300 R.P.M. IDLE SPEED 3,000-3,400 R.P.M. IGNITION TYPE ELECTRONIC IGNITION SWITCH PUSH ON/OFF SWITCH VALVE CLEARANCE 0.003-0.006 INCHES (0.076-0.152 mm) SPARK PLUG GAP 0.02 INCHES (0.5 mm) LUBRICATION SAE 10W-30 OIL FUEL PROPANE 16 OZ. / 465 ...
-
Craftsman 104.79212 - page 19
CRAFTSMAN FULL WARRANTY If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears store, Parts and Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair prove s impossible). This warranty applies for only 90 ...
-
Craftsman 104.79212 - page 20
Your Home For expert troubleshooting and home solutions advice: www.managemyhome.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For ...
Haben Sie eine Frage bezüglich Craftsman 104.79212?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Craftsman 104.79212 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Craftsman 104.79212 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.