Bedienungsanleitung Bose II

28 Seiten 8.56 mb
Download

Zur Seite of 28

Summary
  • Bose II - page 1

    Bose ® Aviation Headset Series II Owner's Guide ...

  • Bose II - page 2

    2 As with any complex electronic device, it is possible for this headset to experience a failure during operation. Such a failure may include loud tones, distortion and loss of communications signal in the headset when used in the active or “on” position. The system is “on” when the rocker switch is “up”. Note: This failure could pr eve ...

  • Bose II - page 3

    3 Operational Advisories This headset meets or exceeds all requir ements of EN352-4, 1996 (European Standar d-Hearing Pr otectors-Safety Requirements and T esting-Part 4: Level-Dependent Ear Muffs). • The wearer should ensur e that: i. The ear muffs ar e fitted, adjusted, and maintained in accordance with the manufactur er’ s instructions. ii. ...

  • Bose II - page 4

    4 Declaration of Conformity W e, the offer er: Bose ® Corporation, The Mountain, Framingham, MA 01701-9168 USA acknowledge our sole responsibility , that the product: Kind of equipment: Headset T ype designation: Bose Aviation Headset Series II in accordance with EMC Directive 89/336/EEC and Article 10(1) of the Directive, is in compliance with th ...

  • Bose II - page 5

    5 Operational Advisories ............................................................ 2 Intr oduction ............................................................................. 6 Description ....................................................................... 6 W ar ranty car d ................................................................. ...

  • Bose II - page 6

    6 Introduction Description Congratulations on your purchase of the Bose ® Aviation Headset Series II. This headset uses an advanced combination of electro-acoustical noise reduction cir cuitry and a patented cushioning system to signifi- cantly reduce air craft noise. It actively r educes noise elements in addition to muffling noise. The patented ...

  • Bose II - page 7

    7 Using the Bose ® Aviation Headset For pr oper headset fit Note: The headset must be worn with the Bose logo (located on the earcups) facing forwar d. T o achieve comfort and good performance, adjust both sides of the headband equally to pr ovide a comfortable fit. T o achieve a good seal, lightly grasp both earcups and position them so that your ...

  • Bose II - page 8

    8 Inter connect plug The headset interconnect plug connects the headset cable to a power source. The power sour ce can be an installed connector in the air craft’ s control panel or an adapter cable connected to a por table battery pack. The interconnect plug is designed for quick connection and r emoval. T o ensur e correct pin alignment, the pl ...

  • Bose II - page 9

    9 Adjusting the volume The volume for your headset is controlled by the gr ooved knobs located on the front side of the headband arms. Avoid setting your volume contr ols at high levels that may af fect your hearing during extended periods of headset use. Note: The volume controls and the active noise r educing cir cuitry work only when the headset ...

  • Bose II - page 10

    10 Micr ophone boom r elocation T o suit your flying prefer ence, the headset boom can easily be moved from one ear cup to the other . 1. Unscrew the r etaining knob on the boom mic mount. 2. Unplug the mic cable fr om the headband arm. Figure 7 Unplugging the mic cable 3. Find the cr escent-shaped flanges on the top and bottom of the boom’ s att ...

  • Bose II - page 11

    11 4. Plug the mic cable into the headband arm. Y ou may want to use the adjustment scr ew to tighten the tension of the clip on the boom mic. The adjustment screw is on the flat end of the clip. Use a 3 ⁄ 32 in. hex wrench to tighten it. Do not over -tighten. Experience in using the headset helps establish your sense of how it should sound. If y ...

  • Bose II - page 12

    12 Using the Bose ® Aviation Headset Powering the headset The Bose Aviation Headset Series II may be power ed in one of two ways: a portable battery pack, or a connector installed into the aircraft’ s instrument panel. Portable batter y pack The portable battery pack is available in two versions: NICAD rechar geable and alkaline. The NICAD recha ...

  • Bose II - page 13

    13 Using the Bose ® Aviation Headset 2 4 1 6 5 Spin the batteries once with thumb to seat them securely . 3 Inserting batteries into the alkaline batter y pack ...

  • Bose II - page 14

    14 12 Click Click 11 10 9 8 7 Using the Bose ® Aviation Headset ...

  • Bose II - page 15

    15 Installed connector An optional installed connector is available for pilots who want to har dwire the DC power , incoming audio, and outgoing microphone functions per manently into their plane. The panel mount receptacle comes wired with a 6 foot har ness to simplify the installation process. T o order this connector , contact the Bose Aviation ...

  • Bose II - page 16

    16 Using the Bose ® Aviation Headset 5. Approved adhesives for use with this connector are Ciba-Geigy Uralane 5754- A/B, Lord 710, or VTCS-6 Vibratite. Do not let any cyanoacrylate-based adhesives (e.g., Loctite), flux remover , or other caustic compounds come into contact with the installed connector body . These chemicals will cause deterioratio ...

  • Bose II - page 17

    17 Installed DC power connector An optional installed connector is available for pilots who want to use their plane’ s DC power , instead of the battery pack, with the portable adapter cable. The connector’ s small size allows it to be installed in a convenient location in the control panel, for example, near the head- phone and mic jacks. Inst ...

  • Bose II - page 18

    18 Cleaning instructions Clean the headset exterior and cushions by wiping them with a moist cloth. Mild soap may be used. CAUTION: Do not immerse the headset in water . The headband cover is made from leather and sheepskin. If it becomes soiled, it may be removed and cleaned using mild soap. T o r emove the headband cover , peel apart the hook and ...

  • Bose II - page 19

    19 T o install a new foam liner Note: The left and right foam liners are dif ferent. 1. Lift the old foam liner out of the ear cup. 2. Place the new foam liner in the ear cup. With the correct foam liner in place, nesting along the walls of the cavity , its half-moon shaped opening should cover the microphone, and the small opening in the foam line ...

  • Bose II - page 20

    20 Communication but no active noise r eduction in both ears. Problem What to do In Case of Dif ficulty • Make sure that your headset is powered, and that the power switch is “ON.” • If using DC power from the aircraft, check the aircraft fuse or breaker . • If using the NICAD battery pack, verify that it is charged. • If using the alka ...

  • Bose II - page 21

    21 Sound pr essure levels (SPL) are r elative to 20 micro Pascal. Earphones Damage could occur to avionics equipment if it was manufactured for use only with 600 Ω (ohm) headsets. If in doubt, consult the avionics equipment manufacturer . Impedance In mono mode: 480 Ω (on) and 190 Ω (off) at 1kHz. In stereo mode: left, 500 Ω (on), 190 Ω ( ...

  • Bose II - page 22

    22 T echnical Information Headset Weight 22 oz. (567 grams) T emperature and Altitude (Category A1) Operating T emperature: +5 ° to +131 ° F (-15 ° to +55 ° C) Storage T emperature: -67 ° to +158 ° F (-55 ° to +70 ° C) Altitude: 15,000 ft. maximum pressur e altitude for full cancellation The Bose ® Aviation Headset Series II headset, adapt ...

  • Bose II - page 23

    23 Service Bose ® Aviation Headset Service Depar tment 145 Pennsylvania Avenue Framingham, MA 01701-9168 U.S.A. TEL: 1-800-233-4416 (U.S.) 1-508-879-7330, ext. 62006 (outside U.S.) F AX: 1-508-820-3465 Contact the Bose Aviation Headset Service Department for: • accessories. • technical advice. • installation information. • warranty and rep ...

  • Bose II - page 24

    24 Limited warranty Bose ® product What is covered All parts defective in material or workmanship. For how long At least one year from the purchase date, or longer if specified in your owner’s manual, but not longer than five years from the purchase date. What we will do We will, at our sole option, repair or replace any defective parts free of ...

  • Bose II - page 25

    25 Notes ...

  • Bose II - page 26

    26 Notes ...

  • Bose II - page 27

    27 ...

  • Bose II - page 28

    © 1997 Bose Corporation The Mountain, Framingham, MA 01701-9168 USA JN97884 PN183953 Rev. 01 AM183953 Rev. 01 ...

Produzent Bose Kategorie CD Player

Dokumente, die wir vom Produzenten des Geräts Bose II erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Bose
- Bedienungsanleitungen II
- Produktkarten Bose
- Informationsbroschüren
- oder Energieetiketten Bose II
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Bose II.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Bose II, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Bose II. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Bose II ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Bose II, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Bose II hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Bose II verständlich ist.

Eine gänzliche Bedienungsanleitung von Bose sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Bose II bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Bose II befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Bose II, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Bose II - die uns die ersten Schritte während der Nutzung von Bose II erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Bose II hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Bose II im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Bose II?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Bose II nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Bose II hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)