-
Adcom 7705 - page 1
GF A-7705 & GF A-7707 S.A.F .E. ® HIGH CURRENT , MUL TI-CHANNEL POWER AMPLIFIERS ...
-
Adcom 7705 - page 2
...
-
Adcom 7705 - page 3
• Precision-matched dev ices used throughout the signal path. • Independent power supplies for each channel. • F ewer gain stages improve signal reproduction accur acy . • Custom toroidal power tr ansformer prov ides better regulation and greater peak current capability . • ADCOM-Universal pre-prepped chassis and internal power supplies f ...
-
Adcom 7705 - page 4
Introduction Congratulations on your decision to purchase the GF A-7705/07 multi-channel power ampli er . The GF A-7705/ 07 integrates very well with any other home theater system, such as Dolby P roLogic ™ or Dolby Digital ™ or Dolby Digital ™ ™ . Y ou have made a wise choice that will reward you with exceptionally accurate and musical ...
-
Adcom 7705 - page 5
Rear P anel Inputs (1) The audio inputs for the GF A-7705 and 7707 are through high-quality , gold-plated RCA jacks to minimize high- frequency losses, noise, etc. They will accept standard RCA-type plugs, one for each of the ve channels; Front L (Left), Center , Front R (Right), Surround L (Left), and Surround R (Right). T o insure that the pe ...
-
Adcom 7705 - page 6
6 W ARNING THERE ARE NO USER-SER VICEABLE P AR TS OR FUSES INSIDE THE GF A-7705/07. In the event that the ampli er ’ s rear-panel circuit breaker fails to reset (opens again when power applied to unit and unit turned on) you must refer the ampli er to ADCOM Factory Service or ADCOM Authorized Service Center . turned on) you must refer the a ...
-
Adcom 7705 - page 7
Front P anel On/Off Switch (5) The On/Off Switch controls power to the power transformer and circuits of the GF A-7705/07. Whenever the GF A-7705/07 is energized the P ower LED (7) will glow . T o turn the GF A-7705/07 on, press the push-button. It will remain in the “engaged” position while the unit is energized. T o turn the GF A-7705/07 off, ...
-
Adcom 7705 - page 8
8 Distortion Alert LEDs (7) The Dis tort ion Alert cir cuit is a uni que ADCOM dis tort ion d etec tion syst em w hich read s al l fo rms o f no n- lin ear dist ortio n su ch a s T HD, IM, s lew- indu ced, “cli ppin g,” e tc. The Dis tort ion Alert LED s wil l li ght whe n di stor tion reac hes appro xima tely 1% r egar dles s of impe danc e, v ...
-
Adcom 7705 - page 9
9 W ARNING Whenever connections to or from the GF A-7705/07 are being made, be certain that the AC On/Off Switch (5) of the ampli er is in the OFF position, the AC P ower Cord (4) of the ampli er is disconnected from the AC wall outlet and that all associated components are turned off. Installation & Hookup Unpacking the GF A-7705/07 Befo ...
-
Adcom 7705 - page 10
10 Connecting the GF A-7705/07 R emember , that the Left and Right designations are as you are sitting down in your listening/viewing area. On the rear panel, the inputs and outputs are grouped in 5 or 7 bracketed sets, one set for each channel. They are as follows: LB — Left Back (GF A-7707 only) LS — Left Surround LF — Left Front C — Cent ...
-
Adcom 7705 - page 11
11 Inputs (1) T o preserve the correct effects, be certain to connect the RCA cables to the proper RCA-input connector . If the cables are color coded, then use this sequence for the connections: Blue ............................................................ Left Front R ed ........................................................... Right Front ...
-
Adcom 7705 - page 12
It is suggested that the three front channels follow this chart for speaker lengths and wire gauges. up to 24 feet ...................................... A WG16 up to 36 feet ...................................... A WG14 up to 58 feet ...................................... A WG12 Generally , for the two rear surround channels, longer runs of cable ...
-
Adcom 7705 - page 13
T roubleshooting Resolv ing Problems Use the chart below to solve common situations that don’t require professional attention. If the steps stated in POSSIBLE SOLUTION do not resolve your problem, then please contact your ADCOM Dealer or call the ADCOM Customer Service Department. Any problems not covered here should be brought to the attention o ...
-
Adcom 7705 - page 14
Serv icing ADCOM has a T echnical Service Department to answer questions pertinent to the installation and operation of your unit. In the event of dif culty , please contact us for prompt advice. Please have the following information readily at hand: the unit’ s model and serial numbers, and dealer from whom it was purchased. If your problem c ...
-
Adcom 7705 - page 15
GF A-7700/7707 Speci cations P ower Rating (T o EIA/CEA-490-A Requirements 200 W atts continuous average power per channel into 8 ohms at any frequency between 20Hz and 20kHz with all channels driven at less than 1% THD. 300 W atts continuous average power per channel into 4 ohms at any frequency between 20Hz and 20kHz with all channels driven a ...
-
Adcom 7705 - page 16
8541 East Anderson Drive Scottsdale, Arizona 85255 V oice: (480) 607-2277 Fax: (480) 348-9876 www .adcom.com gfa7705/07_manual_v1 ...
¿Tienes una pregunta acerca de Adcom 7705?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Adcom 7705, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Adcom 7705 probablemente compartirá una forma de solucionarlo.