Manuel d’utilisation Stiga 1171 HST

18 pages 0.61 mb
Télécharger

Aller à la page of 18

Summary
  • Stiga 1171 HST - page 1

    STIGA ROYAL LINE 966 D 1171 HST 1381 HST 8218-2222-70 BRUKSANVISNING KÄYTTÖOHJEET BRUGSANVISNING BRUKSANVISNING GEBRAUCHSANWEISUNG INSTRUCTIONS FOR USE MODE D’EMPLOI SV .... 8 FI ... 1 8 DA . 2 8 NO . 38 DE .. 48 EN .. 59 FR ... 69 ...

  • Stiga 1171 HST - page 2

    2 6 5 4 3 2 1 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 . A D E F 1 2 3 ...

  • Stiga 1171 HST - page 3

    3 G L M Man K J 1 2 3 4 5 7 M L HST 4 6 8 5 7 9 ...

  • Stiga 1171 HST - page 4

    4 AB C 5 6 8 3 2 3 10 12 14 11 13 15 ...

  • Stiga 1171 HST - page 5

    5 1 2 Man A B C D E F G H I HST J A B E L G I E Man HST E L J 16 18 20 17 19 21 ...

  • Stiga 1171 HST - page 6

    6 HST 12 - 13 mm 12 Man Man M N O M Q Man 22 24 26 23 25 27 ...

  • Stiga 1171 HST - page 7

    7 Man 4 5 6 8 4 Man 8 7 14 13 13 7 17 17 Man A E C B D Man 28 30 29 31 ...

  • Stiga 1171 HST - page 8

    59 ENGLISH EN 1 SYMBOLS The following symbols appear on the machine. They are there to remind you of the care an d attention required in use. This is what the symbols mean: Wa r n i n g . Read and understand the owner ’ s manual before using this machine. Remove the key , disconnect the spark plug wire, and consult technical literat ure before pe ...

  • Stiga 1171 HST - page 9

    60 ENGLISH EN • Never drive across a slope. Mo ve from the top down, and from the bottom to the top. Be careful when changing direction on a slope. A void steep sl opes. • Never operate the machine with insufficient protection or without the safety devices in place. • Existing safety devices mu st not be di sco nnected or disengaged. • Do n ...

  • Stiga 1171 HST - page 10

    61 ENGLISH EN 3.7 GEAR LEVER/SPEED LEVER Manual, see fig. 6. HST , see fig. 7. 1. Set the lever in a suitable position to simp ly fit the angle link (L) into the hole in the gearbox lever (M). 2. Assemble the washer and the lock nut. 3. T ighten the nut. 3.8 CHECKING THE CONTROL WIRES The control wires might need adjustin g be fore using the snow t ...

  • Stiga 1171 HST - page 11

    62 ENGLISH EN 4.18 SHOES (13) Used to set the height of the auger housi ng above the ground. 4.19 WHEEL LOCK 4.19.1 HST See fig. 8. Machines wit h h ydrostat are equipped with easily disengaged wheel locks. This is essential when mowin g the machine without the motor running. Disengage/engage the whee l locks according to the following: 1. Pull out ...

  • Stiga 1171 HST - page 12

    63 ENGLISH EN 5.5 STARTING THE ENGINE (WITH ELECTRICAL START) Do not touch engine comp onents because they are warm during use. Risk of burn injuries. Never run the machine indoors. The exhaust fumes contain carbon monoxide, a very toxic gas. 1. Attach the connecting cable to an earthed extension lead. Then connect the extension l ead to a 220/230 ...

  • Stiga 1171 HST - page 13

    64 ENGLISH EN 5.9 AFTER USE 1. Check for loose or damaged parts. If required, chan ge damaged parts. 2. Tighten loose screws and nuts. 3. Brush all the snow from the machine. 4. Move all the controls backwards and forwards a few times. 5. Put the choke in positio n 6. Disconnecting the starting cable from the sp ark pl ug. Do not cover the machin e ...

  • Stiga 1171 HST - page 14

    65 ENGLISH EN 6.6.4 Chute worm ge ar See fig. 13. If the discharge chute is dif ficu lt to operate, first lubricate the pinion gear (B) and ring gear (A). If it is still difficult to operate, adjust as follows: 1. Loosen the nut (C), which holds the pinion gear bracket in the slotted hole. 2. If the pinion gear is too tight against the ring gear, m ...

  • Stiga 1171 HST - page 15

    66 ENGLISH EN 7.4 THE AUGER BELT 7.4.1 Repla cing the auger belt Man, see fig. 18, 19. HST , see fi g. 20, 21. 1. Remove th e ignition key . 2. Loosen the screws (3) and dismantle the bottom plate (2). See fig. 16. 3. Remove the belt protective cover (1) by loosening the screws (2). See fig. 16. 4. Loosen the belt guide (E) at the engine belt disc. ...

  • Stiga 1171 HST - page 16

    67 ENGLISH EN 7.7 ADJUSTING THE CONTROL WIRES When the belts are adjusted or replaced, the control wires must also be checked/adjusted (see below). 7.7.1 Adjus ting auger wir e 1. Remove the ignition key . 2. Dismantle the belt cover (1) by loosing th e screw (2). See fig. 16. 3. Actuate the auger drive lever and observe the tension pulley . When t ...

  • Stiga 1171 HST - page 17

    68 ENGLISH EN 7.11 HEADLAMP BULB Only 27 W original spare part bulb is allowed to be used. Bulbs with higher power will damage the headlamp. The headlamp bulb is fitted to the headlamp by a bayonet socket. See fig. 17. T o replace the bulb proceed as follows: 1. T urn the bulb about 30° CCW and pull it out. 2. Release the plastic locks at each sid ...

  • Stiga 1171 HST - page 18

    www . stiga.com GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS ...

Fabricant Stiga Catégorie Snow Blower

Les documents que nous recevons du fabricant de l'appareilStiga 1171 HST peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Stiga
- manuels d’utilisations 1171 HST
- fiches produit Stiga
- dépliants
- ou étiquettes-énergie Stiga 1171 HST
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Stiga 1171 HST.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Stiga 1171 HST, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Stiga 1171 HST. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Stiga 1171 HST.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Stiga 1171 HST, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Stiga 1171 HST par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Stiga 1171 HST.

Le manuel d’utilisation complet Stiga, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Stiga 1171 HST - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Stiga 1171 HST, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lStiga 1171 HST qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Stiga 1171 HST - qui devraient nous aider dans les premières étapes lors de l'utilisation Stiga 1171 HST
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Stiga 1171 HST
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Stiga 1171 HST dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Stiga 1171 HST?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Stiga 1171 HST, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Stiga 1171 HST il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)