Manuale per l’uso AT&T 1305

14 pagine 0.39 mb
Scarica

Vai alla pagina of 14

Summary
  • AT&T 1305 - page 1

    Use r ’ s Manual for An s w ering System 1 305 F old open this ma n ual f or in f ormation about this p r oduct ’ s installation and ope r ation . Please r ead Part 1 – Important Product Info r mation, in c luded in this packa g e. Part 2 © 1998 Philips Consumer Communications L. P . All r ights r ese r v ed. P r inted in China . 848230066 I ...

  • AT&T 1305 - page 2

    INS T ALL A TION 1 Insert the mic r ocassette. Slide the c o v er down and insert the microcassette with the full reel at the bottom . Replace the co v e r . 1 2 Connect the line cord. Plug the line cord into a modular w all ja c k. 3 Connect a telephone (optional). Plug the line cord f r om the telephone into the TEL SET jack on the ba c k of the ...

  • AT&T 1305 - page 3

    OPER A TION 2 Repeat all or part of a message / Reco r d a memo or phone conversation Skip all or part of a message / Reco r d outgoing message Mic r ophone Begin message playback / Stop or pause message playback Dec r ease volume / Erase all or selected messages Reco r ding Y ou r Announcement Be f o r e using this an s w e r ing system , y ou nee ...

  • AT&T 1305 - page 4

    2 P r ess and hold A f or t w o seconds , then release the button and w ait f or the system to beep. 3 After the beep , speak to w ard the microphone , f r om about nine in c hes a w a y . 4 P r ess and release p , w hen y ou a r e finished . The tape resets automatical l y and pl a ys the announcement , and the MESS A GE light goes on. T o r eview ...

  • AT&T 1305 - page 5

    Priority Call Signal When a caller ente r s the P r io r ity Calling Code f r om a tou c h tone phone , the system beeps loud l y to ale r t y ou that you ha v e a p r iority call . Y ou ’ ll need to provide select calle r s with the P r io r ity Calling Code (p r eset to 1235) in o r der f or them to use this f eature. Y our P r io r ity Calling ...

  • AT&T 1305 - page 6

    V olume Cont r ol This system has eight volume le v els ; ea c h time you p r ess the app r op r iate button , the v olume increases or decreases one le v el . T o increase v olume , pr ess and r eleas e + . T o dec r ease volume , press and r elease - . I f y ou ’ r e adjusting the volume while the system is not pl a ying messa g es , y ou ’ l ...

  • AT&T 1305 - page 7

    5 If y ou wish , press and releas e f to fast f orwa r d while the memo is pl a ying — OR — P r ess and release to r e wind — OR — P r ess and release p to pause. T w o- W a y Reco r ding Y ou can record a phone con v ersation (the length of the recording depends on the length of y our microcassette) . Y ou can listen to the recording as y ...

  • AT&T 1305 - page 8

    When th e T ape is Full When the r ecording side of the tape is complete l y full , the system beeps , the MESS A GE light f lashes r apid l y , and the system tu r ns itself o f f because it cannot r ecord a caller ’ s messa g e . The system an s w e r s calls after 10 r ings and beeps, but does not pl a y an outgoing announcement or r ecord the ...

  • AT&T 1305 - page 9

    Remote Acces s Code Y ou can use ma n y f eatures of this an s wering system remote l y from a tou c h tone phone . Most f eatu r es can be accessed only after y ou enter a Remote Access Code . (The preset Remot e Access Code is p r inted on the label on the bottom of the an s wering system.) Connect with th e An s w ering System and Listen to Mess ...

  • AT&T 1305 - page 10

    Room Monitor Y ou can call the an s w e r ing system and listen to a n y activity in the r oom f or 15 seconds. 1 Connect with the answering system and listen to messages. 2 P r es s 3 3 . Y ou can listen after the beep. 3 After 15 seconds , the system e xits Room Monitor and beeps twice. T urn System Off 1 Connect with the answering system and lis ...

  • AT&T 1305 - page 11

    If this an s w ering system does not wo r k proper l y , t r y the f ollowing sug g estions. If y ou ’ r e still having di f f icult y , call 1 800 722–9125. If the MESSAGE light flashes rapidly: • The tape is full. • No out g oing announcement is r ecorded. If y ou h a v e difficulty hearing messages: The r ecording heads might be soiled a ...

  • AT&T 1305 - page 12

    IN C ASE OF DIFFICU L TY If the system does not r espond to r emote commands: • Make su r e y ou a r e calling from a tou c h tone telephone . If y ou hear cli c ks when y ou dial , the phone is not a tou c h tone phone. • There might be noise or inter f erence on the phone line . Press dial buttons f i r m l y . • Make sure y ou are ente r i ...

  • AT&T 1305 - page 13

    © 1998 Philips Consumer Communications L. P . All rights reserved. Printed in China. 848230090 Issue 1 A T&T F r om a Remot e T ouc h T one Phone T o connect with your answering system: 1 Dial y our telephone number from a tou c h tone phone. 2 When the system an s w e r s , press * * du r ing the announcement , then enter y our f our-digit Re ...

  • AT&T 1305 - page 14

    COMMAND PRESS Rewind 7 7 Fast Forwa r d 9 9 Save all messages Hang up Clear all messages 0 0 Pause/Stop 8 8 Change Remote Access Code 1 1 , enter new code Play/Stop Announcement 4 4 Reco r d/Stop Announcemen t 5 5 Room Monitor 3 3 T u r n system on System tu r ns on after 10 r ings T u r n system o f f 6 6 , then hang up COMMAND PRESS Rewind 7 7 Fa ...

Fabbricante AT&T Categoria Answering Machine

I documenti che otteniamo dal fabbricante del dispositivoAT&T 1305 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici AT&T
- manuali per l’uso 1305
- schede prodotto AT&T
- opuscoli
- o etichette energetiche AT&T 1305
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso AT&T 1305.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione AT&T 1305, manuali di manutenzione, brevi manuali o manuali utente AT&T 1305. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto AT&T 1305.

Manuali per l’uso simili

Manuale completo del dispositivo AT&T 1305, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare AT&T 1305 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti AT&T 1305.

Il manuale per l’uso completo AT&T, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale AT&T 1305 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice AT&T 1305, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per AT&T 1305 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo AT&T 1305 - che ci dovrebbe aiutare nei primi passi durante l'uso AT&T 1305
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del AT&T 1305
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio AT&T 1305 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su AT&T 1305?

Utilizza il modulo sottostante

Se non hai risolto il problema con AT&T 1305 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con AT&T 1305 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)