Apple 073-0723の取扱説明書

13ページ 0.28 mb
ダウンロード

ページに移動 of 13

Summary
  • Apple 073-0723 - page 1

    073-0723 Re v . B  Power Mac G4 Power Supply Replacement Instructions F ollow the instructions in this sheet carefully . F ailure to f ollo w these instructions could damage your equipment and v oid its w arranty . Note: Written and video instructions covering customer-installab le par ts are av ailab le at http://www .info .apple.com/installpar ...

  • Apple 073-0723 - page 2

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 2 6. T ouch the metal PCI access cov ers on the back of the computer . (Figure 1) Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static electricity build ...

  • Apple 073-0723 - page 3

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 3 Removing the Installed P o wer Supply 1. Remov e the two scre ws that secure the optical driv e carrier to the chassis. (Figure 2) Figure 2 2. Slide the back panel off the carrier . (Figure 3) Figure 3 ...

  • Apple 073-0723 - page 4

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 4 3. Slide the carrier back and rotate it so that you can reach the driv e cab les. 4. Disconnect the drive data and pow er cab les (P6 and P7) from the back of the optical drive(s) and remo ve the carrier from the computer . (Figure 4) Figure 4 5. Disconnect the ribbon cable from the logic ...

  • Apple 073-0723 - page 5

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 5 6. Using a small flat-blade scre wdriver , gently lift up the locking tab on the lo wer f an cable and disconnect the cab le from the logic board. (Figure 6) Figure 6 7. Slide the f an straight up to disconnect it from the optical drive shelf , and remove the f an from the computer . (Fig ...

  • Apple 073-0723 - page 6

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 6 8. Use a T -10 T orx driver to remo v e the power supply scre w . (Figure 8) Figure 8 9. Remov e the Phillips scre w from the side panel. (Figure 9) Figure 9 ...

  • Apple 073-0723 - page 7

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 7 10. Disconnect the power supply cab les from all driv es and from the logic board. 11. Note: For the Power Mac G4 (FW 800) model of the computer, press and hold the tab on the black, plastic connector cover as you pull up the power connector from the board. (Figure 10) Replacement Note: In ...

  • Apple 073-0723 - page 8

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 8 13. Slide the pow er supply f orw ard and remov e the power supply and cable harness from the computer . (Figure 12) Figure 12 ...

  • Apple 073-0723 - page 9

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 9 Installing the Replacement P ower Supply 1. Install the replacement pow er supply . Replacement Note: When rerouting the cable harness, make sure • connectors P4 and P5 are routed inside the front drive carrier • connectors P2 and P3 are routed so they can reach drives in the back driv ...

  • Apple 073-0723 - page 10

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 10 2. Reinstall the f an. Replacement Note: Align the fan with the three latches in the drive shelf and slide straight down until you feel the fan lock into place. (Figure 14) Figure 14 Replacement Note: Route the fan cable under the ribbon cable and over the narrower flex cable, as shown. ( ...

  • Apple 073-0723 - page 11

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 11 3. Reinstall the optical drive carrier . Replacement Note: Before sliding the carrier back onto the optical drive shelf, make sure the power cable bundle at the side panel are routed in the recessed channel. (Figure 16) Figure 16 Replacement Note: When sliding the carrier back onto the op ...

  • Apple 073-0723 - page 12

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 12 Replacement Note: Before sliding the rear panel back onto the carrier, make sure the top lip of the panel engages with the top edge of the drive carrier. W arning: Be careful not to pinch the power cable between the panel and the carrier. (Figure 18) Figure 18 ...

  • Apple 073-0723 - page 13

    Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 13 Closing the Computer 1. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2. Reconnect all cables and restart your computer . W arning: Never turn on your computer unless all of its internal and e xternal parts are in pla ...

メーカー Apple カテゴリー Power Supply

Apple 073-0723のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 073-0723の取扱説明書
- Appleの製品カード
- パンフレット
- またはApple 073-0723の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Apple 073-0723の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Apple 073-0723の取り付け説明書、サービスマニュアル、簡易説明書、またはApple 073-0723のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Apple 073-0723の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Apple 073-0723デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがApple 073-0723を使用するのを助ける技術的文書のことです。説明書は通常、全てのApple 073-0723ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Appleの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Apple 073-0723の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははApple 073-0723の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Apple 073-0723に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Apple 073-0723デバイスの基本機能を使うにあたってのヒント。 Apple 073-0723のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Apple 073-0723に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるApple 073-0723のメーカー/サービスへの連絡先に関する情報。

Apple 073-0723についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもApple 073-0723の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがApple 073-0723で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)