Bunn TB3 Seriesの取扱説明書

11ページ 0.73 mb
ダウンロード

ページに移動 of 11

Summary
  • Bunn TB3 Series - page 1

    TB3 Series Including: TB3; TB3-LP; TB3Q; TB3Q-LP ST ARTING WITH SERIAL NUMBER: TU000200000 INST ALLA TION & OPERA TING MANUAL BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 T o ensure you have the latest revision of the Operating Manual, or to view the Illustrated Part ...

  • Bunn TB3 Series - page 2

    Page 2 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specified below: 2 years parts and 1 year labor . 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compressors on refrigeration equipment: 5 years parts and 1 ...

  • Bunn TB3 Series - page 3

    Page 3 W ARNING ! Fill water tank before turning - on - thermostat or connecting appliance to power sour ce. Use only on a pr operly pr otected circuit capab le of the rated load. Electrically gr ound the chassis. Follow national/local electrical codes. Do not use near combustib les. F AILURE TO COMPL Y RISKS EQUIPMENT D AMAGE, FIRE, OR SHOCK HAZAR ...

  • Bunn TB3 Series - page 4

    Page 4 ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. 120V model brewers require 2-wire, grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. "A" model brewers require 2-wire, grounded service rated 230 volts ac, 10 amp, single phase, 50 Hz. "B& ...

  • Bunn TB3 Series - page 5

    Page 5 120V MODELS These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) from a ½˝ or larger supply line. A shut-off valve should be installed in the line before the brewer . Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345 k ...

  • Bunn TB3 Series - page 6

    Page 6 o o o o ADJUSTING BREW VOLUMES NOTE: Check that the brewer is connected to water supply , the tank is properly filled, and a funnel and server are in place, prior to setting or modifying batch sizes. 1. Modifying batch sizes. T o modify a batch volume, first check that the SET/LOCK switch is in the “SET” po- sition on the circuit board ...

  • Bunn TB3 Series - page 7

    Page 7 INITIAL SET -UP (TB3Q/TB3Q-LP ONL Y) CAUTION - The brewer must be disconnected from the power source throughout the Initial Set-Up, except when specified in the instructions. 1. Remove the top lid from the brewer . 2. Rotate the control thermostat knob fully counterclockwise to the "OFF" position and replace the top lid. 3. Insert ...

  • Bunn TB3 Series - page 8

    Page 8 INITIAL SET -UP (TB3/TB3-LP ONL Y) CAUTION - The brewer must be disconnected from the power sour ce throughout the initial set-up, except when specified in the instructions. 1. Remove the top lid from the brewer . 2. Rotate the control thermostat knob fully counterclockwise to the "OFF" position and replace the top lid. 3. Set the ...

  • Bunn TB3 Series - page 9

    Page 9 AUTO SWEETENER SET -UP CAUTION - The brewer must be disconnected from the power source throughout the Initial Set-Up, except when specified in the instructions. 1. Remove the top lid and both rear panels. 2. Make sure the brewer water supply is off. 3. Connect sweetener hose from the bag in a box delivery system to the rear fitting marked ...

  • Bunn TB3 Series - page 10

    Page 10 41465 082208 OPERA TING CONTROLS A. ON/OFF Switch ON - Placing the switch in the left position allows the start switch to activate a timed brew cycle for three gallons of tea. OFF - Placing the switch in the right position stops the brew cycle. Stopping a brew cycle after it has been started will not stop the flow of water into the funnel ...

  • Bunn TB3 Series - page 11

    Page 11 41465 082208 CLEANING CAUTION - CLEAN AND SANITIZE YOUR ICED TEA BREWER DAIL Y 1. Remove and thoroughly clean the entire brew funnel. The funnel tip and screen must be free from any tea particles or residue. Reassemble the funnel. 2. Place the ON/OFF switch in the "OFF" position. Remove and thoroughly rinse the sprayhead. The hole ...

メーカー Bunn カテゴリー Coffee Grinder

Bunn TB3 Seriesのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- TB3 Seriesの取扱説明書
- Bunnの製品カード
- パンフレット
- またはBunn TB3 Seriesの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Bunn TB3 Seriesの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Bunn TB3 Seriesの取り付け説明書、サービスマニュアル、簡易説明書、またはBunn TB3 Seriesのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Bunn TB3 Seriesの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Bunn TB3 Seriesデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがBunn TB3 Seriesを使用するのを助ける技術的文書のことです。説明書は通常、全てのBunn TB3 Seriesユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Bunnの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Bunn TB3 Seriesの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははBunn TB3 Seriesの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Bunn TB3 Seriesに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Bunn TB3 Seriesデバイスの基本機能を使うにあたってのヒント。 Bunn TB3 Seriesのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Bunn TB3 Seriesに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるBunn TB3 Seriesのメーカー/サービスへの連絡先に関する情報。

Bunn TB3 Seriesについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもBunn TB3 Seriesの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBunn TB3 Seriesで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)