Bunn 4の取扱説明書

16ページ 1.67 mb
ダウンロード

ページに移動 of 16

Summary
  • Bunn 4 - page 1

    IMIX-3 IMIX-4 IMIX-5 INST ALLA TION & OPERA TING MANUAL BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 37510.0000D 01/06 ©2004 Bunn-O-Matic Corporation www .bunnomatic.com ...

  • Bunn 4 - page 2

    2 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specifi ed below: 2 years parts and 1 year labor . 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compressors on refrigeration equipment: 5 years parts and 1 year ...

  • Bunn 4 - page 3

    3 W ARNING ! Fill water tank before turning - on - thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. F AILURE TO COMPL Y RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD READ THE E ...

  • Bunn 4 - page 4

    4 INITIAL SET -UP 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly , drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopper access door; push down gently and tighten scr ...

  • Bunn 4 - page 5

    5 INITIAL fi ll & heat 1. T urn on the water supply and connect the dispenser to the power source. 2. Water will automatically fl ow into the tank to the proper level and then shut-off. This will take less than ten minutes. 3. When the tank is full of water , open the front door and place the ON/OFF/NIGHT switch in the “ON” (up- per) posi ...

  • Bunn 4 - page 6

    6 HOPPER DISPENSE RA TE OF PRODUCT The hopper dispense rates are preset at the factory . With 22 tooth gear and auger wire, the preset dispense rate is approximately 3 to 5 grams per second. With 30 tooth gear and auger wire, the preset dispense rate is approximately 5 to 7 grams per second. The hopper dispense rates can be individually programmed ...

  • Bunn 4 - page 7

    7 Adjust tank temperature (190° F maximum) Adjust minimum tank ready temper - ature for lockout (185° maximum) Adjust hopper motor speed for station selected T ANK TEMP XXX° (-) EXIT (+) READY TEMP XXX° (-) EXIT (+) DRINK STRENGTH (-) XX (+) XX° CAL XX° (-) T ank T emp (+) 235 REFILL 155 (-) EXIT (+) CAL WA TER ? PRESS DISPENSE Calibrate temp ...

  • Bunn 4 - page 8

    8 A. Enter program mode and advance to next menu B. Incriment display value positive C. Exit program mode D. Incriment display value negative E. Return to previous menu and interrupt dispense PORTION CONTROL MODELS D igital B everage C ontr ol D igital B everage C ontr ol ST OP PROGRAM HOME SCREEN The screen above will be shown when the dispenser i ...

  • Bunn 4 - page 9

    9 PROGRAMMING CUP SIZES - Portion Control Models The cup size can be programmed in portion control models by “EXAMPLE” or “TIME”. Programming by EXAMPLE is manually pressing desired dispense button, then releasing when the desired cup size is attained. The time required to fi ll the cup will be stored in the controller memory when moving t ...

  • Bunn 4 - page 10

    10 DISABLE MESSAGES ? NO EXIT YES Press and release right switch (advance to next menu), “T ANK TEMP XXX°” appears on screen. PROGRAMMING THE DISPENSER (cont.) T ANK TEMP XXX° READY TEMP XXX° (-) EXIT (+) STRENGTH ADJ. ? (-) EXIT (+) EXIT YES ENTER P ASSWORD (-) XXXX (+) CALIBRA TION ? EXIT YES LOCKS/DISABLES ? EXIT YES AUDIBLE ALARM ? NO EX ...

  • Bunn 4 - page 11

    11 XX° CAL XX° (-) T ank T emp (+) PROGRAMMING THE DISPENSER (cont.) DRINK STRENGTH 1 (-) XX (+) PRESS DISPENSE TO CHECK T ASTE T ASTE 1 OK ? NO YES SET FLA VOR 1 BY T ASTE RECIPE ENTER RECIPE # #.# gm/fl uid oz CHANGING V ALUES WILL EFFECT RPM ARE YOU SURE ? NO EXIT YES (B) Adjust hopper motor speed for station for station selected SELECT UNITS ...

  • Bunn 4 - page 12

    12 PROGRAMMING THE DISPENSER (cont.) LOW POWDER LOCK ? NO EXIT YES DISPENSE LOCKOUT NO EXIT YES RINSE ALARM ? NO EXIT YES HEAD 1 DISABLE ? NO EXIT YES SET P ASSWORD ? (-) XXXX (+) Returns to (G) (page 10) TEST SWITCHES ? Use Switch T o T est TEST HEA TER ? EXIT YES TEST REFILL ? EXIT YES TEST HOT WA TER ? EXIT YES TEST AUGERS ? DISPENSE TO TEST TES ...

  • Bunn 4 - page 13

    13 $Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 6/, 43!#7)2% 3).',%0(!3%(: 3#(%-! 4)#7)2).'$)! '2!- I-) 8  '2. , ",+ ...

  • Bunn 4 - page 14

    14 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 6/, 43!#7)2% 3).',%0(!3%(: 3#(%-! 4)#7)2).'$)! '2!- I-) 8 I-) 8  &a ...

  • Bunn 4 - page 15

    15 37510 010206 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 3).',%0(!3%(: SCHEMA TIC WIRING DIAGRAM IMIX-3A '2. , ",+ ",+ ",+ ",+ ",+ ,)-)4 4(%2-/34 ...

  • Bunn 4 - page 16

    16 37510 010206 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 3).',%0(!3%(: SCHEMA TIC WIRING DIAGRAM IMIXA-4/IMIXA-5 '2. , ",+ ",+ ",+ ",+ ",+ " ...

メーカー Bunn カテゴリー Coffeemaker

Bunn 4のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 4の取扱説明書
- Bunnの製品カード
- パンフレット
- またはBunn 4の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Bunn 4の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Bunn 4の取り付け説明書、サービスマニュアル、簡易説明書、またはBunn 4のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Bunn 4の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Bunn 4デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがBunn 4を使用するのを助ける技術的文書のことです。説明書は通常、全てのBunn 4ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Bunnの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Bunn 4の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははBunn 4の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Bunn 4に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Bunn 4デバイスの基本機能を使うにあたってのヒント。 Bunn 4のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Bunn 4に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるBunn 4のメーカー/サービスへの連絡先に関する情報。

Bunn 4についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもBunn 4の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBunn 4で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)