Curtis 1620Sの取扱説明書

16ページ 0.33 mb
ダウンロード

ページに移動 of 16

Summary
  • Curtis 1620S - page 1

    manu al MODEL 1620 SWITCH MODE BA TTERY CHARGER Before charging, read instructions carefully! ® Applicable to 230VAC units only ...

  • Curtis 1620S - page 2

    IMPORT ANT SAFETY INSTRUCTIONS SA VE THESE INSTRUCTIONS Read the Operating Instructions carefully before using the Model 1620 charger . 1. W ARNING – Failure to install and operate the charger in accordance with these instructions may result in damage to the charger or injury to the operator . 2. W ARNING – Never pla ce the charge r dir ect ly ...

  • Curtis 1620S - page 3

    CONTENTS 1. MODEL ENCODEMENT ............................. page 1 2. TECHNICAL SPECIFICA TIONS .................. page 1 3. INST ALLA TION ............................................. page 7 4. OPERA TION ................................................... page 8 5. TROUBLESHOOTING ................................. page 9 6. MAINTENANCE .......... ...

  • Curtis 1620S - page 4

    Curtis 1620 Manual page 1 MODEL ENCODEMENT TECHNICAL SPECIFICA TIONS 2.1 Electrical 2.2 Mechanical Case: Aluminum alloy , black finish End caps: Polycarbonate, black Dimensions (mm): 292L x 165.0W x 73.0H W eight: 2.8kg 2.3 Connections AC Power Inlet: IEC 320/C14 Programming Port: Molex 39-01-2040 For use with Curtis Instruments’ Model 1311 handh ...

  • Curtis 1620S - page 5

    Wiring diagram 1. 2.4 Environmental Operating temperature: 0°C to +50°C Storage temperature: -40°C to +85°C Humidity: 95% non-condensing at 38°C Shock: SAEJ1378, 55g pulse at 9-13ms Vibration: 5g rms, 5-500 Hz, 2 hrs. per axis Protection: IP-54, including fan 2.5 Compliance 2.6 Battery T ypes This charger is suitable for use with all 24V , 12 ...

  • Curtis 1620S - page 6

    Curtis 1620 Manual page 1 2.7.1 – End of Charge Mode Figure 1. Charge profile for End of Charge Mode Figure 1 defines the charge profile for the End of Charge Mode. As long as the battery voltage (V) is above Under voltage Lockout Level (V uvlo), charging will start after shor t delay of about 6 seconds. For batter y voltage between V uvlo and Vl ...

  • Curtis 1620S - page 7

    2.7.2- Equalize Mode after End of Charge Mode Figure 2. Charge profile for Equalize Mode Figure 2 defines the charge profile for the Equalize Mode. After going through bulk charge and Constant V oltage modes, the charger will reduce its output cur- rent to T op-Off Current (Ito) until one of the two possible outcomes occurs: (1) Batter y voltage ri ...

  • Curtis 1620S - page 8

    Curtis 1620 Manual page 1 2.7.3 - Float Mode Figure 3. Charge profile for Float Mode Figure 3 defines the charge profile for the Float Mode. In this mode of operation, batteries are maintained at full charge. In addition to maintaining full charge, the charger can support a load current – as long as the combined load current and battery charging ...

  • Curtis 1620S - page 9

    2.8 Indication Lights The charger features built in diagnostics. Refer to the table below to interpret the flashing of the green and yellow indicator lights. Curtis 1620 Manual page 6 Flash Pattern Mode Charge Status Y ellow on, Green on Standby Indicator 1 Charge done, ready to use. Y ellow on, Green blinks 1 Charging Charging nor mally . Y ellow ...

  • Curtis 1620S - page 10

    Curtis 1620 Manual page 1 Curtis 1620 Manual page 7 INST ALLA TION 3.1 Unit should be securely mounted to a flat sur face. 3.2 The power cord to the IEC 320/C14 connector should be of the appropriate gauge to car ry a 15A current, for the cable’ s length, to meet the requirements of applicable electrical codes. The power cord must meet IEC requir ...

  • Curtis 1620S - page 11

    OPERA TION 4.1 Charging the batter y 4.1.1 If using the motor speed controller inhibit, and a Curtis motor controller is present, connect the Motor Controller Inhibit connector to the appr opriate connector on the motor speed controller . 4.1.2 Connect the (–) terminal of the charger to the (–) terminal of the batter y . 4.1.3 Connect the (+) t ...

  • Curtis 1620S - page 12

    Curtis 1620 Manual page 1 5 TROUBLESHOOTING The following checklist should help you to troubleshoot any problems with the charger . Make sure to observe all safety instr uctions provided on the unit and in this manual. 1 – 0.5s on, 0.5s off 2 – 0.5s on 3 – Resetting the charger: Remove and restor e power to the charger . Charger may be damage ...

  • Curtis 1620S - page 13

    Curtis 1620 Manual page 10 6 MAINTENANCE Excess dir t or grime may be removed from the unit by wiping it with a cloth dampened with water . Although Cur tis chargers are equipped with a fan designed to last the life of the charger , exposure to harsh environments – such as dusty condition, grease, chemi - cals, etc. – may impair the effectivene ...

  • Curtis 1620S - page 14

    Curtis 1620 Manual page 1 Curtis 1620 Manual page 11 Programming mode Description Programming Limits Default Value Increment Accuracy* Definition BASIC MODE 2 Battery Type 1 or 21 1 1 -FLA: Float voltage is set to 26.8V, Constant voltage set to 29V. 2 -SLA: Float voltage set to 27.6V, Constant voltage to 29.4V End of Charge 1, 2, or 31 1 1 -OFF : C ...

  • Curtis 1620S - page 15

    Curtis 1620 Manual page 12 Programming mode Description Programming Limits Default Value Increment Accuracy* Definition BASIC MODE 2 Battery Type 1 or 21 1 1 -FLA: Float voltage is set to 26.8V, Constant voltage set to 29V. 2 -SLA: Float voltage set to 27.6V, Constant voltage to 29.4V End of Charge 1, 2, or 31 1 1 -OFF : Charger goes into standby. ...

  • Curtis 1620S - page 16

    CURTIS INSTR UMENTS, INC. 200 Kisco Avenue, Mt. Kisco, NY 10549 • T el: (914) 666-2971 • FAX (914) 666-2188 www .curtisinst.com Specifications subject to change without notice © 2 00 5 C U RT I S I NS TR UM EN T S, IN C. 53033 REV E 12/07 is a registered trademark of Curtis Instruments, Inc. ...

メーカー Curtis カテゴリー Battery Charger

Curtis 1620Sのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 1620Sの取扱説明書
- Curtisの製品カード
- パンフレット
- またはCurtis 1620Sの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Curtis 1620Sの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Curtis 1620Sの取り付け説明書、サービスマニュアル、簡易説明書、またはCurtis 1620Sのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Curtis 1620Sの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Curtis 1620Sデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCurtis 1620Sを使用するのを助ける技術的文書のことです。説明書は通常、全てのCurtis 1620Sユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Curtisの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Curtis 1620Sの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCurtis 1620Sの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Curtis 1620Sに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Curtis 1620Sデバイスの基本機能を使うにあたってのヒント。 Curtis 1620Sのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Curtis 1620Sに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCurtis 1620Sのメーカー/サービスへの連絡先に関する情報。

Curtis 1620Sについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCurtis 1620Sの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCurtis 1620Sで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)