Bunn ES.2Cの取扱説明書

17ページ 0.46 mb
ダウンロード

ページに移動 of 17

Summary
  • Bunn ES.2C - page 1

    OPERA TING & SER VICE MANU AL BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 10837.0000C 6/96 ©1994 Bunn-O-Matic Corporation B UNN E spr ess ® ES•2C ES•2C ™ Espresso Brewer O F F O N 0 0 , 5 0,5 1 1 , 5 1,5 2 2 , 5 2,5 0 4 8 1 2 12 1 6 16 C L 2 CL 2 b a r bar C ...

  • Bunn ES.2C - page 2

    BUNN E spress ® ES•2C ™ 2 User notices ......................................................................................................................... 3 Site Requirements .............................................................................................................. .4 Installation ..................................... ...

  • Bunn ES.2C - page 3

    B UNN Espr ess ® ES•2C ™ 3 The notices on this brewer should be kept in good condition. Replace unreadable or damaged labels. 00656.0000 00831.0000 24246.0000 24247.0000 USER NOTICES CAUTION HOT Liquid-Steam-Surfaces ...

  • Bunn ES.2C - page 4

    BUNN E spress ® ES•2C ™ 4 SITE REQUIREMENTS PHYSICAL The brewer is for indoor use only on a sturdy counter. It is 26 1 ⁄ 2 ” (67 cm) wide,16” (40.5 cm) tall, and 19 1 ⁄ 2 ” (49 cm) deep. The brewer weighs approximately 142 pounds (64.5 kg) when the water tank is filled. PLUMBING The brewer must be connected to a cold water source wit ...

  • Bunn ES.2C - page 5

    B UNN Espr ess ® ES•2C ™ 5 PLUMBING Install the brewer as indicated below INST ALLA TION WATER STRAINER ASSY. INLET HOSE BUNN 9 0 p s ig m a x o p e r a tin g p r e s s u r e B O M S t r a in e r F L O W From Water T reatment 24682.0000 Adaptor 24684.0000 Sealing Washer 23820.0000 Strainer Assy . 24684.0000 Sealing Washer 24683.0000 Adapter T ...

  • Bunn ES.2C - page 6

    BUNN E spress ® ES•2C ™ 6 OPERA TING CONTROLS 1 .............. Tank/Boiler Manual Fill Button 2 .............. Pressure Gage 3 .............. Hot Water Wand 4 .............. Tank Water Level Gage 5 .............. Hot Water Wand Control Knob 6 .............. Espresso Group Head 7 .............. Cup Warmer Tray 8 .............. Steam Wand Contro ...

  • Bunn ES.2C - page 7

    B UNN Espr ess ® ES•2C ™ 7 ADJUSTMENTS INFUSION The brewer leaves the factory set to yield these approximate amounts of water: One Half-Cup ................... 50 cc. Two Half-Cups ................. 100 cc. One Full-Cup .................... 100 cc. Two Full-Cups .................. 200 cc. To change the factory set amounts: 1. Place the program ...

  • Bunn ES.2C - page 8

    BUNN E spress ® ES•2C ™ 8 OPERA TION ESPRESSO BREWING 1. Determine the batch size to be made. 2. Place the desired amount of espresso grind coffee in the appropriate filter holder (1 or 2 cups), shake it gently to level the bed, and using a tamper, compress the coffee. 3. Clean all coffee particles from the edge of the filter holder. 3. Raise ...

  • Bunn ES.2C - page 9

    B UNN Espr ess ® ES•2C ™ 9 BREWING TIPS GENERAL Good espresso is identified by its taste, aroma, and the manner in which it is served. All of these elements can be improved-upon to serve your customers a better product. BEAN SELECTION The selection of a blend of coffee is a matter of personal choice. A blend with a high proportion of Central a ...

  • Bunn ES.2C - page 10

    BUNN E spress ® ES•2C ™ 10 CLEANING FIL TER HOLDER CLEANING Bunn-O-Matic recommends daily cleaning for your espresso brewer using the following steps: 1. Place the one-cup basket into the filter holder. 2. Put a teaspoon of any granular espresso cleaner or automatic dish washing detergent (such as Cascade ® ) into the basket. 3. Lock the filt ...

  • Bunn ES.2C - page 11

    B UNN Espr ess ® ES•2C ™ 11 ALARMS ONE BREW INDICA TOR FLASHING (EITHER SIDE) This alarm flashes when either flow meter has not sent impulses to the electronic control unit for more than five seconds. All functions will stop and the lamp will begin to flash if brewing a programmed amount. Check the following: A. Coffee ground too fine. B. Obst ...

  • Bunn ES.2C - page 12

    BUNN E spress ® ES•2C ™ 12 TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department at (800) 637-8606. • Inspection, testing, and repair of elect ...

  • Bunn ES.2C - page 13

    B UNN Espr ess ® ES•2C ™ 13 TROUBLESHOOTING PROBLEM PROBABLE CAUSE REMEDY Will not brew when any of the batch buttons is pressed. (Continuous brew works as well as automatic refill.) Water is not hot or long re- covery time. Flowmeter Solenoid valve Pump Solenoid valve Limit thermostat(s) Tank heater Check connections between the flowmeter and ...

  • Bunn ES.2C - page 14

    BUNN E spress ® ES•2C ™ 14 TROUBLESHOOTING PROBLEM PROBABLE CAUSE REMEDY Short brew time(less than approximately 20 seconds per half-cup). Weak coffee. No crema. Brewer does not reach oper- ating pressure or does so very slowly. Coffee ground too coarse Coffee not fresh Too little coffee used Coffee not tamped into filter basket Check coffee g ...

  • Bunn ES.2C - page 15

    B UNN Espr ess ® ES•2C ™ 15 TROUBLESHOOTING PROBLEM PROBABLE CAUSE REMEDY problem problem problem ...

  • Bunn ES.2C - page 16

    BUNN E spress ® ES•2C ™ 16 PLUMBING DIAGRAM TO STEAM WAND TO HEATER CONTROL Hot Water (surrounding tank heater) PRESSURE SWITCH TANK HEATER LEGEND Cold Water Brew Water Steam Components and Item Numbers FILTER HOLDER COLD WATER FILL LINE FLOWMETER FROM WATER SUPPLY VALVE COLD WATER PUMP W/ADJUSTABLE PRESSURE RELIEF VALVE SET TO ~150 PSI HEAT E ...

  • Bunn ES.2C - page 17

    B UNN Espr ess ® ES•2C ™ 17 WIRING DIAGRAM J6-1 ES•2C 10839.0000A 10/94 © 1994 BUNN-O-MATIC CORPORATION GREEN 220 VOLTS AC 2 WIRE SINGLE PHASE 60 HZ L1 L2 ELECTRONIC CONTROLLER SOL GROUP SOL REFILL J8-1 PROGRAM SWITCH J9-1 J2-1 LIMIT THERMOSTAT TANK HEATER (RIBBON CABLE) J1 J3-1 J4-1 J5-1 J7-1 FLOW METER SOL GROUP FLOW METER CONTROL & I ...

メーカー Bunn カテゴリー Espresso Maker

Bunn ES.2Cのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- ES.2Cの取扱説明書
- Bunnの製品カード
- パンフレット
- またはBunn ES.2Cの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Bunn ES.2Cの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Bunn ES.2Cの取り付け説明書、サービスマニュアル、簡易説明書、またはBunn ES.2Cのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Bunn ES.2Cの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Bunn ES.2Cデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがBunn ES.2Cを使用するのを助ける技術的文書のことです。説明書は通常、全てのBunn ES.2Cユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Bunnの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Bunn ES.2Cの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははBunn ES.2Cの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Bunn ES.2Cに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Bunn ES.2Cデバイスの基本機能を使うにあたってのヒント。 Bunn ES.2Cのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Bunn ES.2Cに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるBunn ES.2Cのメーカー/サービスへの連絡先に関する情報。

Bunn ES.2Cについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもBunn ES.2Cの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBunn ES.2Cで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)