Axor 10101XX1の取扱説明書

16ページ 2.58 mb
ダウンロード

ページに移動 of 16

Summary
  • Axor 10101XX1 - page 1

    Starck 10101XX1 10140XX1 Starck 10106XX1 10145XX1 Starck X 10170001 10175001 10180001 10185001 Installation Instructions / W arranty ...

  • Axor 10101XX1 - page 2

    2 Starck 10101XX1/10106XX1 Starck 10140XX1/10145XX1 Starck X 10170001/10175001 Starck X 10180001/10185001 ...

  • Axor 10101XX1 - page 3

    3 Starck 10101XX1/10106XX1/10140XX1/10145XX1 Starck X 10170001/10175001/10180001/10185001 T echnical Information Recommended water pressure 15 - 58 psi Max. water pressure 58 psi Max. hot water temp. 176 o F* Recommended hot water temp. 120 o F - 140 o F* Flow rate 1.3 gpm Batter y CR-P2 / 6 V Lithium Automatic shutoff after 1 minute *Please know a ...

  • Axor 10101XX1 - page 4

    4 Installation notes • Flush the hot and cold supplies thoroughly before installing the faucet. Damage to the faucet caused by debris is not covered under the warranty . • The hot and cold supplies should be of equal pressure. • The faucet should not be used with a con- tinuous flow water heater . • Do not install the faucet on a sink with ...

  • Axor 10101XX1 - page 5

    5 Installation Position the faucet on the sink or countertop (1). Install and tighten the mounting nut (2). T ighten the tensioning screws (3). Connect the 3/8” adapters to the stops (4). Connect the hoses to the adapters (5). T ighten the hoses with two wrenches, as shown, to prevent the hoses from twisting. ...

  • Axor 10101XX1 - page 6

    6 Connect the faucet power cable to the batter y pack or AC power pack (1). Plug the AC power pack in. T urn the hot and cold supplies on (2). Remove the protective film from the sensor window (3). W ait 30 seconds before attempting to use the faucet (4). Position your hand in front of the sensor to turn the water on. Due to air in the faucet, the ...

  • Axor 10101XX1 - page 7

    7 Remove the faucet body (1). T urn the temperature screw for ward to make the water cooler , backward to make it warmer (2). Dr y any drops of water from the faucet or mounting surface. Replace the faucet body (1). Replace the screw (2). T urn the water supplies on (3). Reconnect the power cable (4). W ait 30 seconds (1). Place your hand in front ...

  • Axor 10101XX1 - page 8

    8 Battery Replacement -- models 10101XX1/ 10106XX1/10170001/10175001 only If the LED in the sensor window flashes, the batter y is low , but the faucet can still be used. If the LED lights continuously , the batter y must be changed before the faucet can be used. Remove the four screws and the batter y pack cover . Remove the old batter y (1). Inst ...

  • Axor 10101XX1 - page 9

    9 Clean the aerator and filters -- all models If the water flow is reduced over time, clean the aerator (a) and the filters (b). T urn the water supplies off (1). Disconnect the power cable (2). Starck 10101/10106/10140/10145 -- unscrew and remove the aerator (a). Starck X 10170/10175/10180/10185 -- remove the spray former (a), using a 2 mm Allen w ...

  • Axor 10101XX1 - page 10

    10 T urn the water on (1). Reconnect the power cable (2). W ait 30 seconds (1). Place a hand in front of the sensor to turn the faucet on (2). ...

  • Axor 10101XX1 - page 11

    11 Cleaning The faucet may be turned off temporarily so that the sink may be cleaned. Cover the sensor window with a hand for approximately 10 seconds. The faucet will turn off for approximately 60 seconds, so that the sink may be cleaned. The LED in the sensor window will flash. When the LED no longer flashes, the faucet may be used normally . ...

  • Axor 10101XX1 - page 12

    12 Change the Spray Former -- Starck X 10170 / 10175 / 10180 / 10185 only The waterfall spray for mer is installed on the faucet at the fac- tor y . A round monospray spray former is included with the faucet. The spray former may be changed easily , if desired. Use a 2 mm Allen wrench to remove the spray former screws. Remove the old spray former . ...

  • Axor 10101XX1 - page 13

    13 Reduce the Sensor Range The sensor is set for maximum range at the factor y . If the faucet is used on a ver y small or highly reflective lavator y , the sensor range may be reduced by ap- proximately 2”. Disconnect the power cable for approximately 10 seconds (1). Reconnect the power cable (2). The LED will blink once to indicate that it is i ...

  • Axor 10101XX1 - page 14

    14 Replacement Parts 1 batter y , lithium CR-P2 / 6V 2 connection hose 98809000 3 spray former 98867000 4 aerator , Starck 94005XX0 5 fixing set 13961000 6 electronics, Starck 98799000 electronics, Starck X 98849000 7 AC adapter 8 batter y box 98801000 9 check valve 96456000 10 aerator , Starck X 98610000 XX = color 00 = chrome 80 = Steel Maintenan ...

  • Axor 10101XX1 - page 15

    15 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY ...

  • Axor 10101XX1 - page 16

    Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770 360-9880 • Fax 770 360 9887 www .hansgrohe-USA.com US - Installation Instructions • Part No. 90423021 • Revised 09/2007 including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year , with respect to Hansgrohe and Commercial pr ...

メーカー Axor カテゴリー Indoor Furnishings

Axor 10101XX1のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 10101XX1の取扱説明書
- Axorの製品カード
- パンフレット
- またはAxor 10101XX1の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Axor 10101XX1の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Axor 10101XX1の取り付け説明書、サービスマニュアル、簡易説明書、またはAxor 10101XX1のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Axor 10101XX1の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Axor 10101XX1デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAxor 10101XX1を使用するのを助ける技術的文書のことです。説明書は通常、全てのAxor 10101XX1ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Axorの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Axor 10101XX1の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAxor 10101XX1の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Axor 10101XX1に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Axor 10101XX1デバイスの基本機能を使うにあたってのヒント。 Axor 10101XX1のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Axor 10101XX1に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAxor 10101XX1のメーカー/サービスへの連絡先に関する情報。

Axor 10101XX1についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAxor 10101XX1の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAxor 10101XX1で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)