Manual Raypak RFSDV34RFNAU

27 pages 0.44 mb
Download

Go to site of 27

Summary
  • Raypak RFSDV34RFNAU - page 1

    RAYPAK VERMONT RFSDV34 FREESTANDING GAS LOG FIRE Installation and Operating Instructions For Models RFSDV34RFNAU (Natural Gas) & RFSDV34RFPAU (Propane) Page 1 of 27 ...

  • Raypak RFSDV34RFNAU - page 2

    CONTENTS Part 1: For Your Safety Part 2: Installation Instructions • Start Up Recommendations • Locating The Fireplace • Clearance to Combustibles • Fireplace Dimensions • Gas Specifications • Gas Inlet and Manifold Pressures • Preparation • Gas Line Installation Part 3: General Venting Information • Termination Clearances • Gen ...

  • Raypak RFSDV34RFNAU - page 3

    Part 7: Conversion • Gas Type Conversion Instruction Part 8: Wiring Diagram • Wiring Diagram Part 9: Warranty Page 3 of 27 ...

  • Raypak RFSDV34RFNAU - page 4

    Part 1: For Your Safety For your safety do not operate this appliance before readi ng this instruction book. Warning: Improper installation, adjustm ent, alt eration, service or maintenance can cause injury or pr operty damage. For assistance or additional information cons ult with Raypak Australia, your Raypak distributor, qualified in staller or ...

  • Raypak RFSDV34RFNAU - page 5

    Part 2: Installation Instructions This gas fireplace must be installed by a qualified installer in accordance with AS5601 and all relevant local building codes. For safe installation and operation please note the following: 1. This fireplace gives off high temperatures and should be located out of high traffic areas and away fr om furniture and dra ...

  • Raypak RFSDV34RFNAU - page 6

    IMPORTANT: PLEASE READ THE FOLLOWING CAREFULLY Remove any plastic from trim parts before turning the appliance on. It is normal for fireplaces fabricated of steel to give o ff some expansion and/or contraction noises during t he start up or cool down cycle. It is not unusual for the Raypak Verm ont gas fireplace to produce some odour the first time ...

  • Raypak RFSDV34RFNAU - page 7

    DIMENSION RFSDV34 A 667mm B 800mm C 492mm D 762mm E 254mm F 394mm G 114mm H 667mm I 333mm J 495mm K 162mm Page 7 of 27 ...

  • Raypak RFSDV34RFNAU - page 8

    Gas Specifications Model Gas Type Gas Control Min. MJ/h Input Max. MJ/h Input RFSDV34RFN Natural Radio Freq. 22 32 RFSDV34RFP Propane Radio Freq. 24 32 Gas Inlet and Burner Pressures Natural Gas ULPG Inlet Minimum 1.1 kPa 2.75 kPa Inlet Maximum 3.50 kPa 3.50 kPa Burner Pressure 0.87 kPa 2.50 kPa Preparation Warning: The use of wall paper adjacent t ...

  • Raypak RFSDV34RFNAU - page 9

    Note: When making the gas connection to the appliance inlet fitting, hold the 10mm 3/8” BSP fitting with a s panner when tightening the gas inlet pipe compression nut. For Propane installations an approved gas regulator must be fitted in accordance with AS5601. Ensure copper tube meets the re quirements of Australian Standard AS1432 Type B. Note: ...

  • Raypak RFSDV34RFNAU - page 10

    Part 3: General Flue Installation Underside of gas cowl must be at least 500mm above highest point of the roof. This appliance is approved for an installation with a maximum flue height of 12m and a minimum flue height of 3m. Suspend a plumbline from the ceiling to the centre of the flue spigot. Mark the centre of the flue spigot on the ceiling. Pr ...

  • Raypak RFSDV34RFNAU - page 11

    Part 4: Operating Instructions NOTE: Carbon deposits maybe present on the glass and logs. This is normal and must be cleaned when the heater is serviced or the glass door is cleaned. Please refer to the Gener al Glass Information section on page 15. General Glass Information Warning: Only glass approved for use by Raypak Australia may be used for r ...

  • Raypak RFSDV34RFNAU - page 12

    glass and causes lint, dust and other air-borne particles to cling. Initial paint curing may also deposit a slight film on the glass. Clean the glass two or three ti mes with a non-ammonia based household cleaner and warm water. (We recomm end gas fireplace glass cleaner.) After the initial cleaning, clean the glass two or three times during each o ...

  • Raypak RFSDV34RFNAU - page 13

    Flame and Temperature Adjustment The appliance is fitted with the Honeywe ll Radio Frequency control valve and all adjustments are performed with t he use of a remote controller. See instructions packaged with the Remote Controller or refer to page 16 in this manual for operating instructions. Flame Appearance Periodically perform a visual check of ...

  • Raypak RFSDV34RFNAU - page 14

    • DO NOT use any phone in the building. • IMMEDIATELY call you gas supplier from a neighbour’s phone or a mobile phone outside the build ing. Follow the gas suppliers instructions. • IF YOU CANNOT CONTACT YOU GAS SUPPLIER CALL THE FIRE BRIGADE. D. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will ...

  • Raypak RFSDV34RFNAU - page 15

    13. For the RN/RP models turn the remote control ON/OFF switch to the ON position or set the thermostat to the desired setting. 14. Turn on electrical supply. To Turn Off the Heater 1. Turn the remote control ON/OFF switch to OFF or set the thermostat to the lowest setting. 2. Turn off power supply to the appliance if a service is to be performed. ...

  • Raypak RFSDV34RFNAU - page 16

    remote control within 30 seconds. The LED will blink indicating the remote control will now work with the receiver valve. If the switch continues in the REMOTE position, the remote control will now control the main valve, flame modul ation level and fan control. 7. If the manual switch is in the LOCA L position, the valve will be at the highest fix ...

  • Raypak RFSDV34RFNAU - page 17

    Fig. 7 Transmitter diagram Delay Timer Mode The shut off delay timer maximum setting is 2 hours and minimum setting is zero minutes. To change the timer le vel, press the timer key, then the arrow key. Each key press changes the setting by 10 minutes. Auto Mode In the AUTO mode, the r oom temperature, set te mperature, flame and fan levels will be ...

  • Raypak RFSDV34RFNAU - page 18

    To Change Batteries 1. Remove cover on backside of the remote control. Install 3 AAA as shown on the cover and then re-attach the cover. 2. Once OPERATION steps 1 to 3 are completed, the receiver/valve and remote control are ready. Press any button on the remote control to initiate the recognition process between the receiver/valve and the remote c ...

  • Raypak RFSDV34RFNAU - page 19

    If an error code 8 is observed while performing the testing, complete the following: 1. Confirm that the gas valve is not in the REMOTE mode. • If the valve is producing error code 8 while in the REMOTE mode, the valve is defective and should be replaced. • If the valve is producing error co de 8 while in the LOCAL mode, go to the next step. 2. ...

  • Raypak RFSDV34RFNAU - page 20

    Troubleshooting the Gas Control System Comfort Valve System Control Seque nce of Operation with Remote Control Local Path On Path Auto Path Move switch from manual to remote. Press any key on remote control If the manual switch is set to remote, press the mode button to display ON. Does the remote control the main burner and fan? Does remote contro ...

  • Raypak RFSDV34RFNAU - page 21

    Part 6 Replacement Parts List Insert replacement parts list and parts drawing here. Part 7 Conversion Instructions 1. Disconnect power to the unit and shut off the gas supply. 2. Remove the window frame a ssembly. (see the Window Frame Assembly section) 3. Carefully remove the logs . (ensure they are not hot) 4. Remove pilot asse mbly from bracket. ...

  • Raypak RFSDV34RFNAU - page 22

    Part 8 Wiring Diagram A N 240V A C Te r m i n a l B l o c k Tr a n s f o r m er 240V AC - 110V AC 2A (50V A) Fuse - 3 Amp 240V A C 50 Hz Main Heater Supply Speed C on trol High Limit Fan RFSDV34 GAS L OG F I RE W I RI NG DI AGRAM Page 22 of 27 ...

  • Raypak RFSDV34RFNAU - page 23

    Page 23 of 27 ...

  • Raypak RFSDV34RFNAU - page 24

    Page 24 of 27 ...

  • Raypak RFSDV34RFNAU - page 25

    Page 25 of 27 ...

  • Raypak RFSDV34RFNAU - page 26

    Part 9 Warranty RAYPAK RFSDV34RFN & RFSDV34RFP FREESTANDING GAS LOG FIRE WARANTY - AUSTRALIA ONLY – Rheem Australia * w ill: a) Repair o r, if necessary replace any Ra ypak RFSDV34 Freestan ding Gas Log Fire, or b) Replace any comp onent (or, if necessary, arrange the installation of a Raypak Gas Log Fire, which falls within the Warranty Peri ...

  • Raypak RFSDV34RFNAU - page 27

    RAYPAK MAJESTIC RFSDV34RFNAU AND RFSD34RFPAU WARRANTY - AUSTRALIA ONLY – WARRANTY CON DITIONS 1. This warranty is appli cable only to the RFSDV34RFN and the RFSDV34RFP gas log fires manufactured from August 2005 2. The gas log fire mu st be installed in accordance with the Raypa k installation instructions, supplied with the applianc e and in a c ...

Manufacturer Raypak Category Indoor Fireplace

Documents that we receive from a manufacturer of a Raypak RFSDV34RFNAU can be divided into several groups. They are, among others:
- Raypak technical drawings
- RFSDV34RFNAU manuals
- Raypak product data sheets
- information booklets
- or energy labels Raypak RFSDV34RFNAU
All of them are important, but the most important information from the point of view of use of the device are in the user manual Raypak RFSDV34RFNAU.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Raypak RFSDV34RFNAU, service manual, brief instructions and user manuals Raypak RFSDV34RFNAU. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Raypak RFSDV34RFNAU.

A complete manual for the device Raypak RFSDV34RFNAU, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Raypak RFSDV34RFNAU by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Raypak RFSDV34RFNAU.

A complete Raypak manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Raypak RFSDV34RFNAU - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Raypak RFSDV34RFNAU, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Raypak RFSDV34RFNAU, that we can find in the current document
3. Tips how to use the basic functions of the device Raypak RFSDV34RFNAU - which should help us in our first steps of using Raypak RFSDV34RFNAU
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Raypak RFSDV34RFNAU
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Raypak RFSDV34RFNAU in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Raypak RFSDV34RFNAU?

Use the form below

If you did not solve your problem by using a manual Raypak RFSDV34RFNAU, ask a question using the form below. If a user had a similar problem with Raypak RFSDV34RFNAU it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)