English dropdown-ico

Manual Bosch Appliances HMV9307

20 pages 0.85 mb
Download

Go to site of 20

Summary
  • Bosch Appliances HMV9307 - page 1

    Household Appliances Over -the-Range Microwave Installation Instructions For Models: HMV9302, HMV9305, HMV9306, HMV9307 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING IMPORT ANT : Save these instructions for the local electrical inspector’ s use. INST ALLER: Please leave these Installation Instructions with this unit for the owner . OWNER: Ple ...

  • Bosch Appliances HMV9307 - page 2

    2 YOUR SAFETY FIRST BEFORE YOU ST ART • Proper installation is the installer's responsibility! – Read the entire manual before you begin. The Model number label is located on the oven front. See Figure 1. Mounting plate is located on back side of microwave oven. See Figure 2. BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS: FOR YOUR SAFE ...

  • Bosch Appliances HMV9307 - page 3

    3 • THIS APPLIANCE MUST BE GROUNDED! ...

  • Bosch Appliances HMV9307 - page 4

    4 • MAKE SURE YOU HAVE ENOUGH SPACE AND SUPPORT. – Mount the oven against a flat, vertical wall, so it is supported by the wall. The wall should be constructed of minimum 2" x 4" wood studding and 3/8" thick drywall or plaster/lath. – ATTACH AT LEAST ONE of the two lag screws supporting the oven to a vertical, 2" x 4" ...

  • Bosch Appliances HMV9307 - page 5

    5 THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN: P AR TS, TOOLS, MA TERIALS Damper/duct connector (for roof vented or wall vented installation) Not Actual Size Four 1/4" x 2" lag screws - Actual Size (for wall stud holes) Four 1/4" x 3" toggle bolts - Actual Size (for drywall holes) Two 1/4" x 3" bolts - Actual Size O ...

  • Bosch Appliances HMV9307 - page 6

    6 YOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THE INSTALLATION: Carton or other heavy material for covering the counter top. • If you have brick or masonry walls, you will need special hardware and tools. • The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper (shown on page 5). ...

  • Bosch Appliances HMV9307 - page 7

    7 A VOID ELECTRICAL SHOCK! THIS APPLIANCE MUST BE GROUNDED! 1. Locate the grounded electric outlet for this oven in the cabinet above the oven, as shown in Figure 4 Detail. 2. You will cut the power-supply-cord hole (shown in Figure 4 Detail) later when you prepare the wall and upper cabinet in Step 4. Improper grounding could result in electric sh ...

  • Bosch Appliances HMV9307 - page 8

    8 THIS OVEN MUST BE PROPERLY VENTED! You may vent your oven in one of three ways: Roof-venting If your oven is located on an outside wall near the roof, as in Figures 5 (3 1 / 4 " x 10" duct) and 8 (6" round duct.) Wall-venting If your oven is located on an outside wall on the first floor of your house, as in Figure 7 (3 1 / 4 " ...

  • Bosch Appliances HMV9307 - page 9

    9 STEP 2: PREP ARE THE VENTING SYSYTEM ST ANDARD FITTINGS DUCT LENGTH The total length of the duct system, including straight duct, elbows, transitions, wall or roof caps must not exceed the equivalent of 140 feet. For best performance, do not use more than three 90 degree elbows. Below are the standard fittings and their equivalent length in feet. ...

  • Bosch Appliances HMV9307 - page 10

    10 Your microwave oven is shipped with the blower assembled for roof venting. You need to adjust the blower if you want wall-venting or room-vented (recirculating) installation. ELECTRICAL SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT . • DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in electrica ...

  • Bosch Appliances HMV9307 - page 11

    11 W ALL-VENTED INST ALLA TION: 1. Remove one blower unit mounting screw and one blower plate screw. Remove the blower plate from cabinet. See Figure 13. 2. Carefully lift the blower unit out of the microwave oven. 3. Use side cutters or tin snips to cut and remove knockouts “B” from Back plate. Discard knockouts. Be careful not to distort the ...

  • Bosch Appliances HMV9307 - page 12

    12 STEP 3: PREP ARE THE VENTING BLOWER ROOM-VENTED (Recirculating) INST ALLA TION: 1. Remove one blower unit mounting screw and one blower plate screw. Remove the blower plate from cabinet. See Figure 19. 2. Carefully lift the blower unit out of the microwave oven. 3. Rotate blower unit 90 ˚ so the exhaust ports face the front of the cabinet. See ...

  • Bosch Appliances HMV9307 - page 13

    13 MEASURE AND T ACK / T APE UP THE TEMPLA TES 1. Using a plumb line and (metal) measuring tape, find and mark the vertical center line on the back wall, as in Figure 22. 2. Find and mark one or two points where the studs are on the wall (Studs are normally 16 inches apart) and then measure and mark the stud locations. If you cannot find any wall s ...

  • Bosch Appliances HMV9307 - page 14

    14 DRILLING THE HOLES IN THE W ALL AND UPPER CABINET : BE VER Y CAREFUL WHEN DRILLING HOLES INTO THE W ALL. Electrical wires could be concealed behind the wall covering and if the drill hits them you could get an electric shock. 1. Find the points on the mounting plate labeled A, B, C , and D . Drill a 3/16" diameter hole at any of these point ...

  • Bosch Appliances HMV9307 - page 15

    15 STEP 5: INST ALL THE MOUNTING PLA TE TO THE W ALL 1. Draw a vertical line on the wall at the center of the 30 ″ wide space. Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the notch and center line on the mounting plate to t ...

  • Bosch Appliances HMV9307 - page 16

    16 STEP 5: INST ALL THE MOUNTING PLA TE TO THE W ALL TO PREP ARE THE REAR W ALL CUTOUT OPENING AND EXHAUST ADAPTOR/MOUNTING PLA TE FOR W ALL-VENTED: 1. Place the mounting plate against the rear wall as described in step 5 item 1 (page 15). 2. Using a pencil, put dots through slots F and G, and through holes H and I. Remove the mounting plate and dr ...

  • Bosch Appliances HMV9307 - page 17

    17 STEP 6: A TT ACH THE OVEN TO THE W ALL You will need two people to lift this microwave. Failure to use more than one person could result in personal injury . 1. Carefully lift microwave oven and hang it on support tabs (See Figure 26 on the page 15) at the bottom of the mounting plate. Reaching through upper cabinet, thread power supply cord thr ...

  • Bosch Appliances HMV9307 - page 18

    18 STEP 6: A TT ACH THE OVEN TO THE W ALL 5. Roof vented installation: See Figure 32 Install ductwork through the vent opening in the upper cabinet. Complete the venting system through the roof according to the method needed. See “ PREPARE THE VENTING SYSTEM, ” step 2 on the page 8. Use caulking to seal exterior roof opening around the exhaust ...

  • Bosch Appliances HMV9307 - page 19

    Installation Notes ...

  • Bosch Appliances HMV9307 - page 20

    Printed in Korea P/No.: 3828W5U0310 ...

Manufacturer Bosch Appliances Category Microwave Oven

Documents that we receive from a manufacturer of a Bosch Appliances HMV9307 can be divided into several groups. They are, among others:
- Bosch Appliances technical drawings
- HMV9307 manuals
- Bosch Appliances product data sheets
- information booklets
- or energy labels Bosch Appliances HMV9307
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bosch Appliances HMV9307.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bosch Appliances HMV9307, service manual, brief instructions and user manuals Bosch Appliances HMV9307. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bosch Appliances HMV9307.

Similar manuals

A complete manual for the device Bosch Appliances HMV9307, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bosch Appliances HMV9307 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bosch Appliances HMV9307.

A complete Bosch Appliances manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bosch Appliances HMV9307 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bosch Appliances HMV9307, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bosch Appliances HMV9307, that we can find in the current document
3. Tips how to use the basic functions of the device Bosch Appliances HMV9307 - which should help us in our first steps of using Bosch Appliances HMV9307
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bosch Appliances HMV9307
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bosch Appliances HMV9307 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bosch Appliances HMV9307?

Use the form below

If you did not solve your problem by using a manual Bosch Appliances HMV9307, ask a question using the form below. If a user had a similar problem with Bosch Appliances HMV9307 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)