English dropdown-ico

Manual Ice-O-Matic CD20030 CD20530

22 pages 0.83 mb
Download

Go to site of 22

Summary
  • Ice-O-Matic CD20030 CD20530 - page 1

    SERVICE/INST ALLA TION MANUAL HOTEL/MOTEL DISPENSER Part Number 80701101 Print Date: 6/00 GC Series Cuber Shown CD10022 CD10522 ICE Series Cuber Shown CD20030 CD20530 ICE-O-Matic 11100 East 45th Avenue Denver , Colorado, USA 80239 ...

  • Ice-O-Matic CD20030 CD20530 - page 2

    ...

  • Ice-O-Matic CD20030 CD20530 - page 3

    CD10022 CD20030 CD10522 CD20530 Intr oduction T o the owner or user . This product is a sour ce of information about the installation, start up, cleaning, maintenance and repair of the pr oduct. The CD10022, CD10522, CD20030 and CD20530 are Ice-O-Matics brand hotel/motel ice dispenser . The CD10022 is designed to use a Ice-O-Matic model GC300, 550, ...

  • Ice-O-Matic CD20030 CD20530 - page 4

    CD10022 CD20030 CD10522 CD20530 Specifications Limitations: • Must meet the same limitations as the cuber installed on top of it: • 50 o F air minimum • 100 o F air maximum • Must be installed indoors • Must allow space to the right for air intake when using air cooled machine. • The CD10022 and CD10522 are compatible only with Ice-O-Ma ...

  • Ice-O-Matic CD20030 CD20530 - page 5

    CD10022 CD20030 CD10522 CD20530 Installation: General After the carton has been removed fr om the dispenser , the legs may be installed. Place flat portions of the carton on the floor behind the dispenser and lay the dispenser down on its back. Thread the legs into the base of the dispenser . Be sure that the legs ar e scr ewed in all the way . T u ...

  • Ice-O-Matic CD20030 CD20530 - page 6

    CD10022 CD20030 CD10522 CD20530 Installation: Ice Machine Check that gasket tape has been placed at the outside edge of the dispenser top. Place corner posts from the carton on top of the dispenser , at the left and right corners. Place the ice machine onto the dispenser . The ice machine is heavy , use of a mechanical hoist is recommended. Careful ...

  • Ice-O-Matic CD20030 CD20530 - page 7

    CD10022 CD20030 CD10522 CD20530 Kits: Coin Mechanism Kits are available to install a coin mechanism, a room key mechanism or a key car d mechanism. All kits come with detailed instructions which are also listed below . Please follow these instructions carefully to complete the addition of the coin mechanism kit to the CD10022, CD10522, CD20030, and ...

  • Ice-O-Matic CD20030 CD20530 - page 8

    CD10022 CD20030 CD10522 CD20530 Kits: Coin Mechanism 15. Replace the control box cover , front brace and decorative front cover . The dispenser should now be restor ed to service. 6 ...

  • Ice-O-Matic CD20030 CD20530 - page 9

    CD10022 CD20030 CD10522 CD20530 Key Kit Installation This kit has been designed for use with the CD10022, CD10522, CD20030 and CD20530 ice dis- penser . When this kit is installed, ice cannot be dis- pensed unless a specific type of key is inserted into the lock cylinder . The kit contains a universal mount- ing fitting for lock cylinders and a swi ...

  • Ice-O-Matic CD20030 CD20530 - page 10

    CD10022 CD20030 CD10522 CD20530 Key Kit Installation The operation of this kit is as follows: When the key is inserted into the lock cylinder , a portion of the key will extend beyond the brass fitting. It is this part of the key that will actuate the kit micro switch. Then when the dispense button swithch is depressed and held; the machine will di ...

  • Ice-O-Matic CD20030 CD20530 - page 11

    CD10022 CD20030 CD10522 CD20530 Key Car d Kit Installation This kit has been designed for use with the CD10022, CD10522, CD20030 and CD20530 ice dispenser . When this kit is installed, ice cannot be dispensed unless a key card is inserted into the key card slot. The kit contains a universal mounting and a microswitch assembly . 1. Make sure all ele ...

  • Ice-O-Matic CD20030 CD20530 - page 12

    CD10022 CD20030 CD10522 CD20530 Key Car d Kit Installation The Operation of this kit is as follows: When the key card is inserted into the key car d slot, and the dispenser button switch is depressed and held, the machine will dispense ice.. 10 ...

  • Ice-O-Matic CD20030 CD20530 - page 13

    CD10022 CD20030 CD10522 CD20530 Final Check List/Initial Start Up 11 1. Check that electrical power has been supplied. 2. Check that a drain, separate from the ice machine, insulated and made of rigid tubing, has been connected to the dispenser . 3. Check that the ice machine has been properly installed per the ice machine’ s installation directi ...

  • Ice-O-Matic CD20030 CD20530 - page 14

    CD10022 CD20030 CD10522 CD20530 Operational Schematic 12 ...

  • Ice-O-Matic CD20030 CD20530 - page 15

    CD10022 CD20030 CD10522 CD20530 Cleaning General Care and Ceaning: Periodically inspect and clean the ice dispenser to keep it operating at peak performance. W ash the outside of the dispenser with warm water and soap. Rinse off and dry . Cleaning and Sanitizing of the Ice Storage Bin: The minerals, chlorine and other impurities in the water are r ...

  • Ice-O-Matic CD20030 CD20530 - page 16

    CD10022 CD20030 CD10522 CD20530 Cleaning 10. Mix a solution of ice machine sanitixer and water: 1 ounce of household bleach to 2 gallons of (95 o F-115 o F) water . W ash all interior surfaces and the wheel withthe sanitizer solution. Use a clean cloth. 11. Allow the parts to air dry . 12.Reassemble wheel and sweep arm onto drive shaft. 13. Replace ...

  • Ice-O-Matic CD20030 CD20530 - page 17

    CD10022 CD20030 CD10522 CD20530 Service Diagnosis Leaks water Bin drain leaks Check bin drain connections and fittings Check for clogged bin drain tubing Coin Mechanism Does not vend, no ice Check the above, plus coin switch 15 PROBLEM Does not vend POSSIBLE CAUSE No ice PROBABLE FIX Check ice machine Check power supply Check / replace vend switch ...

  • Ice-O-Matic CD20030 CD20530 - page 18

    CD10022 CD20030 CD10522 CD20530 Removal and Replacement Gear Motor: 1. Disconnect electrical power . 2. Locate key and remove fr ont panel. 3. Remove dispenser wheel. 4. Disconnect wires at gearmotor . 5. Remove 4 bolts securing gearmotor bracket to cabinet. 6. Pull gearmotor out of cabinet. 7. Remove gearmotor from bracket. 8. Reverse steps to rea ...

  • Ice-O-Matic CD20030 CD20530 - page 19

    CD10022 CD20030 CD10522 CD20530 Standar d With Room Key Kit or Car d Kit Electrical Schematic 17 ...

  • Ice-O-Matic CD20030 CD20530 - page 20

    CD10022 CD20030 CD10522 CD20530 Standar d With Room Key Kit or Car d Kit Electrical Schematic 18 ...

  • Ice-O-Matic CD20030 CD20530 - page 21

    CD10022 CD20030 CD10522 CD20530 With Coin Mechanism Electrical Schematic 19 ...

  • Ice-O-Matic CD20030 CD20530 - page 22

    SER VICE HISTOR Y MODEL NUMBER: ______________ SERIAL NUMBER: _____________ ____________________________ ____________________________ ____________________________ ____________________________ ____________________________ ____________________________ ____________________________ ____________________________ ____________________________ _____________ ...

Manufacturer Ice-O-Matic Category Beverage Dispenser

Documents that we receive from a manufacturer of a Ice-O-Matic CD20030 CD20530 can be divided into several groups. They are, among others:
- Ice-O-Matic technical drawings
- CD20030 CD20530 manuals
- Ice-O-Matic product data sheets
- information booklets
- or energy labels Ice-O-Matic CD20030 CD20530
All of them are important, but the most important information from the point of view of use of the device are in the user manual Ice-O-Matic CD20030 CD20530.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Ice-O-Matic CD20030 CD20530, service manual, brief instructions and user manuals Ice-O-Matic CD20030 CD20530. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Ice-O-Matic CD20030 CD20530.

Similar manuals

A complete manual for the device Ice-O-Matic CD20030 CD20530, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Ice-O-Matic CD20030 CD20530 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Ice-O-Matic CD20030 CD20530.

A complete Ice-O-Matic manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Ice-O-Matic CD20030 CD20530 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Ice-O-Matic CD20030 CD20530, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Ice-O-Matic CD20030 CD20530, that we can find in the current document
3. Tips how to use the basic functions of the device Ice-O-Matic CD20030 CD20530 - which should help us in our first steps of using Ice-O-Matic CD20030 CD20530
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Ice-O-Matic CD20030 CD20530
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Ice-O-Matic CD20030 CD20530 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Ice-O-Matic CD20030 CD20530?

Use the form below

If you did not solve your problem by using a manual Ice-O-Matic CD20030 CD20530, ask a question using the form below. If a user had a similar problem with Ice-O-Matic CD20030 CD20530 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)