English dropdown-ico

Manual Taylor 371

16 pages 1.56 mb
Download

Go to site of 16

Summary
  • Taylor 371 - page 1

    OPERA T OR’S MANUAL Granit a Merchandising Freezers Model 369 (FBM 1P) Model 370 (FBM 2) Model 371 (FBM 3) ROCKTON, ILLINOIS 61072 ...

  • Taylor 371 - page 2

    Complete this page for quick re ference when service is required: Taylor Distributor: __________________________________________________________ Address:_________________________________________________________________ Phone:____________________________________________________ _______ ________ Service:_______________________________________________ ...

  • Taylor 371 - page 3

    Models 369/370/371 3 ENGLISH Note: Continuing research results in st eady improve menets; there fore, information in this man ual is subject to change without notice. This dispenser is manufact ured under one or more of th e following U.S.patents and /or other pending patents : U.S.A. 4,900,158 U.S.A. 4,696,417 U.S.A. 5,713,214 U.S.A. 5,906,105 TAB ...

  • Taylor 371 - page 4

    4 Models 369/ 37 0 / 37 1 1 TECHNICAL CHARACTERISTICS The electric diagram o f the dispenser is located inside inner part o f the dispen sing side pa nel. Specifications are subject to cha nge without notice. 2 INTRODUCTION Please read all sections of this man ual thoroughly to fami liarize yourself with all aspects of the unit. Like all mechanical ...

  • Taylor 371 - page 5

    Models 369/370/371 5 ENGLISH 4 TO OPERATE SAFELY 1 - Do not opera te the dispenser without rea ding this operator’s manual. 2 - Do not operate the dispenser unless it is properly grounded. 3 - Do not use extensio n cords to connect the dispenser. 4 - Do not operate the dispenser un less all panels are restrained with screws. 5 - Do not obstruct a ...

  • Taylor 371 - page 6

    6 Models 369/ 37 0 / 37 1 Safety pressure swit ch warnin g light (C) To operate the unit: 1 - Set the power sw itch to I position. 2 - Set the mixer/refrigerat ion switches as follows: - to the I position to get soft drink. - to the II position to get Granita. 3 - Set the light swi tch to I positi on. 5. 2 OPERATION HELPFUL HINTS 1 - Gra nita visco ...

  • Taylor 371 - page 7

    Models 369/370/371 7 ENGLISH side up and off the hook located on th e opposite side (see figure 6). figure 6 3 - Remove the bowl by lifting its faucet side up and off the fastening hooks (see figure 7) and slide it out (see figure 8). figure 7 figure 8 4 - Slide th e outer spiral out (see figure 9) and the n the inside auger (see figure 10). figure ...

  • Taylor 371 - page 8

    8 Models 369/ 37 0 / 37 1 5 - Remove the bowl gasket from its seat (see figure 11). figure 11 6 - Dismantle the faucet assembly (see figure 12). figure 12 7 - Slide the drip tray out and empty it. 5. 3. 2 CLEANING 1 - Prepare at least two gallo ns of a mild cleaning solution of warm (45-60 °C / 120-14 0 °F) potable water and dishwashing detergent ...

  • Taylor 371 - page 9

    Models 369/370/371 9 ENGLISH (see figure 12) 4 - Fit bowl gasket around i ts seat. Note: the largest brim of g asket must face again st th e rear wall (see figure 14). figure 14 5 - Carefully in sert the auger into the evapora tor use caution to prevent it from h itting the rear wall (see figure 15). figure 15 6 - Install the outer spiral. Slide it ...

  • Taylor 371 - page 10

    10 Models 369/ 37 0 / 37 1 from the condenser filter. Remove the only left panel (fro m faucet side) unscrewing the two plastic coated screws (see figure 18). figure 18 3 - Replacement of lighted top co ver bulb: remove the scre w placed in the upper pa rt of the top cover, remove the lo wer part and replace the bulb (using a 24 -28V 21W max bu lb) ...

  • Taylor 371 - page 11

    Models 369/370/371 11 ENGLISH time of day with the arrow B o n the timer face. Th is is a 24 hour timer showing both A.M. and P.M. 2 - Program the defrost timer by pushing ou t on the tabs C that correspond to the hours desired to defrost. Each tab represents 15 minutes. A minimum of four to eight h ours are required to defrost frozen beverage (d e ...

  • Taylor 371 - page 12

    OPERATOR PARTS IDE NTIFICATION MODEL 369/370/371 2471_01 V 3.5 04I0 9 ...

  • Taylor 371 - page 13

    1 047634 Cover-Ho pper-Transparent 27 >>> Relay-Start (Compresso r) 57 046510 Knob-Temperature Control 2 046456 Hopper-10.7 Qt./10 Liter 28 >>> Overload protector 58 PPP Transformer-Light bulb 3 046457 Valve-Draw 29 >>> Capacitors 59 052212 Insulation-Flange-Foam 4 046458 O-Ring-Draw Valve 30 047405 Leg-4” 8MM Thread 60 ...

  • Taylor 371 - page 14

    GEAR MOTOR 052213-12 052213-27 052213-34 052213-44 Motor-Gear *369,370,371* GEN 3 (Magnetic Drive - BR 0067955/Up) Include: 1 052042 Bracket-Gear Motor w/Bushing 8 052047 Cap-Ball Bearing 19 052052 Gasket-Gear Motor 2 057900 Stator-Gear Motor (230V / 50Hz) 9 057878 O-Ring-Gearshaft 20 052053 Cover-Gear box 2 057901 Stator-Gear Motor (220V / 60Hz) 1 ...

  • Taylor 371 - page 15

    Models 369/370/371 15 IMPORTANT: The display light bulb must be replaced with the fact ory authorized replacement bulb. Failure to comply may result in component damag e or severe persona l injury du e to broken glass. Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY 1 - Product is too stiff. a - Improper mi xi ng of product. b - Mix low conditi ...

  • Taylor 371 - page 16

    046445-M 2471_01 R0.4 04I09 ...

Manufacturer Taylor Category Juicer

Documents that we receive from a manufacturer of a Taylor 371 can be divided into several groups. They are, among others:
- Taylor technical drawings
- 371 manuals
- Taylor product data sheets
- information booklets
- or energy labels Taylor 371
All of them are important, but the most important information from the point of view of use of the device are in the user manual Taylor 371.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Taylor 371, service manual, brief instructions and user manuals Taylor 371. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Taylor 371.

Similar manuals

A complete manual for the device Taylor 371, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Taylor 371 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Taylor 371.

A complete Taylor manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Taylor 371 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Taylor 371, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Taylor 371, that we can find in the current document
3. Tips how to use the basic functions of the device Taylor 371 - which should help us in our first steps of using Taylor 371
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Taylor 371
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Taylor 371 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Taylor 371?

Use the form below

If you did not solve your problem by using a manual Taylor 371, ask a question using the form below. If a user had a similar problem with Taylor 371 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)