English dropdown-ico

Manual Clarion DPX1001.2

16 pages 0.77 mb
Download

Go to site of 16

Summary
  • Clarion DPX1001.2 - page 1

    OPERAT I ON I NSTALLAT I ON MANUAL 2/1 CHANNEL POWER AMPLIFIER ...

  • Clarion DPX1001.2 - page 2

    DPX1001.2 Power System Amplifier 2 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Input Connections and Audio Controls . . . . . . . . . . 4 Connections for Power and Speakers . . . . . . . . . . 5 Applications . . . . . . . . . . ...

  • Clarion DPX1001.2 - page 3

    Owner’s Manual 3 Owner’s Manual • Gold-plated input/output connectors • Aluminum heat sink for efficient heat dissipation • Low profile, compact size for space limited installations • Wired remote Sub Level Control (BC2) included • Full range or low pass output mode • High level inputs • Built-in Subsonic filter ABOUT THE MANUAL A ...

  • Clarion DPX1001.2 - page 4

    DPX1001.2 Power System Amplifier 4 INPUT CONNECTIONS AND AUDIO CONTROLS The front panel of the DPX1001.2 contains connections for RCA Inputs, Speaker Level Inputs and Audio Controls as shown below. The RCA Input Connections are gold-plated RCA jacks and are labeled as RIGHT and LEFT. • Remote Sub level Control - This port is for the supplied remo ...

  • Clarion DPX1001.2 - page 5

    Owner’s Manual 5 Use this feature, along with your speaker manufacturer’s recommended crossover frequencies, to quickly design a more advanced system. • X-Over Slope Switch - This switch will change the X-Over between a 12db and 24dB per octave slope. The steep crossover slope keeps midrange tones out of the subwoofer and thereby eliminates a ...

  • Clarion DPX1001.2 - page 6

    DPX1001.2 Power System Amplifier 6 APPLICATIONS The Clarion DPX1001.2 2-channel car audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. Figure 3 - In this application the amplifier is bridged for mono operation to drive a subwoofer. Minimum load in the bridged mode is 2 ohms. B ...

  • Clarion DPX1001.2 - page 7

    Owner’s Manual 7 Figure 4 - In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE: A passive crossover must be used with satellite speakers. Minimum load in the stereo mode is 1ohm. 2-Channel Full Range, Satellite, or Subwoofer Stereo System Set Amp Mode as shown Set Amp Mode as ...

  • Clarion DPX1001.2 - page 8

    DPX1001.2 Power System Amplifier 8 (Set INPUT SELECT Switch to STEREO) Mixed-Mode Satellite and Subwoofer System NOTE: Chart values based on 4 ohm speakers. Figure 5 - The amplifier can be configured for a mixed-mode operation. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use components that hav ...

  • Clarion DPX1001.2 - page 9

    Owner’s Manual 9 INSTALLATION This section lists Mounting and Wiring Precautions for installing the Clarion DPX1001.2. These safeguards provide enough detail to complete the installation successfully. If you do not have the necessary skills, Clarion recommends consulting your authorized Clarion dealer for installation. MOUNTING PRECAUTIONS Althou ...

  • Clarion DPX1001.2 - page 10

    DPX1001.2 Power System Amplifier 10 5. Add an external fuse on the amplifier’s positive (+) power lead and connect it as close as possible to the vehicle’s (+) battery terminal. Use a fuse rated to the total current consumption of the amplifier(s). Adding an external fuse will protect the electrical system from short circuits that can cause a f ...

  • Clarion DPX1001.2 - page 11

    Owner’s Manual 11 Figure 6. - Electrical connections for the DPX1001.2 ...

  • Clarion DPX1001.2 - page 12

    DPX1001.2 Power System Amplifier 12 SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON pos ...

  • Clarion DPX1001.2 - page 13

    Owner’s Manual 13 FINAL SYSTEM CHECKS 1. Start the engine and turn on the source unit. After a two-second delay, slowly increase the Volume Control and listen to the audio. If you hear any noise, static, distortion or no sound at all, check the connections, and also refer to Troubleshooting. Depending on your system design, the levels may become ...

  • Clarion DPX1001.2 - page 14

    DPX1001.2 Power System Amplifier 14 Frequency Response Signal Noise Ratio THD Input Sensitivity Low Level Input Sensitivity Speaker Level Max. Power Output Cont. Power Output 2-Ohm Stereo Output Bridged Power Dimensions Current Consumption at output @ max power 20Hz ~ 20kHz >95db .2% all channels driven 250mV ~ 2.5 V 500mV - 5V 500 watts x 2 @1 ...

  • Clarion DPX1001.2 - page 15

    Owner’s Manual 15 WARRANTY INFORMATION This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. Clarion ProAudio products except for speakers are covered by a two year warranty when installed by an authorized Clarion dealer. The conditions of this warranty and the extent of ...

  • Clarion DPX1001.2 - page 16

    Clarion Corporation of America 661 W. Redondo Beach Blvd. Gardena, CA 90247-4201 U.S.A. Tel 1.800.GO.CLARION www.clarion.com DPX1001.2 Rev. 1(11/01) ...

Manufacturer Clarion Category Stereo Amplifier

Documents that we receive from a manufacturer of a Clarion DPX1001.2 can be divided into several groups. They are, among others:
- Clarion technical drawings
- DPX1001.2 manuals
- Clarion product data sheets
- information booklets
- or energy labels Clarion DPX1001.2
All of them are important, but the most important information from the point of view of use of the device are in the user manual Clarion DPX1001.2.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Clarion DPX1001.2, service manual, brief instructions and user manuals Clarion DPX1001.2. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Clarion DPX1001.2.

Similar manuals

A complete manual for the device Clarion DPX1001.2, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Clarion DPX1001.2 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Clarion DPX1001.2.

A complete Clarion manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Clarion DPX1001.2 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Clarion DPX1001.2, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Clarion DPX1001.2, that we can find in the current document
3. Tips how to use the basic functions of the device Clarion DPX1001.2 - which should help us in our first steps of using Clarion DPX1001.2
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Clarion DPX1001.2
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Clarion DPX1001.2 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Clarion DPX1001.2?

Use the form below

If you did not solve your problem by using a manual Clarion DPX1001.2, ask a question using the form below. If a user had a similar problem with Clarion DPX1001.2 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)