Manual Apple G5

22 pages 4.99 mb
Download

Go to site of 22

Summary
  • Apple G5 - page 1

    033-2501 Re v . E  iMac G5 Inverter, 20-inch Replacement Instructions F ollow the instructions in this document carefully . F ailure to f ollo w these instructions could damage your equipment and v oid its w arranty . T ools Requir ed • Use the screwdriver provided, or a Phillips #2 screwdriver, preferably with a magnetized tip • Needlenose ...

  • Apple G5 - page 2

    2 - iMac G5 Inverter, 20-inch Important Things to Kno w 1. All customer remov able scre ws are brass colored. Do not remove screws unless they are brass colored, or you will v oid y our warranty . 2. A magnetized “L”-shaped Phillips screwdriver is included with the replacement part. 3. Remove the gray plastic inverter cover before returning the ...

  • Apple G5 - page 3

    iMac G5 Inverter, 20-inch - 3 Opening the Computer Note: These instructions cover the iMac G5 (20-inc h) models. The models may look slightly diff erent from one sho wn in the illustration; ho wever , the f ollo wing procedure applies to both models. 1. T ur n off your computer b y choosing Shut Do wn from the Apple ( K ) menu. 2. Disconnect all ca ...

  • Apple G5 - page 4

    4 - iMac G5 Inverter, 20-inch 4. Locate the three silv er case screws circled belo w . Y ou ma y ha v e to lift the stand to locate the middle case screw . Note: These screws are captiv e; they are part of the displa y/bezel assemb ly and cannot be remo ved. Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws. Tur ...

  • Apple G5 - page 5

    iMac G5 Inverter, 20-inch - 5 Removing the In verter 1. T o access the inv er ter other ser vice modules ha v e to be remov ed. This procedure will show y ou how to remo v e and replace each module. As you remov e each module , set it aside, along with the scre ws f or that module . 2. Ground yourself . T ouch the metal surface (as sho wn below) on ...

  • Apple G5 - page 6

    6 - iMac G5 Inverter, 20-inch 3. Locate the memor y module(s) in the bottom right cor ner . Y ou must remo v e the memor y to gain access to the inv er ter . 4. Rotate the computer to the left so the memor y is in the position shown belo w . 5. T o release the memor y from its slot, push down on the two side latches (circled below). Pull the memor ...

  • Apple G5 - page 7

    iMac G5 Inverter, 20-inch - 7 6. Locate the gra y plastic module on the r ight side of the computer . This is the inv er ter . 7. Remov e the three in v er ter screws (circled belo w). ...

  • Apple G5 - page 8

    8 - iMac G5 Inverter, 20-inch 8. Slide the inv erter out at an angle. Locate the colored cables connected on the right side of the inv erter . Important: Carefully slide out the inv erter so that it doesn't make contact with the DIMM connector latches . 9. Disconnect the two in v er ter cables b y pulling on the connectors, not on the cab les ...

  • Apple G5 - page 9

    iMac G5 Inverter, 20-inch - 9 10. Lift the inv erter out of the computer . Gently pull the blac k cable (circled) that is connected under (see ne xt photo) the gra y fan duct. 11. This picture shows a close up of the connector from step 10. The black cab le (from the pre vious step) connects to the pins shown belo w . ...

  • Apple G5 - page 10

    10 - iMac G5 Inverter, 20-inch 12. Locate the small, gra y inverter cable cov er in the top right corner . 13. Pull the gra y cover in the direction of the arro w . ...

  • Apple G5 - page 11

    iMac G5 Inverter, 20-inch - 11 14. Disconnect the two white connectors underneath the cov er . Pull on the connectors, not on the cables . F ree the cab les from the clips inside the cov er . Set the inv er ter and cov er aside . 15. T ur n ov er the in v er ter as shown. Using your fingers or a flatb lade scre wdriver , remov e the gra y plastic ...

  • Apple G5 - page 12

    12 - iMac G5 Inverter, 20-inch 16. T ur n the inv erter board over . Disconnect the blac k cable and tr ansf er it to the replacement inv erter . ...

  • Apple G5 - page 13

    iMac G5 Inverter, 20-inch - 13 Installing the Replacement In verter 1. Remov e the replacement in v er ter from its packaging. Attach the black in v er ter cable that you remo v ed in the pre vious step . 2. Locate the gra y plastic cover that came with the in v er ter . ...

  • Apple G5 - page 14

    14 - iMac G5 Inverter, 20-inch 3. Install the plastic cov er on the replacement in v er ter board. Gently squeeze the board near each tab (circled) until all six tabs snap onto the board. 4. T ur n ov er the in v er ter . Pull the in v er ter cables up into the slot on the in v er ter cov er as shown. ...

  • Apple G5 - page 15

    iMac G5 Inverter, 20-inch - 15 5. Slide the inv erter par tially into place. Note: The excess b lack cab le tuc ks under the memor y slots. Important: Be careful of the DIMM latches when you install the inv erter board, they are very delicate. Push the DIMM latches into the closed position bef ore installing the inv er ter board. 6. Route the blac ...

  • Apple G5 - page 16

    16 - iMac G5 Inverter, 20-inch 7. Connect the inv erter cables, connecting the small connector first. Note: The connectors are ke y ed, and plug in only one wa y . 8. Lower the in v erter into place. Replace the three inverter screws. . ...

  • Apple G5 - page 17

    iMac G5 Inverter, 20-inch - 17 9. Locate the gra y inverter cable cov er . Connect the inv er ter cables as sho wn, making sure the connectors lie flat inside the cable co v er . 10. Low er the cable co v er , pressing down steadily until the tabs on the cov er loc k the cov er into the midplane . ...

  • Apple G5 - page 18

    18 - iMac G5 Inverter, 20-inch 11. T uck the in v er ter cables along the edge of the hard driv e and ne xt to the memor y tabs. 12. Replace the memor y module(s) by lining up the notch on the module with the notch on the slot. Press fir mly on the memor y module until it clicks into place . Use your thumb and inde x finger to push the module int ...

  • Apple G5 - page 19

    iMac G5 Inverter, 20-inch - 19 Closing the Computer 1. Replace the cov er so that the slots on the top edge of the co v er mate with the tabs on the displa y housing. 2. Lower and press the co v er into place until it fits snugly on the computer . ...

  • Apple G5 - page 20

    20 - iMac G5 Inverter, 20-inch 3. Tighten the case screws b y turning them to the r ight. 4. Reconnect the power cord while the computer is f ace down. ...

  • Apple G5 - page 21

    iMac G5 Inverter, 20-inch - 21 5. P osition the computer in the upr ight position. P ow er on the computer . ...

  • Apple G5 - page 22

    22 - iMac G5 Inverter, 20-inch  Apple Computer , Inc. © 2005 Apple Computer , Inc. All rights reser v ed. This document is protected under U .S . Copyright La w and International T reaties, and no par t of this document may be reproduced in an y f orm without written per mission from Apple. Apple is not responsible f or typographical, printing, ...

Manufacturer Apple Category Computer Hardware

Documents that we receive from a manufacturer of a Apple G5 can be divided into several groups. They are, among others:
- Apple technical drawings
- G5 manuals
- Apple product data sheets
- information booklets
- or energy labels Apple G5
All of them are important, but the most important information from the point of view of use of the device are in the user manual Apple G5.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Apple G5, service manual, brief instructions and user manuals Apple G5. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Apple G5.

A complete manual for the device Apple G5, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Apple G5 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Apple G5.

A complete Apple manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Apple G5 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Apple G5, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Apple G5, that we can find in the current document
3. Tips how to use the basic functions of the device Apple G5 - which should help us in our first steps of using Apple G5
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Apple G5
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Apple G5 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Apple G5?

Use the form below

If you did not solve your problem by using a manual Apple G5, ask a question using the form below. If a user had a similar problem with Apple G5 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)