English dropdown-ico

Manual Audiovox Microcruise IV

25 pages 2.57 mb
Download

Go to site of 25

Summary
  • Audiovox Microcruise IV - page 1

    i':-:"~;: '::-.;;J .~ 'J K " t .l ~ ! : { } , .;::;"::1 FORM :." ": ~ # 2756 Rev. B 10/98 ...

  • Audiovox Microcruise IV - page 2

    [ THIS MANUAL, YOUR KIT AND YOu-~ This Cruise Control Kit is a microprocessor based Cruise Control. It is designed for ease of installation and can be used with most cars, light trucks and vans. Carefully follow the installation procedures in this manual for best results. DO NOT INSTALL THIS SYSTEM ON A DIESEL POWERED VEmCLE WmCH HAS A MANUAL TRANS ...

  • Audiovox Microcruise IV - page 3

    ~ T ABLE OF CONTENTS ~ I. 4- .5 Parts List and Parts Diagram n. Helpful Hints 6 Ill. Switch Settings 7 IV. 8.. 1 1 1 1 1 12-1 1 1 1 1 1 1 1 1 ] 1 Installation Procedures A. Servo Assembly Mounting B. Throttle Connection I. Measuring Throttle Travel 2. Attaching Cable Assembly to Throttle a. Pulley Assembly using Loop Cable b. Pulley Assembly using ...

  • Audiovox Microcruise IV - page 4

    PARTS LIST Disengagement Switch use 250-4206 , " Vacuum Reservoir use 250-3417 or 250-6019 ,',' Vacuum Regulator use 250-4115 *Order Kit 250-2213 and receive parts indi~~~.; " Form #2756, Page 4 ...

  • Audiovox Microcruise IV - page 5

    r~ ~ ~) ~ O o u O o o o 0 () O D ","-..I ~ ~ ? @ .-. ~ ~ ~ @ ~ 11 lti ~ @ @ " . """'"",""c, , ' ~ ~ "."."".",.,:,".-J,!22 ~~~-&~.~ Form #2756, Page 5 ...

  • Audiovox Microcruise IV - page 6

    'C" : '," II :!!ELPFUL IDNTS ~ 1. Before Starting Installation: Familiarize yourself with the Installation Instructions and Cruise Control's components. A. If vehicle is equipped with an ANTI- rnEFf RADIO. the radio c<xie must be written down prior to disconnecting battery cable. The c<xie must be re-entered wbtJI the ...

  • Audiovox Microcruise IV - page 7

    PROGRAMMING SWITCHES ARE FOUND BElDND HARNESS END CAP ON SER YO ASSEMBL y . SWITCHES ARE SHOWN IN nIB "ON" POSmON The Actuator Assembly must be programmed for the vehicle on which it is installed. The TEN (10) programming switches must be set according to the chart below in order for the Cruise Control to operate properly. NOTE I: Both th ...

  • Audiovox Microcruise IV - page 8

    r SERVO ASSEMBL y MOUNTIN I I. NOTE: 00 NOT MOUNT SERVO ASSEMBLY IN nIB FOu.oWING AREAS: a. Under the felKIcr b. U..r the vehicle c. DirectJyto the eDgiM or bi)llrhead d With cable JX)inted ckJwn e. Near sharp. bot or DMJViDg OOjects f. Near ignition coil (No clC*r than 10-) g. In the passenger --t (noise) h. Where it will interfere with selVice ch ...

  • Audiovox Microcruise IV - page 9

    MEASUIUNG THROTfLE TRA VEL " , Continued I. Make a mark on the throtde cable when the throttle is in the idle position. (Figure 3) 2. Depress aa:elerator ~ aIMi make a mark on the throttle cable when the throttle is in the wide open position. (Ficure 4) FIGURE 4 3. Measure the di~~ between the two marks. (Fipre ~ If di~~ is greater than 1-5/8& ...

  • Audiovox Microcruise IV - page 10

    A TT ACHING CABLE ASSEMBL y TO THROTTLE This section will cover the proper ways to use the hardware available. Each section contains sample illustrations showing how the coMector is used in an actual installation. It must be noted however, that you should have an understanding of howeach attachment method works so that a proper installation is achi ...

  • Audiovox Microcruise IV - page 11

    T -Bar Adapler BeadCbain Cdver " Top Pulley / Segnle~t Bead Chain Conncctoi nGURE 10 B. Pullev Assemblv mua/J UsinL-' the T-BAR ADAPTER (250-4184J I. Remove air cleaner to expose the dual pulley segments. 2. Find the blank anchor that is located above the throttle anchor. Follow the instructions in STEP B for Anchoring Cruise Cable -pag ...

  • Audiovox Microcruise IV - page 12

    -- INST ALLA TION PROCEDURES FIGURE 13 -118 A TT ACHING CABLE ASSEMBL y TO THROTTLE D. Ford Throttle I. Select a Tube Clamp that fits the throttle cable. Make sure the tabs of the Tube Clamp point away from the carburetor or air throttle, this will prevent the throttle from banging. (Figure 13) 2. Attach Cable Assembly to the Eyelet Connector . NOT ...

  • Audiovox Microcruise IV - page 13

    2. Attach the Bead Chain to the Two Bead Connector. Secure beads by folding down the metal tabs. The following parts will be used when installed properly: Two Bead Connector, Bead Chain, Bead Chain Connector, and Bead Chain Connector Cover. (Figure 16) 3. Remove clip or pin which retains throttle cable (and washer ifprovided) and install Two Bead C ...

  • Audiovox Microcruise IV - page 14

    - ~ut I Cable Assembly / 114"-20 (., , A~.--, "-'-- --~ ---I --= ,.I 7116» Box End Wretlch ~ INST ALLA TION PROCEDURES ~ r Anchoring Cable Assembly I 1- There arc tJU'CC (3) types of comlectors used to anchor tJ1e Cable Assembly: A. Snap-In Adapter B. General Motors Blank Anchor C. Tube Clamp ~~~ I ~ i--F onned Threads -1-3/8&q ...

  • Audiovox Microcruise IV - page 15

    Vehicle Cable Assembly - .8. General Motors Blank Anchor I. To locate the blank anchor on General Motors vehicles. it is necessary to remove the air cleaner. The blank anchor is located above the throttle anchor . ,. Dri1l1/4" From Side 2. This anchor is hollow except at one end. Use a 114. bit and drill as shown in Figure 22~ FIGURE 1.1. f~ 3 ...

  • Audiovox Microcruise IV - page 16

    / Tube Clamp Adjustable ~ Sleeve Assembly c Tube OalnD , I. Before using the Tube Clamp slide tI)e Adjustable Sleeve into a 1<K:a'tiaR-oD the Cable Assembly so you can center the Tube Clamp to avoid slippage. (Figure 26) FIGURE 26 Bead Chain 2. The Tube Clamp may be used to anchor the Cable Assembly to an exjsting throttle cable bracket. (F ...

  • Audiovox Microcruise IV - page 17

    I Vacuum Line Vacuum Tee "" FIGURE 29 ~0..bl' Cap Suggested Vacuum Source Locations: a. Factory Installed Tee with removable cap (Figure 29) b. Manifold Vacuum Tree usually with an extra vacuum port with removable cap (Figure 30) c. Existing Vacuum Canister mounted on vehicle generally on the inner fenderwell or engine bulkhead (Figu ...

  • Audiovox Microcruise IV - page 18

    Harness Assembly I. Plug Bamess Assembly into Servo Assembly. Be sure to push Rubber Grommet securely into place. (Figure 35) Place cover onto the Servo Assembly and securely fasten screws. (Figure 36) --Saw Aaembly ~ . Rubber Oiw ~ nGURE 35 Harness ASIeIDbly 2. Straighten the Harness Assembly and find the 4 pin mating connectors. Separate the 4 pi ...

  • Audiovox Microcruise IV - page 19

    i It,~,,;i . ~ ".');.,., .",. -~:!'. I~ I Cruise Control Switch Installatio I '",,'-; ~~.;f~, If your Cruise Control switch is the type which clamps on the turn signal lever, requires cutting the turn signal lever, or is ~f'c;; mounted on ~ instrument panel, follow instructions packaged with it. If you ha.ve ...

  • Audiovox Microcruise IV - page 20

    ~ SELF DIAGNOSTICS PROCEDURES ';"' Entering Diagnostics Mode: " I. Turn the Cruise Control Switch to the OFF position 2. Turn the ignition switch to the OFF position 3. Press and hold the RESUME/ACCEL slide switch while you turn thc ignition switch to the ON position Mlitjollt starting tIle eIIg;'.e. Now release the RESUMFJ ...

  • Audiovox Microcruise IV - page 21

    ...

  • Audiovox Microcruise IV - page 22

    ~ ~ w ~ ZO ~Q. OZ a:O ~~ z ~ ~ ~ 0 (I) z LU (I) O W UJ a.. ~ -8 B:~ t= Go O I ~ - o x z. ~~ ..JO ~~ .1 4( >-z cQ ~IR . c~ cn > ~Q IU ---" ..J ..J IU ~ ..JOOe~ ~>OCIJ~ UlO m ~- -JCO ~ ]:.~ (J 4( 1- ~ ~ ~ < « o~ wW ~a . t- ~ &I. &I. 0 z 0 -J III 0 O C W 2 ~ CD W « PIx 8e si jo' §~ ~o ~o .'1 :§I ~ ~I :1 ~ II J ~ ...

  • Audiovox Microcruise IV - page 23

    I i t [ ; ~ r ~ I ~ IN EASTERN U.8.A.: AUDIOVOX CORPORA nON. 60 ARKA Y DRIVE. HAUPP AUGE. NEW YORK 11788 -(516) 231-6051 IN WESTERN U.8.A.: AUDIOVOX WEST CORPORAnON, 16808 MARQUARDT AVENUE. CERRn"OS. CALIFORNIA 90701 (213) 926-7758 OWNER'S WARRANTY RECORD (To be completed by selling dealer and retained by customer) i ~ ~ Customer's N ...

  • Audiovox Microcruise IV - page 24

    ROAD TESTING Be sure to road test your Cmisc Control after instAJlatioD.lfyoor Cmisc Control was installed correctly, it should perfonn as indicated in this section. The Cnaile Control Switch is used to opcrate the system. TEST DRIVE Follow the operating instructions to test drive your new Cruise Control. Try all functions on your Cmise Control to ...

  • Audiovox Microcruise IV - page 25

    TECHNICAL SERVICE In the event that you need technical assistance with trouble shooting, please h~ve the following information ready when calling our Technical Service Department 910-277-1828. This information is important for a proper and speedy diagnosis of the problems encountered. Model Number of Cruise Control System printed on box and DI8Dufa ...

Manufacturer Audiovox Category car-cruise ctrl kit

Documents that we receive from a manufacturer of a Audiovox Microcruise IV can be divided into several groups. They are, among others:
- Audiovox technical drawings
- Microcruise IV manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox Microcruise IV
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox Microcruise IV.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox Microcruise IV, service manual, brief instructions and user manuals Audiovox Microcruise IV. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox Microcruise IV.

Similar manuals

A complete manual for the device Audiovox Microcruise IV, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox Microcruise IV by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox Microcruise IV.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox Microcruise IV - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox Microcruise IV, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox Microcruise IV, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox Microcruise IV - which should help us in our first steps of using Audiovox Microcruise IV
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox Microcruise IV
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox Microcruise IV in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox Microcruise IV?

Use the form below

If you did not solve your problem by using a manual Audiovox Microcruise IV, ask a question using the form below. If a user had a similar problem with Audiovox Microcruise IV it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)