Manual Hotpoint 228

16 pages 0.65 mb
Download

Go to site of 16

Summary
  • Hotpoint 228 - page 1

    Instruction booklet DISHWASHER Contents Installation, 2-5 Positioning and levelling Technical data Electrical connection Connecting the water supply Ecodesign Regulation Description of the appliance, 6 Overall view Control panel Loading the racks, 7 Lower rack Cutlery basket Upper rack Start-up and use, 8 Starting the dishwasher Loading the deterge ...

  • Hotpoint 228 - page 2

    2 EN Advice regarding the first wash cycle After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt dispenser with water and add only then approximately 1 kg of salt ( see chapter entitled Rinse aid and refined salt ). The water may overflow: this is normal and is not a cause for concern. Sel ...

  • Hotpoint 228 - page 3

    3 EN The dishwasher meets the requirements set out by the regulations in force concerning safety and electrical equipment. Any technical checks should be conducted exclusively by a trained and authorised technician: Repairs carried out by unaithorised persons will invalidate the guarantee, as well as posing a potential hazard to the user. The manuf ...

  • Hotpoint 228 - page 4

    4 EN Connecting the water supplies Connection to the water and electricity supplies should only be performed by a qualified technician. The dishwasher should not stand on top of the water hoses or the electricity supply cable. Connecting the water inlet hose The water inlet and outlet hoses and the electricity supply cable may be positioned towards ...

  • Hotpoint 228 - page 5

    5 EN Anti-flooding protection * To ensure floods do not occur, the dishwasher: - is provided with a special system which blocks the water supply in the event of anomalies or leaks from inside the appliance. Some models are also equipped with the supplementary safety device New Acqua Stop * , which guarantees anti- flooding protection even in the ev ...

  • Hotpoint 228 - page 6

    6 EN Overall view 1. Upper rack 2. Upper sprayer arm 3. Tip-up compartments 4. Rack height adjuster 5. Lower rack 6. Lower sprayer arm 7. Cutlery basket 8. Washing filter 9. Salt dispenser 10. Detergent and rinse aid dispensers 11. Data plate 12. Control panel *** *** Only in completely built-in models. * Only available in selected models. Descript ...

  • Hotpoint 228 - page 7

    7 EN Loading the racks * Only available in selected models. The number and position may vary. Before loading the racks, remove all food residue from crockery and empty liquids from glasses and cups. After loading the appliance, make sure that the sprayer arms can rotate freely. Lower rack and cutlery basket The lower rack can hold pans, lids, plate ...

  • Hotpoint 228 - page 8

    8 EN Start-up and use Starting the dishwasher 1. Turn the water tap on. 2. Open the door and press the ON/OFF button: you will hear a short beep and the display and option indicator lights switch on. 3. Measure out the detergent ( see below ). 4. Load the racks ( see Loading the racks ). 5. Select the wash cycle in accordance with the type of crock ...

  • Hotpoint 228 - page 9

    9 EN Wash cycles If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, re- duce the amount of detergent used accordingly. The number and type of wash cycles and options may vary depending on the dishwasher model. Note To make it easier to measure out the detergent, it is worth remembering ...

  • Hotpoint 228 - page 10

    10 EN G H F Rinse aid and refined salt Only use products which have been specifically designed for dishwashers. Do not use table salt or industrial salt, or washing up liquid. Follow the instructions given on the packaging. If using a multi-functional product it is not necessary to add rinse aid; however, we recommend that you add salt, especially ...

  • Hotpoint 228 - page 11

    11 EN Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. • Always unplug the appliance when cleaning it and when performing maintenance work. Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a non-abrasive ...

  • Hotpoint 228 - page 12

    12 EN The appliance was designed and manufactured in compliance with current international safety standards. The following information has been provided for safety reasons and should therefore be read carefully. General safety • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabil ...

  • Hotpoint 228 - page 13

    13 EN Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance ( see Assistance ). Troubleshooting Problem: Possibl e causes / Soluti ons: The dishwash er does not start or cannot be cont rolled • Switc h off the applianc e by press ing the ON/OFF butt on, swit ch it back on af t er approxim ...

  • Hotpoint 228 - page 14

    14 EN After Sales Service After Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in the country offering you access to 400 skilled telephone advisors and 1000 fully qualified engin ...

  • Hotpoint 228 - page 15

    15 EN Guarantee 12 months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, ...

  • Hotpoint 228 - page 16

    16 EN 195064984.03 06/2012 pb - Xerox Fabriano ...

Manufacturer Hotpoint Category Dishwasher

Documents that we receive from a manufacturer of a Hotpoint 228 can be divided into several groups. They are, among others:
- Hotpoint technical drawings
- 228 manuals
- Hotpoint product data sheets
- information booklets
- or energy labels Hotpoint 228
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hotpoint 228.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hotpoint 228, service manual, brief instructions and user manuals Hotpoint 228. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hotpoint 228.

A complete manual for the device Hotpoint 228, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hotpoint 228 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hotpoint 228.

A complete Hotpoint manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hotpoint 228 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hotpoint 228, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hotpoint 228, that we can find in the current document
3. Tips how to use the basic functions of the device Hotpoint 228 - which should help us in our first steps of using Hotpoint 228
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hotpoint 228
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hotpoint 228 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hotpoint 228?

Use the form below

If you did not solve your problem by using a manual Hotpoint 228, ask a question using the form below. If a user had a similar problem with Hotpoint 228 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)