Manual Thermador HMCN36FS

32 pages 2.52 mb
Download

Go to site of 32

Summary
  • Thermador HMCN36FS - page 1

    DOWNDRAFT USE AND CARE MANUAL MODELS: CVS2 MODELS: UCV2 DOWNDRAFT USE AND CARE MANUAL MODEL: HMCN 36 FS / 42 FS VENTILA TION INST ALLA TION MANUAL ...

  • Thermador HMCN36FS - page 2

    2 en page 0 3–1 0 fr page 11 – 19 es página 20 – 28 ...

  • Thermador HMCN36FS - page 3

    3  W ARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fir e-related construction. B. Sufficient air is needed for pr oper combustion and exhausting of gas ...

  • Thermador HMCN36FS - page 4

    4 Fig. 1 GAS ELECTRIC IMPORT ANT INFORMA TION Old appliances are not worthless rubbish. V aluable raw materials can be r eclaimed by r ecycling old appliances. Befor e disposing of your old appliance, render it unusable. Y ou received your new appliance in a protective shipping carton. All packaging materials are envir onmentally friendly and r ecy ...

  • Thermador HMCN36FS - page 5

    5 The exhaust air is discharged upwards through a duct or dir ectly through the outside wall into the open. D Exhaust air should neither be directed into a smoke or exhaust flue that is currently used for other purposes, nor into a duct that is used for ventilating rooms in which stoves or fireplaces ar e also located. Exhaust air may be discharg ...

  • Thermador HMCN36FS - page 6

    6 For optimum hood efficiency: ❑ Short, smooth duct pipe. ❑ As few bends in the ducting as possible. ❑ Diameter of ducting to be as large as possible and no tight bends in ducting. If long, rough exhaust-air ducting, many ducting bends or smaller pipe diameters are used, the air extraction rate will no longer be at an optimum level and there ...

  • Thermador HMCN36FS - page 7

    7 Step 3: ELECTRICAL CONNECTION  W ARNING: THIS APPLIANCE MUST BE GROUNDED The hood should only be connected to a grounded socket that has been installed according to r elevant regulations. If possible, site the earthed socket directly behind the chimney paneling. ❑ The grounded socket should be connected via its own circuit. ❑ If the ground ...

  • Thermador HMCN36FS - page 8

    8 ...

  • Thermador HMCN36FS - page 9

    9 Step 5: INST ALLA TION This hood is intended to be mounted onto the kitchen wall. 1. Remove the grease filter (r efer to Opera- ting Instructions). 2. Draw a line on the wall from the ceiling to the lower edge of the hood at the center of the location where the hood is going to be mounted. 3. Use the template to mark the points on the wall where ...

  • Thermador HMCN36FS - page 10

    13. Insert the cover panels at an angle and tilt them back. 14. Slide out the upper section and attach it to the mounting brackets at the sides with two screws. 15. Insert the grease filter (r efer to Operating Instructions). If the vent system does not operate satisfactorily during any of the above procedur es, review all steps in these Installat ...

  • Thermador HMCN36FS - page 11

    11 Pièces nécessaires ❑ Mètre à ruban ❑ T our nevis à tête Phillips ❑ Ruban à conduit ❑ Système de gaines (la configuration variant selon l’emplacement ; voir »A vant l’installation «). ❑ V is à tôles suppl,émentaires (au besoin pour l’installation de conduit) Pièces incluses ❑ Dispositif appareil (1) ❑ V is à m? ...

  • Thermador HMCN36FS - page 12

    Fig. 1 GAZ ÉLECTRIQUE INFORMA TION IMPORT ANTE Les appareils usagés ne sont pas de déchets sans valeur . Leur élimination par recyclage permet de récupérer de précieuses matièr es premièr es. Avant de mettr e au rebut un appareil usagé, r endez-le inutilisable. V otre nouvel appareil vous a été livré dans une caisse d'expédition ...

  • Thermador HMCN36FS - page 13

    13 L'air vicié est évacué vers le haut par un conduit d'aération ou directement à l'air libre en traversant le mur extérieur . D L'air vicié ne doit jamais être évacué vers un conduit de cheminée ou d'évacuation en service pour d'autres raisons, ni vers un conduit servant à l'aération de pièces dans ...

  • Thermador HMCN36FS - page 14

    14 Pour un rendement optimal de la hotte aspirante, veillez à ce que : ❑ Le conduit d'évacuation soit court et lisse. ❑ Il ait le moins possible de coudes. ❑ Il ait le plus fort diamètre et que les coudes soient les plus arrondis possibles. Si l'on utilise des conduits d'évacuation d'air longs et rugueux, de nombreux c ...

  • Thermador HMCN36FS - page 15

    15 Étape 3 : BRANCHEMENT ÉLECTRIQUE  A VERTISSEMENT : CET APP AREIL DOIT ÊTRE MIS À LA TERRE La hotte aspirante doit être raccor dée uniquement à une prise électrique avec mise à la terre montée conformément à la réglementation pertinente. Si possible, installez la prise de terre directement derrièr e le panneau de cheminée. ❑ L ...

  • Thermador HMCN36FS - page 16

    16 ...

  • Thermador HMCN36FS - page 17

    17 Étape 5: INST ALLA TION Cette hotte aspirante est destinée à être montée sur un mur de cuisine. 1. Enlevez le filtre à graisse (r eportez-vous à la Notice technique d'utilisation). 2. Tir ez un trait sur le mur depuis le plafond jusqu'au bord inférieur de la hotte au centre de l'emplacement où cette dernière doit être ...

  • Thermador HMCN36FS - page 18

    18 1. 2. 1. 2. 3. 0 9. Raccorder la hotte aux tuyaux. 10. Effectuer le branchement électrique de la hotte. 11. Retirez la pellicule de plastique protégeant les deux capots en inox.  Evitez d'endommager les surfaces lisses en acier inox. Prudence : les côtés intérieurs des capots de hotte peuvent présenter des arêtes vives. Risques de ...

  • Thermador HMCN36FS - page 19

    19 INST ALLA TION 15. Remettre le filtr e à graisse en place (voir la notice d'utilisation). Si après avoir terminé les procédur es ci-dessus, le système de ventilation ne fonctionne pas convenablement, passez en r evue les étapes de cette Notice d'installation pour vérifier que rien n'a été omis. Reportez-vous également ...

  • Thermador HMCN36FS - page 20

    20  ADVERTENCIA P ARA REDUCIR EL RIESGO DE FUEGO, DESCARGAS ELÉCTRICAS O SUFRIR LESIONES, OBSERVE LO SIGUIENTE: A. El trabajo de instalación y la instalación eléctrica deben ser realizados por una persona calificada de acuerdo con todos los códigos y normas aplicables, incluyendo los códigos de construcción con respecto a incendios. B. S ...

  • Thermador HMCN36FS - page 21

    21 Fig. 1 GAS ELÉCTRICO INFORMACIÓN IMPORT ANTE Los electrodomésticos viejos no son basura sin valor . Las valiosas materias primas pueden recuperarse mediante el r eciclado de electrodomésticos viejos. Antes de desechar su electrodoméstico viejo, haga que sea inutilizable. Usted recibió su electr odoméstico nuevo en una caja de envío prote ...

  • Thermador HMCN36FS - page 22

    22 El aire de salida debe ser liberado hacia arriba a través de un conducto o directa- mente a través de la pared externa a la intemperie. D El aire de salida no debe ser dirigido a un conducto de humo ni de salida que actualmente se utilice para otros fines, ni a un conducto que se utilice para ventilar habitaciones en las cuales también se en ...

  • Thermador HMCN36FS - page 23

    23 Para obtener la máxima eficiencia de la campana extractora: ❑ T ubería corta, lisa. ❑ La menor cantidad posible de codos en el conducto. ❑ El diámetro del conducto debe ser lo más grande posible y no debe tener codos cerrados. Si se utiliza un conducto de aire de salida largo e irregular , hay muchos codos en el conducto o el diámetr ...

  • Thermador HMCN36FS - page 24

    24 Paso 3: CONEXIÓN ELÉCTRICA  ADVERTENCIA: ESTE ELECTRO- DOMÉSTICO DEBE EST AR CONECT ADO A TIERRA. La campana extractora sólo debe conectarse a una toma de corriente con conexión a tierra que haya sido instalada conforme a las reglamentaciones pertinentes. Si es posible, ubique la toma de corriente con conexión a tierra directamente detr ...

  • Thermador HMCN36FS - page 25

    25 ...

  • Thermador HMCN36FS - page 26

    26 Step 5: INST ALACIÓN Esta campana extractora ha sido diseñada para ser montada en la pared de la cocina. 1. Retire el filtr o de grasa (consulte la sección Instrucciones de operación). 2. Dibuje una línea en la pared desde el techo hasta el borde inferior de la campana en el centro de la ubicación donde se montará la campana. 3. Use la p ...

  • Thermador HMCN36FS - page 27

    27 INST ALACIÓN 1. 2. 1. 2. 3. 0 9. Empalmar el tubo de evacuación del aire en la campana extractora. 10. Conectar el aparato a la red eléctrica. 11. Retirar la lámina protectora de los r evestimientos laterales de la chimenea.  ¡Prestar atención a no dañar la superficie sensible de acero inoxidable de los revestimientos! Atención: La c ...

  • Thermador HMCN36FS - page 28

    28 INST ALACIÓN 15. Montar el filtro antigrasa (véanse al r especto las instrucciones de uso de la campana extractora). Si el sistema de ventilación no funciona correctamente durante cualquiera de los procedimientos mencionados, r evise todos los pasos de la sección Instrucciones de instalación para asegurarse de no haber omitido ni pasado po ...

  • Thermador HMCN36FS - page 29

    29 Notes ...

  • Thermador HMCN36FS - page 30

    30 Notes ...

  • Thermador HMCN36FS - page 31

    31 Noticias ...

  • Thermador HMCN36FS - page 32

    9000 333 896 Printed in Germany 0208 Es. 5551 McFadden Avenue, Huntington Beach, CA 92649 • 1-800-735-4328 • www .thermador .com 9000333896 • 10013 Rev B • 02/08 © BSH Home Appliances Corporation • Litho U.S.A. ...

Manufacturer Thermador Category Ventilation Hood

Documents that we receive from a manufacturer of a Thermador HMCN36FS can be divided into several groups. They are, among others:
- Thermador technical drawings
- HMCN36FS manuals
- Thermador product data sheets
- information booklets
- or energy labels Thermador HMCN36FS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Thermador HMCN36FS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Thermador HMCN36FS, service manual, brief instructions and user manuals Thermador HMCN36FS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Thermador HMCN36FS.

Similar manuals

A complete manual for the device Thermador HMCN36FS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Thermador HMCN36FS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Thermador HMCN36FS.

A complete Thermador manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Thermador HMCN36FS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Thermador HMCN36FS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Thermador HMCN36FS, that we can find in the current document
3. Tips how to use the basic functions of the device Thermador HMCN36FS - which should help us in our first steps of using Thermador HMCN36FS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Thermador HMCN36FS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Thermador HMCN36FS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Thermador HMCN36FS?

Use the form below

If you did not solve your problem by using a manual Thermador HMCN36FS, ask a question using the form below. If a user had a similar problem with Thermador HMCN36FS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)