Manual ABC Office 4300

12 pages 0.42 mb
Download

Go to site of 12

Summary
  • ABC Office 4300 - page 1

    OPER AT ING INSTRUCTIONS FINISHER 4300 Model No. BA-FS43 Banner American Products, Inc. abcoffice 800-658-8788 www.abcoffice.com ...

  • ABC Office 4300 - page 2

    Table of Contents I. For Your Safety ............................................... 2 II. Electrical Safeguards ....................................... 2-3 III. Specifications .................................................. 3 IV. Set-up .............................................................. 3-5 Inspection ............................... ...

  • ABC Office 4300 - page 3

    Finisher 4300 (BA-FS43) SPEED CONTROL TOP BOTTOM TEMPERATURE CONTROL BOTTOM HEAT SHOE TEMPERATURE CONTROL TOP HEAT SHOE 1 0 1 0 FORWARD REVERSE FANS MOTOR HEAT HEATED ROLLERS Control Panel Brake Nut Core Gripper Mandrel 1 0 1 0 STANDARD LAMINATING MOUNTING CLOSED OPEN CLOSED OPEN STANDARD LAMINATING MOUNTING Left Side Cover Right Side Cover STANDAR ...

  • ABC Office 4300 - page 4

    u Do not connect the laminator to electrical power or attempt to operate it until you have read these instructions completely. Keep these instructions in a convenient location for future reference. u Read all safety messages located in this instruction manual and on the laminator very care- fully. u Always replace safety shield before operating you ...

  • ABC Office 4300 - page 5

    u Do not operate the laminator with a damaged power supply cord or plug. u Replace fuses only with same type rated 30A, 240V and 1A, 250V fuses. Contact your dealer for replacement fuses. u There are four (4) EMERGENCY STOP buttons on your Finisher 4300, two in the front and two in the back. Depressing any one of these buttons will stop the rollers ...

  • ABC Office 4300 - page 6

    Threading the Film (Figures 1&2) 1. Feed the film from the top roll behind the upper idler roller rod and lay it over both heat shoes. Be sure that the adhesive side of the film is facing out and the non-adhesive side is against the heat shoes. 2. To thread the lower roll, first remove the two red knobs on each side of the idler slide mechanism ...

  • ABC Office 4300 - page 7

    Slitters (Figure 4) : To install the slitters, place the Main Body Clamps into the Top Roller Guard where they will slide into the slots in the in the top edge of the guard located at each end of the guard. Before setting the slitters in place, ensure the machine is loaded with the proper laminating film. Use a piece of paper/card stock the same wi ...

  • ABC Office 4300 - page 8

    VI. Pressure Sensitive Laminating... Note: You must have the Rewind Option for Pressure Sensitive Films in order to laminate with pressure sensitive material. 1. Load a roll of pressure sensitive film onto the upper mandrel so that it unwinds toward you from the bottom of the roll. 2. Load an empty film core on the take-up mandrel and place it in p ...

  • ABC Office 4300 - page 9

    VIII. Mounting & Laminating... 1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminat- ing film is loaded correctly (See page 3 for film loading instructions). 2. Open the ROLLER RELEASE handle and select the MOUNT position on both sides of your laminator. Close the rollers. 3. Turn t ...

  • ABC Office 4300 - page 10

    Cleaning Rubber Rollers: Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement. Use the following procedure to remove any adhesive from the laminating rollers. 1. Turn the HEATED ROLLERS and TOP & BOTTOM SHOES OFF and allow the laminator to cool . 2. Cut the film where it comes off the top and ...

  • ABC Office 4300 - page 11

    X. Trouble-shooting... Symptom Possible Cause Corrective Action LCDs do not show display No power to laminator Close panel breaker when heat switches are on. Blown fuse Disconnect power and replace fuse Film is not bonding to the print Laminator not set to optimal Adjust temperature slightly laminating temperature upward. Ink on print is wet Allow ...

  • ABC Office 4300 - page 12

    XI. Laminating & Mounting Do’s and Don’ts... Read the instruction manual before operating your laminator. Always run test samples before laminating valuable items. Feed the print through slowly and evenly, smoothing it as it is pulled into the laminator. Operate the laminator with two rolls of the same width laminating film to avoid excessi ...

Manufacturer ABC Office Category Laminator

Documents that we receive from a manufacturer of a ABC Office 4300 can be divided into several groups. They are, among others:
- ABC Office technical drawings
- 4300 manuals
- ABC Office product data sheets
- information booklets
- or energy labels ABC Office 4300
All of them are important, but the most important information from the point of view of use of the device are in the user manual ABC Office 4300.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals ABC Office 4300, service manual, brief instructions and user manuals ABC Office 4300. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product ABC Office 4300.

Similar manuals

A complete manual for the device ABC Office 4300, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use ABC Office 4300 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of ABC Office 4300.

A complete ABC Office manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual ABC Office 4300 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the ABC Office 4300, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the ABC Office 4300, that we can find in the current document
3. Tips how to use the basic functions of the device ABC Office 4300 - which should help us in our first steps of using ABC Office 4300
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with ABC Office 4300
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of ABC Office 4300 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning ABC Office 4300?

Use the form below

If you did not solve your problem by using a manual ABC Office 4300, ask a question using the form below. If a user had a similar problem with ABC Office 4300 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)