Manual Ubiquiti Networks UVC-3

24 pages Not applicable
Download

Go to site of 24

Summary
  • Ubiquiti Networks UVC-3 - page 1

    720p Indoor/Outdoor IP Camera with Infrared Model: UVC ...

  • Ubiquiti Networks UVC-3 - page 2

    Introduction Thank you for purchasing the Ubiquiti Netw orks ™ UniFi® Video Camera. This Quick Start Guide is designed to guide you through the installation of the UniFi Video Camera and show you how to access the Camer a Configuration Interface. This Quick Start Guide also includes the warranty terms. The UniFi Video software and User Guide are ...

  • Ubiquiti Networks UVC-3 - page 3

    Hardware Overview Side View Adjusts Camera Up or Down Rotates Camera Rotates Base Sun Shade Bottom View 24V 0.5A POE M/N: UVC Video Camera Port Cover microSD Card Slot Ethernet Port Ethernet Seal LEDs LEDs Ethernet The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity. Pow er The Power ...

  • Ubiquiti Networks UVC-3 - page 4

    Before Y ou Begin A few notes about the camera befor e you begin installation: • If you wish to use the sun shade, it is easier to engage bef ore you install the camera. • The camera has an adjustable base, tilt, and camer a rotation. • The camera should never be pointing straight up or straight down. Always ensure it is at least two clicks f ...

  • Ubiquiti Networks UVC-3 - page 5

    Sun Shade If you want to use the Sun Shade , press the Sun Shade Lock and Release T ab from behind the camera and slide the Sun Shade forward until it locks into place. Sun Shade Sun Shade Lock and Release T ab ...

  • Ubiquiti Networks UVC-3 - page 6

    *640-00069-04* 640-00069-04 Installation Overview The installation process differs depending on if you ar e mounting the camera on a pole or on a wall. Follo w the instructions for the installation that you are performing. Below is an overview of the steps: • Connect one end of the Ethernet cable to the camera. • Insert a microSD card (optional ...

  • Ubiquiti Networks UVC-3 - page 7

    3. Connect an Ethernet cable to the Ethernet port on the camera. 24V 0.5A POE M/N: UVC Video Camera 4. Remove the Ethernet Seal from the Port Cov er . 5. Slide the Port Cover back onto the camera near the Ethernet port and snap it in place. 6. Wrap the Ethernet Seal around the Ethernet cable and press it into the Port Cover . ...

  • Ubiquiti Networks UVC-3 - page 8

    W all Mount 1. Remove the adhesive Mounting T emplate from the back ing and place the label on the wall where you want the camera. 2. Use a 7 mm drill bit to drill the holes in the wall. 3. Insert the four Screw Anchors into the wall. 4. Use a Phillips screwdriver t o secure the camera to the wall with the four Screws . Proceed to Connecting P ower ...

  • Ubiquiti Networks UVC-3 - page 9

    Pole Mount T o mount the UniF i Video Camera on a pole, use the included Metal Strap : 1. Open the Metal Strap by turning the locking screw counter-clockwise. 2. Slide the Metal Strap through the base of the camera. 3. Wrap the Metal Strap around the pole . Use a screwdriver or 7 mm socket drive to turn the locking screw clockwise and securely fast ...

  • Ubiquiti Networks UVC-3 - page 10

    Connecting Po wer over E thernet 1. Connect the other end of the Ethernet cable to one of the following: • PoE Adapter Connect the UniFi Video Camera to the Ethernet port labeled POE on the included PoE Adapter . • EdgeSwitch (shown below) or TOUGHS witch Connect the UniFi Video Camera to a port with 24V power enabled and skip steps 2 and 3. ...

  • Ubiquiti Networks UVC-3 - page 11

    2. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter . 3. Connect the power cord to the pow er port on the PoE Adapter . Connect the other end of the power cord t o a power outlet. ...

  • Ubiquiti Networks UVC-3 - page 12

    UniFi Video The UniFI Video software is pre-installed on the UniFi NVR (sold separately). If you do not have the UniF i NVR, you can download and install the latest version of the UniF i Video software at downloads.ubnt.com/unifivideo ; the UniF i Video auto-management feature should automatically detect and install your new camera(s). Proceed to A ...

  • Ubiquiti Networks UVC-3 - page 13

    Camera Configur ation Interface Access the Camera C onfiguration Interface if you have not yet installed the UniFi Video software, or plan t o use the UniFi Video Camera as a stand-alone camera without the UniFi Video software. 1. Ensure that your host machine is connected to the same LAN as the UniFi Video Camera. 2. The UniFi Video Camera is set ...

  • Ubiquiti Networks UVC-3 - page 14

    5. The Main screen will appear and you should see a live video stream from the UniFi Video Camera. Adjusting the Camera View Adjust Camera Up or Down Rotate Camera Rotate Base Note: Remove the protective plastic film from the camera lens and IR LEDs. For details on using the UniF i Video software, refer to the U ser Guide at: documentation.ubnt.com ...

  • Ubiquiti Networks UVC-3 - page 15

    Specifications UniFi Video Camera Dimensions 225 x 75 x 75 mm (8.85 x 2.95 x 2.95") Weight 373 g (13.1 oz) Ports (1) 10/100 Ethernet Port, microSD Card Slot Sensor Progressive Scan RGB CMOS ¼" Lens 3.6 mm/ F1.8 Power LED Amber Link/Activity LED Green Buttons Factory Reset Button Power Method Passive P ower over Ethernet (12-24V) Power Su ...

  • Ubiquiti Networks UVC-3 - page 16

    Safety Notices 1. Read, follow , and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer . W ARNING: Do not use this product in location that can be submerged by water . W ARNING: A void using this product during an electrical storm. There may be a remote risk of electric shock from light ...

  • Ubiquiti Networks UVC-3 - page 17

    Limited W arranty UBIQUITI NETWORKS, Inc (“UBIQUITI NET WORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation. UBIQUITI NETWORKS’ sole and exclusive obligat ...

  • Ubiquiti Networks UVC-3 - page 18

    Disclaimer EXCEPT FOR ANY EXPRESS W ARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND IT S AND THEIR THIRD P ARTY DA T A, SERVICE, SOFTWARE AND HARDW ARE PROVIDERS HEREBY DISCLAIM AND MAKE NO OTHER REPRESENT ATION OR W ARR ANTY OF ANY KIND, EXPRESS, IMPLIED OR ST A TUTORY , INCL UDING, BUT NO T LIMITED TO , REPRESENT A TIONS, GUARAN ...

  • Ubiquiti Networks UVC-3 - page 19

    Note Some countries, states and provinces do not allo w exclusions of implied warranties or conditions, so the abov e exclusion may not apply to you . Y ou may hav e other rights that vary from country to country, state to state, or province t o province. Some countries , states and provinces do not allow the exclusion or limitation of liability fo ...

  • Ubiquiti Networks UVC-3 - page 20

    Industry Canada This Class A digital apparatus complies with Canadian CAN ICES-3(B). T o reduce potential radio interference to other users , the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r .p .) is not more than that permitted for successful communication. This device complies with Industry ...

  • Ubiquiti Networks UVC-3 - page 21

    RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dis ...

  • Ubiquiti Networks UVC-3 - page 22

    Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación. Es responsabil ...

  • Ubiquiti Networks UVC-3 - page 23

    Declaration of Conformity Česky [Czech] UBIQUITI NET WORKS tímto prohla uje, e tent o UBIQUITI NET WORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NET WORKS erklærer herved, at følgende udstyr UBIQUITI NET WORKS device, overholder de væsentlige kr ...

  • Ubiquiti Networks UVC-3 - page 24

    Lietuviškai [Lithuanian] UBIQUITI NET WORKS deklaruoja, kad šis UBIQUITI NET WORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas. Malti [Maltese] Hawnhekk, UBIQUITI NET WORKS, jiddikjara li dan UBIQUITI NET WORKS device, jikkonforma mal- ti ijiet essenzjali u ma provvedimenti o rajn relevanti li hemm fid-Dirret ...

Manufacturer Ubiquiti Networks Category Security camera

Documents that we receive from a manufacturer of a Ubiquiti Networks UVC-3 can be divided into several groups. They are, among others:
- Ubiquiti Networks technical drawings
- UVC-3 manuals
- Ubiquiti Networks product data sheets
- information booklets
- or energy labels Ubiquiti Networks UVC-3
All of them are important, but the most important information from the point of view of use of the device are in the user manual Ubiquiti Networks UVC-3.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Ubiquiti Networks UVC-3, service manual, brief instructions and user manuals Ubiquiti Networks UVC-3. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Ubiquiti Networks UVC-3.

A complete manual for the device Ubiquiti Networks UVC-3, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Ubiquiti Networks UVC-3 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Ubiquiti Networks UVC-3.

A complete Ubiquiti Networks manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Ubiquiti Networks UVC-3 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Ubiquiti Networks UVC-3, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Ubiquiti Networks UVC-3, that we can find in the current document
3. Tips how to use the basic functions of the device Ubiquiti Networks UVC-3 - which should help us in our first steps of using Ubiquiti Networks UVC-3
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Ubiquiti Networks UVC-3
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Ubiquiti Networks UVC-3 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Ubiquiti Networks UVC-3?

Use the form below

If you did not solve your problem by using a manual Ubiquiti Networks UVC-3, ask a question using the form below. If a user had a similar problem with Ubiquiti Networks UVC-3 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)