English dropdown-ico

Manual KitchenAid 3182048

24 pages 2.02 mb
Download

Go to site of 24

Summary
  • KitchenAid 3182048 - page 1

    HOME APPLIANCES Installation Instructions Create-a-Cooktop I D I I Part No. 3182048 Rev. E Important: IMPORTANT: Read and save these instructions. Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. Write ...

  • KitchenAid 3182048 - page 2

    Minimum cabinet width above one appliance: cooktops - 12” Grill - 14” IMPORTANT: Observe all governing codes and ordinances. Downdraft vent - 6” For each additional appliance combined with the first appliance, add the minimum cabinet width for that appliance. LElectric - I” min. Gas - 1’ min to backsplash or vertical wall ’ I See Note* ...

  • KitchenAid 3182048 - page 3

    Before vou start... Proper installation iz your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the bottom of cooktops and grills and on the ri ...

  • KitchenAid 3182048 - page 4

    Product/cutout Dimensions Single Installations - One product per cutout Electric and Gas cooktops Electric Grill lf-1345/16” -4 WARNING: To reduce the risk of fire, electric shock and injury to persons, the downdraft vent system must be installed with either the KitchenAid Model KPED890T exterior mounted motor unit or the KitchenAid Model KPID850 ...

  • KitchenAid 3182048 - page 5

    Combinations - When installing cooktops, grills and downdraft vents in the same cutout, use the following width dimensions: Combination 2 cooktops 3 cook-tops 4 cooktops 1 cook-top and 2 cooktops and 3 cooktops and 1 downdraft vent 1 downdraft vent 2 downdraft vents Cutout Width 23’ min. 35’ min. 47” min. 16-7/a’ min. 29” min. 47’ min. ...

  • KitchenAid 3182048 - page 6

    Tools/Parts Electric Cooktop and Grill Tools and materials needed for installation: Electric cooktops and grills pipejoint compound Downdraft vents l Phillips screwdriver l metal snips l wire stripper or utility knife l duct tape l caulking gun l measurmg tape/ruler l flat-blade screwdriver or 7/16” nut driver l pencil l power supply cable l sabe ...

  • KitchenAid 3182048 - page 7

    Electrical connection This appliance is manufactured with a frame- connected, green or bare, ground wire. Connect the appliance cable to the junction box through the U.L.-listed conduit connector. Complete electrical connection according to local codes and ordinances. Electrical Shock Hazard Turn power supply off before connecting wires. Electrical ...

  • KitchenAid 3182048 - page 8

    Electric Cooktop and Grill (cont.) Now start... With cooktop and/or grill in kitchen. If installing more than one appliance in the same cutout, work with one appliance at a time. Start with the appliance that will be to the left side of the cutout. Make all adjustments: then follow steps to add adjacent appliances. q 1 Remove the shipping materials ...

  • KitchenAid 3182048 - page 9

    Do Not overtighten screws. glass cooktop countertop El 5/16” clamping 7 bracket screw . One cooktop or grill in cutout: Rotate the mounting brackets away from the burner box. Tighten the mounting brackets to the burner box. Insert the 2-l/2” clamping screws into the mounting brackets. Use a screwdriver to tighten the screws against the undersid ...

  • KitchenAid 3182048 - page 10

    Downdraft Vent Electrical requirements WARNING: To reduce the risk of fire, electric shock and injury to persons, the downdraft vent system must be installed with either the KitchenAid Model KPED890T exterior mounted motor unit or the KitchenAid Model KPID850T interior mounted motor unit. These units are marked to indicate their suitability with th ...

  • KitchenAid 3182048 - page 11

    Venting requirements Ductwork needed for installation is not supplied. Wall cap is provided with interior mounted motor. I Fire Hazard Venting system MUST terminate to the outside. Do Not terminate the ductwork in an attic or other enclosed space. Do Not use 4-inch laundry-type wall caps. Do Not use plastic-type ductwork. Use only metal ductwork. F ...

  • KitchenAid 3182048 - page 12

    Downdraft Vent (cont.) Exterior mounted vent motor installation methods To install ductwork under a concrete slab, see Insert Sheet. Do not install exterior vent motor in a window well. Island location Figure 5 Interior wall location Figure 6 Roof venting Figure 7 One exterior power vent motor can be used to operate two downdraft vent systems. The ...

  • KitchenAid 3182048 - page 13

    Now start . n n n El 1 Place cardboard or other form of . protection on top of a flat surface where you can easily assemble the downdraft vent system. Remove downdraft blower box and motor section from cartons. Remove any shipping materials, tape and protective film from downdraft blower box and motor. Remove parts package from inside blower box op ...

  • KitchenAid 3182048 - page 14

    Downdraft Vent /cont.) If downdraft vent is installed next to another appliance in the same cutout, go to Step 11. If downdraft vent will be installed in a separate cutout (no other appliances in same cutout), remove the motor from the blower box. Carefully insert the blower box into the countertop cutout. Lift motor up and place on blower box. Con ...

  • KitchenAid 3182048 - page 15

    other brown wire to the other capacitor terminal. Replace the rubber cap over the top of the capacitor. Put the capacitor into the mounting bracket on the lower section of the wiring box. the front of the blower box under the control using the four screws removed in Step 3. If the vent is installed in the cutout, it may have to be lifted out of the ...

  • KitchenAid 3182048 - page 16

    Downdraft Vent (cont.) Exterior roof-mounted system requires Roof Mount Kit, Part No. 4173296. 11.1 Place cardboard or other form of protection on top of a flat surface where you can easily assemble the downdraft vent system. Remove downdraft blower box and motor sections from cartons. Remove any shipping materials, tape and protective film from do ...

  • KitchenAid 3182048 - page 17

    Position the downdraft vent cover so that it is aligned with light pencil marks made on the countertop in Step 6. Use screws to attach legs to cabinet floor. Check that blower box is vertical. (Adjust legs until blower box is vertical.) Tighten screws that attach the legs to the blower box. Determine the location where the exterior blower assembly ...

  • KitchenAid 3182048 - page 18

    Downdraft Vent (cont.) green ground Power supply wiring is not provided. ‘;r !/I lfT3ire Aconnector Thread the power supply cable through the conduit connector. Tighten the screws on the conduit connector. Disconnect power supply. Connect the two white wires together with twist- on wire connector. Connect the black wire from the power supply cab ...

  • KitchenAid 3182048 - page 19

    Sealed Gas Cooktop Gas supply requirements Explosion Hazard Use a new AGA approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed water column rating specified in LP conversion kit. Examples of a qualified person include licensed hea ...

  • KitchenAid 3182048 - page 20

    Sealed Gas Cooktop (cont.) Electrical requirements Electrical Shock Hazard Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in death, fire, or electrical shock. If codes permit and a separate ground wire is used, it is recommended that a qualified electrician det ...

  • KitchenAid 3182048 - page 21

    To avoid scratching countertop, lift entire cooktop up from cutout when repositioning cooktop into countertop opening. 13.) I I Insert the cooktop into the countertop opening. Check that the front of the cooktop is parallel to the front edge of the countertop. Check that all required clearances are met. Use a pencil to mark a line along the rear of ...

  • KitchenAid 3182048 - page 22

    Sealed Gas Cooktop (cont.) Multiple cooktops and/or grill combinations: Rotate the left mounting bracket away from the burner box of the first appliance. Tighten the mounting bracket to the burner box. Insert the 2-l/2” clamping screw into the mounting bracket. Use a screwdriver to tighten the screw against the underside of the countertop. Rotate ...

  • KitchenAid 3182048 - page 23

    . Plug the power supply cord into-the grounded outlet. I I 115.1 t I Place burner grates over burners and caps. Install control knobs on valve stems. Electronic Ignition System - initial lighting Cooktop burners use electronic ignitors in place of standing pilots. When the cooktop control knob is turned to the “HI” position, the system creates ...

  • KitchenAid 3182048 - page 24

    W iring diagram (WNHT, BkK) (GEN) II L-h I I I I I / , (RED) wHT) (RED (BLK) I (BLK) - 0 - n GAS VALVE GAS VALVE FRONT REAR Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. If the cooktop, grill or downdraft vent does not oper ...

Manufacturer KitchenAid Category Cooktop

Documents that we receive from a manufacturer of a KitchenAid 3182048 can be divided into several groups. They are, among others:
- KitchenAid technical drawings
- 3182048 manuals
- KitchenAid product data sheets
- information booklets
- or energy labels KitchenAid 3182048
All of them are important, but the most important information from the point of view of use of the device are in the user manual KitchenAid 3182048.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals KitchenAid 3182048, service manual, brief instructions and user manuals KitchenAid 3182048. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product KitchenAid 3182048.

Similar manuals

A complete manual for the device KitchenAid 3182048, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use KitchenAid 3182048 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of KitchenAid 3182048.

A complete KitchenAid manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual KitchenAid 3182048 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the KitchenAid 3182048, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the KitchenAid 3182048, that we can find in the current document
3. Tips how to use the basic functions of the device KitchenAid 3182048 - which should help us in our first steps of using KitchenAid 3182048
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with KitchenAid 3182048
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of KitchenAid 3182048 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning KitchenAid 3182048?

Use the form below

If you did not solve your problem by using a manual KitchenAid 3182048, ask a question using the form below. If a user had a similar problem with KitchenAid 3182048 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)