English dropdown-ico

Manual Texas Instruments SLUU477

13 pages 0.21 mb
Download

Go to site of 13

Summary
  • Texas Instruments SLUU477 - page 1

    User's Guide SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path This user's guide describes the features and operation of the bq24210EVM Evaluation Module (EVM). The EVM assists users in evaluating the bq24210 solar chager. The EVM is also called the HPA678. The manual includes the bq24 ...

  • Texas Instruments SLUU477 - page 2

    Introduction www.ti.com 1 Introduction 1.1 EVM Features • Evaluation Module for bq24210 • 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path • Resistor-programmable setting for charge current and input voltage dynamic power management • LED Indication for Status • Test Points for Key Signals Available for Testin ...

  • Texas Instruments SLUU477 - page 3

    ( ) D PM D PM _ 1 VD PM D PM VBU S_ VBUS _ R = K VBUS_ - I SE T I SET O U T K R = I www.ti.com Introduction 1.4 Control and Key Parameters Setting Table 2. Control and Key Parameters Setting Jack Description Factory Setting JP1 Programs the fast-charge current setting. 500mA when JP1 ON; external setting Jumper OFF (external setting) when JP1 OFF J ...

  • Texas Instruments SLUU477 - page 4

    Test Summary www.ti.com 2 Test Summary 2.1 Definitions This procedure details how to configure the HPA678 evaluation board. On the test procedure, the following naming conventions are followed. VXXX : External voltage supply name (VBUS, VBAT) LOADW: External load name (LOADR, LOADI) V(TPyyy): Voltage at internal test point (TPyyy). For example, V(T ...

  • Texas Instruments SLUU477 - page 5

    BQ24210 EVM HP A678 GND J1 VBUS J2 GND BA T APPLICATION CIRCUIT U1 V Iin I Power supply #1 IBAT V Load #1 I TS PG JP1 D1 LED CHG D2 J4 JP4 JP5 JP7 JP6 JP2 J3 JP3 www.ti.com Test Summary 2.5 Equipment 2.5.1 Power Supplies Power Supply #1 (PS#1): a power supply capable of supplying 20-V at 1-A is required. 2.5.2 Loads LOAD #1 A 20V (or above), 1A (or ...

  • Texas Instruments SLUU477 - page 6

    PCB Layout Guideline www.ti.com 2.7 Procedure 2.7.1 Power Supply Make sure EQUIPMENT SETUP steps are followed. Disconnect LOAD #1. Turn on PS#1. Measure → V(J1(VBUS)) = 6.5V ± 200mV Measure → V(J2(VBAT)) = 0V ± 200mV Measure → V(J4(VTSB)) = 0V ± 200mV Observe → D1 (PG) ON, D2 (CHG) OFF 2.7.2 Charger Enable and Battery Detection Connect J ...

  • Texas Instruments SLUU477 - page 7

    www.ti.com Bill of Materials, Board Layout and Schematics 4 Bill of Materials, Board Layout and Schematics 4.1 Bill of Materials Table 4. Bill of Materials -001 RefDes Value Description SIZE Part Number MFR 1 C1 10 µ F Capacitor, Ceramic, 25V,X7R, 10% 1206 STD STD 2 C2, C4 0.1 µF Capacitor, Ceramic, 25V, X7R, 10% 0603 STD STD 1 C3 10 µF Capacito ...

  • Texas Instruments SLUU477 - page 8

    Bill of Materials, Board Layout and Schematics www.ti.com 4.2 Board Layout Figure 2. Top Assembly 8 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path SLUU477 – December 2010 Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 9

    www.ti.com Bill of Materials, Board Layout and Schematics Figure 3. Top Layer 9 SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 10

    Bill of Materials, Board Layout and Schematics www.ti.com Figure 4. Bottom Layer 10 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path SLUU477 – December 2010 Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 11

    www.ti.com Bill of Materials, Board Layout and Schematics 4.3 Schematics Figure 5. bq24210 EVM Schematic 11 SLUU477 – December 2010 800mA, Single-Input, Single Cell Li-Ion Battery Solar Charger with Power Path Submit Documentation Feedback © 2010, Texas Instruments Incorporated ...

  • Texas Instruments SLUU477 - page 12

    Evaluation Board/Kit Important Notice Texas Instruments (TI) provides the enclosed product(s) under the following conditions: This evaluation board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by TI to be a finished end-product fit for general consumer use. Persons handling th ...

  • Texas Instruments SLUU477 - page 13

    IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the latest relevant information before placing orders ...

Manufacturer Texas Instruments Category Automobile Battery Charger

Documents that we receive from a manufacturer of a Texas Instruments SLUU477 can be divided into several groups. They are, among others:
- Texas Instruments technical drawings
- SLUU477 manuals
- Texas Instruments product data sheets
- information booklets
- or energy labels Texas Instruments SLUU477
All of them are important, but the most important information from the point of view of use of the device are in the user manual Texas Instruments SLUU477.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Texas Instruments SLUU477, service manual, brief instructions and user manuals Texas Instruments SLUU477. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Texas Instruments SLUU477.

Similar manuals

A complete manual for the device Texas Instruments SLUU477, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Texas Instruments SLUU477 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Texas Instruments SLUU477.

A complete Texas Instruments manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Texas Instruments SLUU477 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Texas Instruments SLUU477, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Texas Instruments SLUU477, that we can find in the current document
3. Tips how to use the basic functions of the device Texas Instruments SLUU477 - which should help us in our first steps of using Texas Instruments SLUU477
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Texas Instruments SLUU477
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Texas Instruments SLUU477 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Texas Instruments SLUU477?

Use the form below

If you did not solve your problem by using a manual Texas Instruments SLUU477, ask a question using the form below. If a user had a similar problem with Texas Instruments SLUU477 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Jim

Hello, my name is James and I was just looking your website usermanuals.org over and thought I would message you on your contact form and offer some help. I really like your site but I noticed you weren’t getting a lot of traffic and your Alexa ranking isn’t as strong as it could be. Fortunately, I may have an answer for you. I can get you 1,000’s of visitors looking at usermanuals.org ready to buy your product, service or sign up for an offer and fast. Our advertising network of over 9000 websites provides a low cost and effective online marketing solutions that actually works. I can help your business get more online quality traffic by advertising your business on websites that are targeted to your specific market. The Internet is vast but you don’t have to spend huge amounts of cash to jump start your business. I can get you 10,000 highly targeted visitors directly to your website for as little as $39.00 for a 30 day trial run. https://worldtrafficsolutions.xyz It has taken us 12 years to perfect our system and in addition to being exciting, it works!! We also have a special offer of 200,000 Targeted visitors spread over 60 days for a special one time charge of $299.00. https://worldtrafficsolutions.xyz Also check out the short video here and see how everything works. Best Regards support@worldtrafficsolutions.xyz WorldTrafficSolutions.xyz https://worldtrafficsolutions.xyz To be placed on our removal list please visit: https://zfrmz.com/vTN2gJq4qHlWtaZ1YFQO