Manual Fisher LNS-W31A

18 pages 1.11 mb
Download

Go to site of 18

Summary
  • Fisher LNS-W31A - page 1

    F ollowing chec ks and confir mations should be tak en f or saf ety . Check the f ollo wing things by the time of the cabinet assemb ly after the lens replacement. 1. Check the lens is securely fix ed. 2. Check the proper wiring and the wires are fix ed properly . 3. Check each connector is connected properly . 4. Check no wiring is tangled on the ...

  • Fisher LNS-W31A - page 2

    Fig-1 Fig-2 Fig-3 Fig-4 SCREW "A" Remov e 2 scre ws-A. Press the button (or remo v e 2 screws-B) on the low er of the lens cov er and remov e the lens cov er . Remov e the light-b lock sheet from the light- bloc k sheet base. LENS REPLA CEMENT PR OCEDURE (FOR "A" TYPE ) REMO VE THE LENS CO VER AND LIGHT - BLOCK SHEET (See Figure ...

  • Fisher LNS-W31A - page 3

    Fig-6 Fig-7 Fig-8 3 REMO VE THE LENS (See Figure-5 and 6) Remov e the connector "K16J" of the circuit board. Remov e the lens motor lead from lead holder . Remov e screws-C (4 scre ws) which f astens the lens and remov e the lens. Use the driv er (3 mm, Green) included with the lens to remov e the screws . 1 . 2. DRIVER IN THE LENS LENS M ...

  • Fisher LNS-W31A - page 4

    T urn the lens cov er to counter-clockwise and pull it tow ard front and remov e the Lens Cov er . Remov e 2 Scre ws-A. Remov e the front cabinet REMO VE THE LENS CO VER AND FRONT CABINET 1 1. 2. 2 REMO VE THE LIGHT -BLOCK SHEET BASE AND LIGHT -BLOCK SHEET (See Figure-2) P erf orm the steps to f or lens replacement. 1 6 First set the lens at the fu ...

  • Fisher LNS-W31A - page 5

    4 MOUNT THE LENS (See Figure-5) Remov e protectiv e caps (front and back) on the lens. Mount the lens on lens mounting brac ket with Upper 2 screws . (locate motor on left side). Use the driver (4 mm, Y ellow) included with the lens to f asten the screws . Remov e the low er 2 screws on the Lens . (Lower 2 screws are not used.) Slide the lens lock ...

  • Fisher LNS-W31A - page 6

    5 MOUNT THE LIGHT -BLOCK SHEET AND LIGHT -BLOCK SHEET BASE (See Figure-6) 6 MOUNT THE FRONT CABINET AND LENS CO VER (See Figure-6 and 7) Mount the light-bloc k sheet on the lens as shown in the Figure-6. (In the same position as the remov ed sheet has been placed). Use the sheet included with the lens. Make sure the part no. and mark (T OP and BA C ...

  • Fisher LNS-W31A - page 7

    - 7 - T ur n the lens cov er to counter-clockwise and pull it tow ard front and remov e the Lens Cov er . Remov e 2 Screws-A. Remov e the front cabinet REMO VE THE LENS CO VER AND FRONT CABINET 1 1. 2. 2 REMO VE THE LIGHT -BLOCK SHEET BASE AND LIGHT -BLOCK SHEET P erf or m the steps to f or lens replacement. 1 6 First set the lens at the fully low ...

  • Fisher LNS-W31A - page 8

    - 8 - LENS ATTACHMENT Part No. (610 275 6029) 4 MOUNT THE LENS Remov e protectiv e caps (front and back) on the optional lens. Mount the lens on the lens attachment with 4 Screws . Connect the lens motor lead connector to the sock et on the lens attachment. (Motor Driven Lens only .) Grasp the Lens Loc k Lev er and turn it fully upward. Install the ...

  • Fisher LNS-W31A - page 9

    - 9 - UP 5 MOUNT THE LIGHT -BLOCK SHEET AND LIGHT -BLOCK SHEET BASE 6 MOUNT THE FRONT CABINET AND LENS CO VER Mount the light-bloc k sheet on the lens. (In the same position as the remov ed sheet has been placed). Use the sheet included with the lens. Make sure the mark (T OP and BA CK) on Light-Block Sheet and set them properly . Mount the light-b ...

  • Fisher LNS-W31A - page 10

    液晶プロジェクターレンズ 品番 LNS-T31A/W31A/T32 レンズ交換作業手順書 交換作業上の注意 レンズ交換はサ−ビス技術員が行ってください。 レンズ交換はこの作業手順書に従い、正しく行ってください。 レンズ交換のまえに、液晶プロジェクターの品番と交換レ? ...

  • Fisher LNS-W31A - page 11

    レンズ交換は スクリューA (2本)を外します。 レンズカバー下部のボタンを矢印の方向に押し、{モデルに よってはレンズカバー下部のスクリューB (2本)を外しま す。} レンズカバーを外します。 遮光プレートを遮光プレートベースより取り外します。 レンズ ...

  • Fisher LNS-W31A - page 12

    3 レンズを外す。 (図 5、6 参照) 基板のコネクター "K16J" を外します。 レンズモーターのリードを上部ホルダーより外します。 レンズを固定しているスクリューC(4本)を外し、レン ズを外します。 スクリューの取り外しは付属の専用ドラ イバ−(3 ...

  • Fisher LNS-W31A - page 13

    レンズ交換は レンズカバーを矢印の方向に回し手前に引っ張り、レンズカ バーを取り外します。 スクリューA (2本)を外します。 前面キャビネットを取り外します。 レンズ交換のしかた (B タイプへの取り付け) レンズカバー及び前面キャビネットを外す。 1 ...

  • Fisher LNS-W31A - page 14

    4 レンズを取り付ける。 (図 5 参照) 交換レンズに付いているレンズ保護キャップ(前後2箇所) を外します レンズをレンズマウントブラケットへレンズに付属のスク リュー(上側2本)で取り付けます。 (モーターを左側にし て取り付けます。 ) 下側の2? ...

  • Fisher LNS-W31A - page 15

    UP 図6 図7 5 6 遮光プレート及び遮光プレートベースを取り付 ける。 (図 6 参照) 交換レンズに同梱されている遮光プレートをレンズに通し ます。 遮光プレートには取り付け方向が表示されています。 THIS SIDE BACK を 後方に、 TOP を上側に取り付けます。 交換? ...

  • Fisher LNS-W31A - page 16

    - 7 - レンズ交換は レンズカバーを矢印の方向に回し手前に引っ張り、レンズカ バーを取り外します。 スクリューA (2本)を外します。 前面キャビネットを取り外します。 レンズカバー及び前面キャビネットを外します。 1 1. 2. 1 6 ∼ 2 の手順で行います。 遮光 ...

  • Fisher LNS-W31A - page 17

    - 8 - レンズに付属の ドライバー レンズアタッチメント 品番 (610 275 6029) レンズロックレバー タブをつまん で下げ る。 4 レンズを取り付けます。 交換レンズを 1. 2. 3. 4. ソケット レンズモーターリード レンズアタッチメント コネクター レンズロックレバー 交 ...

  • Fisher LNS-W31A - page 18

    - 9 - UP 5 6 遮光プレート及び遮光プレートベースを取り付 けます。 交換レンズに同梱されている遮光プレートをレンズに通し ます。 遮光プレートには取り付け方向が表示されています。 THIS SIDE BACK を 後方に、 TOP を上側に取り付けます。 交換レンズに同梱さ? ...

Manufacturer Fisher Category Projection Television

Documents that we receive from a manufacturer of a Fisher LNS-W31A can be divided into several groups. They are, among others:
- Fisher technical drawings
- LNS-W31A manuals
- Fisher product data sheets
- information booklets
- or energy labels Fisher LNS-W31A
All of them are important, but the most important information from the point of view of use of the device are in the user manual Fisher LNS-W31A.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Fisher LNS-W31A, service manual, brief instructions and user manuals Fisher LNS-W31A. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Fisher LNS-W31A.

Similar manuals

A complete manual for the device Fisher LNS-W31A, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Fisher LNS-W31A by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Fisher LNS-W31A.

A complete Fisher manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Fisher LNS-W31A - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Fisher LNS-W31A, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Fisher LNS-W31A, that we can find in the current document
3. Tips how to use the basic functions of the device Fisher LNS-W31A - which should help us in our first steps of using Fisher LNS-W31A
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Fisher LNS-W31A
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Fisher LNS-W31A in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Fisher LNS-W31A?

Use the form below

If you did not solve your problem by using a manual Fisher LNS-W31A, ask a question using the form below. If a user had a similar problem with Fisher LNS-W31A it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)