Manual Audiovox ACC-52

20 pages 0.62 mb
Download

Go to site of 20

Summary
  • Audiovox ACC-52 - page 1

    MODEL ACC-52 REMOTE-CONTROL 10-DISC CD CHANGER O WNER'S MANU AL AND INST ALLA TION GUIDE OPEN ...

  • Audiovox ACC-52 - page 2

    INTRODUCTION Congratulations on your purchase of this remote mount 10 Disc CD Changer. It allows you to easily upgrade your existing car stereo system to the quality of Compact Disc entertainment. The entire system plays through your FM Stereo car radio and stereo speaker system - there’s nothing else to add or replace. Best of all, the CD Change ...

  • Audiovox ACC-52 - page 3

    CD Magazine (P/N ACC-52MAZ) 1 pc. Index label sheet 1 pc. Owner's Manual and Installation Guide 1 pc. Self-tapping screw (M5 x 12) 4 pcs. Seals (A) 1 pc. 5 Meter Din Cable 1 pc. Hexagonal bolt with washer (M5 x 10) 7 pcs. INST ALLA TION P ARTS OTHER ACCESSORIES MAIN UNIT P ACKING LIST Changer Bracket (L) 1 pc. Bracket (R) 1 pc. Seals (B) 1 pc. ...

  • Audiovox ACC-52 - page 4

    Note If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation not to cause a short circuit. Do not install the unit in the following locat ...

  • Audiovox ACC-52 - page 5

    5 MOUNT ON FLOOR OF TRUNK (HORIZONTAL OR 45 DEGREES) MOUNT ON SIDEWALL OF CARGO AREA MOUNT ON BULKHEAD BEHIND SEAT OF PICKUP TRUCKS MOUNT ON BACKWALL OF HATCH AREA MOUNT ON SIDE OF TRUNK SIDEWALL TRUNK MOUNTING (SEDANS) This is usually the easiest location to use as there is ample space available. Check that you do not interfere with the removal of ...

  • Audiovox ACC-52 - page 6

    PROCEDURE FOR HORIZONT AL INST ALLA TION INST ALLA TION The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compen ...

  • Audiovox ACC-52 - page 7

    Hexagonal bolt with washer base (M5 x 10) Bracket (R) Bracket (L) 4 2 Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer base (M5 x 10). Mount the unit in place, using four self-tapping screws (M5 x 12). Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Set ...

  • Audiovox ACC-52 - page 8

    4 2 Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer base (M5 x 10). Mount the unit in place, using four self-tapping screws (M5 x 12). Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Set the left and right anti-vibration springs to position "45°&q ...

  • Audiovox ACC-52 - page 9

    9 NOTE: When routing wires and cables from the rear of the car to the dash- board, it is best to conceal the wires under carpeting. If you do not know how to do this, your local auto me- chanic or car stereo installer should be consulted. REMOTE CONTROL CABLE (4-1/2 FEET) CHANGER BLACK GROUND WIRE OVERALL WIRING VIEW This page is provided to give y ...

  • Audiovox ACC-52 - page 10

    10 WIRING THE FM MODULE The FM module should be positioned near your existing car stereo and the 15 foot data cable should be connected to it. Make the following connections to the FM module: 15 FOOT DATA CABLE "TO CD CHANGER" LABEL CAR FUSEBLOCK ORANGE w/WHITE STRIPE WIRE 15 FOOT EXTENSION LEAD (MAY NOT BE REQUIRED) SPLICE INTO "LIV ...

  • Audiovox ACC-52 - page 11

    CAR ANTENNA INPUT Locate your existing car radio antenna cable. This is normally a black cable about as thick as a pencil and will be plugged into a socket on the rear of your car radio. Unplug this antenna lead and plug it into the mating female socket on the FM module. IMPORTANT - Some Import cars have a special dual antenna called “DIVERSITY A ...

  • Audiovox ACC-52 - page 12

    12 MOUNTING THE REMOTE CONTROL On the back of the remote control you will find an adhesive backed “Velcro” pad. Select the desired mounting area on your car dashboard that will allow ease of use and full visibility of the LCD display. Peel off the protective paper on the adhesive pad. Make certain the dash area is clean of all wax, grease, etc. ...

  • Audiovox ACC-52 - page 13

    CONTROLS LCD Display Play/Pause ( / II) Power Off Switch (OFF) Disc Select ( + - ) Track Select ( ) Track Search ( ) Track/Disc Shuffle (SHFL) Track/Disc Repeat (RPT) Track/Disc Scan (SCN) Reset Button PREP ARING FOR OPERA TION 1. Load CD magazine bm and insert into changer as described on page 16. 2. Turn on your car ignition and your car stereo b ...

  • Audiovox ACC-52 - page 14

    USE OF CONTROLS pressing the Shuffle again, or by activating the Scan 9 or Repeat 8 functions. When the Shuffle button is pressed and held longer than 2 seconds, the SHFL and DISC indications will appear on the LCD panel and the discs in the magazine will be played in a random shuffled order, as well as the tracks on each disc. When all the tracks ...

  • Audiovox ACC-52 - page 15

    This CD Changer is designed to be operated only on 12 volt DC negative ground systems. The unit can not be used on 24 volt or positive ground systems. TEMPERATURE The unit may not operate correctly in extremely hot or cold temperatures. It is equipped with a built-in thermal protection ci rcuit which will stop operation of the unit when the tempera ...

  • Audiovox ACC-52 - page 16

    LOADING DISCS INTO THE MAGAZINE This CD Changer uses a specially-designed magazine to hold up to 10 compact discs. To load discs into the magazine, grip the tab on the magazine tray into which you will be loading a disc and pull it out gently as shown in Figure 1. Pull out only one tray at a time. Insert a disc into the tray with the label side up ...

  • Audiovox ACC-52 - page 17

    CD CHANGER OPERA TING INSTR UCTIONS This CD Changer is designed to operate through a compatible Audiovox car stereo which incorporates the controls and display functions or through the FM section of any car stereo. P l e a s e c h ec k w i th y o u r Audiovox stereo specialist for recommendations of the models that will work with this changer. The ...

  • Audiovox ACC-52 - page 18

    TROUBLESHOOTING An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility. No power Magazine cannot be installed CD is not played Noise, skipping, or intermittent sound during playback. Possible Cause Remedy ...

  • Audiovox ACC-52 - page 19

    AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product ...

  • Audiovox ACC-52 - page 20

    © 2001 Audiovox Electronics Corp., Hauppauge, NY 11788 Printed in China 128-6002 ...

Manufacturer Audiovox Category CD Player

Documents that we receive from a manufacturer of a Audiovox ACC-52 can be divided into several groups. They are, among others:
- Audiovox technical drawings
- ACC-52 manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox ACC-52
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox ACC-52.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox ACC-52, service manual, brief instructions and user manuals Audiovox ACC-52. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox ACC-52.

Similar manuals

A complete manual for the device Audiovox ACC-52, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox ACC-52 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox ACC-52.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox ACC-52 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox ACC-52, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox ACC-52, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox ACC-52 - which should help us in our first steps of using Audiovox ACC-52
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox ACC-52
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox ACC-52 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox ACC-52?

Use the form below

If you did not solve your problem by using a manual Audiovox ACC-52, ask a question using the form below. If a user had a similar problem with Audiovox ACC-52 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)