Manual Polycom A2400

30 pages 0.61 mb
Download

Go to site of 30

Summary
  • Polycom A2400 - page 1

    June 2008 Edition 1725-36080-001 Revision J VIEW Certified Configuration Guide Aruba Mobility Controllers A200, A800, A2400, A6000 ...

  • Polycom A2400 - page 2

    Configuration Guide PN: 1725-36080-001_J.doc 2 Trademark Information Polycom® and t he logo design s SpectraLink® LinkPlus Link NetLink SVP Are trademarks and registe red trademarks of Polycom, Inc. in the Un ited States of Am erica and various c ountries. All ot her trademarks used herein are the propert y of their respective owners. Patent Info ...

  • Polycom A2400 - page 3

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 3 Introduction Polycom’s Voice Interoperability for Enterprise Wireless (VIEW) Certification Program is designed to ensure interoperability and high performance between SpectraLink Wireless Telephones and WLAN infrastructure products. The pr oducts listed below have bee ...

  • Polycom A2400 - page 4

    Configuration Guide PN: 1725-36080-001_J.doc 4 Network Topology It is important to note that this configuration is not necessar ily applicable to all customer environments. The following topology was tested during VIEW Certification testing. Known Limitations No limitations were discovered during VIEW Certification testing. VIEW Certification testi ...

  • Polycom A2400 - page 5

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 5 Deployment Description It is a SpectraLink requirement that voice users be placed on a separate VLAN (e.g., VLAN 10) and data users on a separate VLAN (e.g., VLAN 25). The voice and data VLANs reside on the Aruba mobility controller and not on the acce ss points (APs). ...

  • Polycom A2400 - page 6

    Configuration Guide PN: 1725-36080-001_J.doc 6 Connecting to the Mobility Controller Command, comment, and screen text key In the sections below you will find commands, comments, prompts, system responses, or other screen-displayed information involved in the configuration process. This key explains the text styles and symbols used to denote them. ...

  • Polycom A2400 - page 7

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 7 Via the CLI By default, only SSH (Secure She ll) access to the switch (mobility controller) is permitted. 1. From a management system that has network connectivity to the switch, connect to the switch using SSH: ssh admin@< sw itch IP address > 2. Enter the admin ...

  • Polycom A2400 - page 8

    Configuration Guide PN: 1725-36080-001_J.doc 8 Initial Setup Before starting, please ensure that the Policy Enforcement Firewall module license is enabled on the Aruba mobility controller. Please contact Aruba Networks for licenses and installation information. On power-up, the user is presented with the startup wizard: Enter System na me [Aruba800 ...

  • Polycom A2400 - page 9

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 9 . . . . . <<<<< Welcome to Arub a Wireless Netw orks - Aruba 800 >>>>> . . . . (Aruba) User: ...

  • Polycom A2400 - page 10

    Configuration Guide PN: 1725-36080-001_J.doc 10 Assigning an IP to the Mobility Controller 1. Connect to the switch via the CLI. 2. Login with the configured username and password, admin/adm in in this example. 3. Type enable at the > prompt. 4. Type the enable password, enable in this example. 5. Type configure ter minal at the # prompt. 6. Cre ...

  • Polycom A2400 - page 11

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 11 Connecting APs Provisioning APs The APs need to be provisioned. The Aruba APs can be provisioned manually or be configured for automatic provisioning. For manual provisioning, use the Web-based AP provisioning Web page. Refer to the AP Provisioning User Guide for instr ...

  • Polycom A2400 - page 12

    Configuration Guide PN: 1725-36080-001_J.doc 12 SSID Configuration CLI command configuration APs can be configured using the CLI or the Web interface. Each AP is identified by a unique location code . The APs can either be configured per location with unique settings us ing the AP’s unique location code or globally using the wildcard location. ? ...

  • Polycom A2400 - page 13

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 13 Web-based configuration 1. Click the Configuration button. 2. In the navigation pane, select Net work from the WLAN sub-menu. 3. To edit an existing AP profile, click the Edit button corresponding to the SSID. 4. To add a new profile, click the Add button. 5. Under Add ...

  • Polycom A2400 - page 14

    Configuration Guide PN: 1725-36080-001_J.doc 14 Access Point Configuration Radio setting 802.11b or 802.11g When using the 802.11b/g band for the VoWiFi network, set the radio settings to 802.11b/g mixed mode. Preamble settings The tests on the Aruba system were run with the short prea mble setting. The short preamble setting can be used, as this s ...

  • Polycom A2400 - page 15

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 15 For additional details on RF deployment please see the Deploying Enterprise-Grade Wi-Fi Telephony white paper and the Best Practices Guide for Deploying SpectraLink 8020/8030 Wirele ss Telephones . Recommended AP configuration settings CLI Commands Required Settings De ...

  • Polycom A2400 - page 16

    Configuration Guide PN: 1725-36080-001_J.doc 16 CLI Commands Required Settings Default Settings Description 802.11b/g Tx rates (if all wireless client are 802.11g) These rates should be determined from RF site survey. Verify you have sufficient coverage to support data rates. 1,2,5,11 802.11a rates These rates should be determined from RF site surv ...

  • Polycom A2400 - page 17

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 1 7 CLI command configuration All of the commands listed in the CLI Commands column above must be entered under the ap location command. The format is: ap location x.y .z phy-type g (To make t he changes f or the “g” ra dio.) commands ! phy-type a (To make t he change ...

  • Polycom A2400 - page 18

    Configuration Guide PN: 1725-36080-001_J.doc 18 ...

  • Polycom A2400 - page 19

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 19 10. Click the 802.11 a tab. 11. For Max Retries , enter 2 fo r voice. 12. For the DTIM period , enter 3 . 13. For Basic Rates and Supported Rates, consult the facilities RF site survey to determine if coverage is sufficient to support all data rates. 14. To assign the ...

  • Polycom A2400 - page 20

    Configuration Guide PN: 1725-36080-001_J.doc 20 Dynamic RF Management — ARM Aware Scanning If Adaptive Radio Resource M anagement (ARM) Aware Scanning (RF scanning) is included in your firmware release, it can be enabled through the command line interface as follows: configure termina l ap location x.y .z phy-type g arm scann ing enable arm assig ...

  • Polycom A2400 - page 21

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 21 Security Policies and QoS Once the basic infrastructure is conf igured, it is necessary to configure the security policies to ensure that the data network and the voice network are secured and access to these networks is limited as required. The steps are as follows: 1 ...

  • Polycom A2400 - page 22

    Configuration Guide PN: 1725-36080-001_J.doc 22 Create policies for the wireless telephone user The policies shown in the above example can be configured using the Web interface as follows: ...

  • Polycom A2400 - page 23

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 23 Assign policies to the role Create a role, for example phones , and assign the policies to this role. This is the role that would be assigned to the handsets when they are authenticated successfully. The Security Policies and QoS can also be configured through the comm ...

  • Polycom A2400 - page 24

    Configuration Guide PN: 1725-36080-001_J.doc 24 alias svp_s erver user svc-svp per mit queue high user alias tftp-serv er svc-tftp permit user alias dhcp-serv er svc-dhcp permit user host 22 4.0.1.1 16 any per mit ! user-role phones session-acl phone_acl ! ...

  • Polycom A2400 - page 25

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 25 Authentication In addition to the encryption, Aruba recommends the use of MAC authentication to authenticate th e Spectralink handsets. On the Aruba System, the roles for SpectraLink Wireless Telephones are derived using MAC-authentication. The wireless telephones can ...

  • Polycom A2400 - page 26

    Configuration Guide PN: 1725-36080-001_J.doc 26 Quality of Service (QoS) Quality of service is achieved by prioritizing the SpectraLink voice traffic over data traffic. To prioriti ze the voice traffic over data traffic in the AP traffic queues, the “queue high” tag is used at the e nd of each ACL to prioritize the traffic matching the ACL over ...

  • Polycom A2400 - page 27

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 2 7 Subnet Roaming The Aruba system can be set up to support inter-switch inter-subnet roaming. The topology is as shown in the figure on page 2. When two or more switches are used in the Aruba WLAN system, one switch has to be identified as the master and the others as t ...

  • Polycom A2400 - page 28

    Configuration Guide PN: 1725-36080-001_J.doc 28 CLI Commands to Set Up Subnet Roaming Commands for the master switch (the Aruba 800) Configure termina l ip default-gate way <ip_addr of router> ap location 1.1.0 (#ap connected to 800) lms-ip <ip_ addr of 80 0 switch> ap location 1.2.0 (#ap connected to 6000 ) lms-ip <ip_ addr of 60 00 ...

  • Polycom A2400 - page 29

    Aruba Mobility Controllers: A200, A800, A2400, A6000 PN: 1725-36080-001_J.doc 29 It’s also necessary to set the def ault gateway of the SpectraLink 8000 SVP Server and SpectraLink 8000 Telephony Gateway to the IP address of the router connected to the master switch. CLI Commands to Verify Setup for Subnet Routing From the Aruba 800 show master ip ...

  • Polycom A2400 - page 30

    Configuration Guide PN: 1725-36080-001_J.doc 30 Checking the Configuration Verify connectivity by pinging between the switches, the APs, and the server and gateway. The switch and AP are now ready for use with the SpectraLink Wireless Telephones. To show AP settings: show ap config loc ation x.y.z To show all APs connected to a switch: show stm con ...

Manufacturer Polycom Category Network Hardware

Documents that we receive from a manufacturer of a Polycom A2400 can be divided into several groups. They are, among others:
- Polycom technical drawings
- A2400 manuals
- Polycom product data sheets
- information booklets
- or energy labels Polycom A2400
All of them are important, but the most important information from the point of view of use of the device are in the user manual Polycom A2400.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Polycom A2400, service manual, brief instructions and user manuals Polycom A2400. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Polycom A2400.

Similar manuals

A complete manual for the device Polycom A2400, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Polycom A2400 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Polycom A2400.

A complete Polycom manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Polycom A2400 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Polycom A2400, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Polycom A2400, that we can find in the current document
3. Tips how to use the basic functions of the device Polycom A2400 - which should help us in our first steps of using Polycom A2400
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Polycom A2400
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Polycom A2400 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Polycom A2400?

Use the form below

If you did not solve your problem by using a manual Polycom A2400, ask a question using the form below. If a user had a similar problem with Polycom A2400 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)