Manual Alpine TDM-7574E

19 pages 0.45 mb
Download

Go to site of 19

Summary
  • Alpine TDM-7574E - page 1

    EN DE FR ES IT SE R R ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel.: (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U.S.A. Tel.: 1-800-ALPINE-1 (1-800-257-4631) ALPINE ELECTRONICS OF CANADA, INC. Suite 203, 7300 Warden Ave. Markham, Ontario ...

  • Alpine TDM-7574E - page 2

    ...

  • Alpine TDM-7574E - page 3

    1 -EN Contents Operating Instr uctions W ARNING W ARNING .................................................. 2 CA UTION ................................................... 2 PRECA UTIONS ......................................... 2 Basic Operation Detaching the Front Panel .................................. 4 Attaching the Front Panel ............... ...

  • Alpine TDM-7574E - page 4

    2 -EN WARNING The e xclamation point within an equilateral triangle and "W ARNING" are intended to aler t the user to the presence of impor tant operating instructions. F ailure to heed the instructions will result in se vere injur y or death. DO NOT DISASSEMBLE OR AL TER. Doing so may lead to accident, fire or electric shock. KEEP SMALL ...

  • Alpine TDM-7574E - page 5

    3 -EN T ape Head Cleaning Periodic cleaning (approximately every 20 hours of use) of the tape head with a wet type head-cleaning cassette tape (available at audio stores) is necessary for best performance. Fuse Replacement When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder . If the fuse blows more t ...

  • Alpine TDM-7574E - page 6

    4 -EN Basic Operation Detaching the Fr ont P anel 1 Press the PWR (P ower) b utton to tur n off the power . 2 Press the (Release) button until the front panel pops out. 3 Grasp the left side of the front panel and pull it out. NO TES • The front panel may become hot (especially the connector terminals). This is not a malfunction. • T o pr otect ...

  • Alpine TDM-7574E - page 7

    5 -EN 2 Press and hold the A.S.U . (Automatic Setup) button f or at least 3 seconds to activate the A.S.U . mode. "ASU" blinks in the displa y . The unit automatically perf or ms the follo wing operations. 1. Activates the A uto Memor y mode. 2. Gradually sets the Bass, T reb le, Balance and F ader controls to their center positions. 3. G ...

  • Alpine TDM-7574E - page 8

    6 -EN 4 Press the DN g or f UP button to automatically seek f or a station downward or upward respectiv ely . The unit will stop on the ne xt station it finds. Press the same button again to seek the ne xt station. Manual Storing of Station Presets 1 Select the radio band and tune in a desired radio station you wish to store in the preset memory . ...

  • Alpine TDM-7574E - page 9

    7 -EN A utomatic Memory of Station Presets 1 Press the SOURCE button until the r adio frequency appears in the displa y . 2 Press the BAND button repeatedly until the desired radio band is displa yed. Each press changes the radio bands as f ollows: → F1 → F2 → AM 3 Press and hold the A. ME button f or at least 2 seconds. The frequency on the ...

  • Alpine TDM-7574E - page 10

    8 -EN Inser ting/Ejecting Cassette 1 Inser t a cassette tape into the slot with the open side f acing r ight. When the cassette is loaded, the pla yer automatically star ts tape pla yback and indicates "T APE" in the display . 2 Press the Eject ( c ) button when y ou want to eject the cassette tape. NOTES • When power is turned off or t ...

  • Alpine TDM-7574E - page 11

    9 -EN F ast Forward and Re wind 1 Press the DN g or f UP button during tape pla y to fast rewind or f orward the tape respectively . The tape side indicator or blinks indicating the direction of the tape. When the end of the tape is reached in the f ast rewind mode, the pla yer stops automatically and begins pla ying from the beginning of the same ...

  • Alpine TDM-7574E - page 12

    10 -EN Contr olling CD Chang er (Optional) The CD controls on the TDM-7574E will function only when a CD Changer (M-Bus) is connected. 1 Press the SOURCE button to activ ate the CD Changer . The display sho ws the disc number and trac k number . NOTE T o start play or pause playback, pr ess the : / J button. 2 When a 6-disc CD Changer is connected: ...

  • Alpine TDM-7574E - page 13

    11 -EN M.I.X. (Random) Pla y 1 Press and hold the M.I.X. button in CD pla y for at least 2 seconds to turn on the M.I.X. mode. When this mode is turned on, the tracks on the currently pla ying disc will be played bac k in a random sequence. T o cancel the M.I.X. mode, press and hold the M.I.X. button f or at least 2 seconds. The M.I.X. indicator di ...

  • Alpine TDM-7574E - page 14

    12 -EN Inf or mation CD CD Changer not functioning. • Out of operating temperature range +50˚C (+120˚F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool. CD playbac k sound is wavering. • Moisture condensation in the CD Module. - Allow enough time for the condensation to evaporate (about 1 hour). Unable to fast f orw ...

  • Alpine TDM-7574E - page 15

    13 -EN Indication for CD Changer • Protective circuit is activated due to high temperature. - The indicator will disappear when the temperature returns to within operation range. • Malfunction in the CD Changer . - Consult your Alpine dealer . Press the magazine eject button and pull out the magazine. Check the indication. Insert the magazine a ...

  • Alpine TDM-7574E - page 16

    14 -EN Installation and Connections Before installing or connecting the unit, please read the follo wing and pages 2 and 3 of this manual thor oughly for pr oper use . W arning USE ONL Y VEHICLES WITH A 12 VOL T NEGA TIVE (–) GROUND. Check with your dealer if you are not sure. Failure to do so may result in fire or electric shock. BEFORE WIRING, ...

  • Alpine TDM-7574E - page 17

    15 -EN 3 Slide the TDM-7574E into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashbo ...

  • Alpine TDM-7574E - page 18

    16 -EN Installation and Connections Connections Antenna To power antenna To amplifier or equaliser Ignition Key Front right Rear right CD Changer (Sold Separately) Speakers Amplifier Rear left Front left Battery TDM-7574E A DIN Connector PIN Configuration. Grey SPEAKER RIGHT FRONT Blue POWER ANT REMOTE TURN-ON Red IGNITION Y ellow BATTER Y Black GN ...

  • Alpine TDM-7574E - page 19

    17 -EN 1 Antenna Receptacle 2 Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicab le. NOTE This lead should be used only for contr olling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal pr ocessor , etc. 3 Remote Turn-On Lead (Blue/White) Connect this lead to t ...

Manufacturer Alpine Category Cassette Player

Documents that we receive from a manufacturer of a Alpine TDM-7574E can be divided into several groups. They are, among others:
- Alpine technical drawings
- TDM-7574E manuals
- Alpine product data sheets
- information booklets
- or energy labels Alpine TDM-7574E
All of them are important, but the most important information from the point of view of use of the device are in the user manual Alpine TDM-7574E.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Alpine TDM-7574E, service manual, brief instructions and user manuals Alpine TDM-7574E. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Alpine TDM-7574E.

Similar manuals

A complete manual for the device Alpine TDM-7574E, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Alpine TDM-7574E by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Alpine TDM-7574E.

A complete Alpine manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Alpine TDM-7574E - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Alpine TDM-7574E, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Alpine TDM-7574E, that we can find in the current document
3. Tips how to use the basic functions of the device Alpine TDM-7574E - which should help us in our first steps of using Alpine TDM-7574E
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Alpine TDM-7574E
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Alpine TDM-7574E in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Alpine TDM-7574E?

Use the form below

If you did not solve your problem by using a manual Alpine TDM-7574E, ask a question using the form below. If a user had a similar problem with Alpine TDM-7574E it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)