English dropdown-ico

Manual Hearth and Home Technologies RCTS-MLT

10 pages 0.55 mb
Download

Go to site of 10

Summary
  • Hearth and Home Technologies RCTS-MLT - page 1

    1 Printed in U.S.A. Copyright 2007 Hearth & Home T echnologies Inc. 20802 Kensington Boulevard, Lakeville, MN 55044 100-920B 8/07 RCTS-ML T Remote Control Kits -For use with SIT Millivolt V alves only- - Installation and Operating Instructions - INTRODUCTION The remote control system can be operated thermostatically or manually from the transmi ...

  • Hearth and Home Technologies RCTS-MLT - page 2

    2 RECEIVER WIRING INSTRUCTIONS Incorrect wiring connections WILL cause damage to the gas valve or electronic module operating the gas appliance and may also damage the remote receiver . Wiring Flame Function Connect the remote receiver by connecting the two red wires leading from the remote receiver to the red and brown remote wires labeled “FOR ...

  • Hearth and Home Technologies RCTS-MLT - page 3

    3 Figure 4. Plunger insertion NOTE: All steps required for installation of the fl ame controller MUST be done by a quali fi ed gas service technician. FLAME CONTROL SOLENOID REGULATOR TOWER PLUNGER JAM NUT REMOTE RECEIVER Line cord from fan LEARN 110/120 VAC, 3A (Receptacle on back) Alternative Wiring for units with a wall switch Disconnect the w ...

  • Hearth and Home Technologies RCTS-MLT - page 4

    4 Figure 8. REMOTE RECEIVER JAM NUT REGULA TOR TOWER PLUNGER RED ORANGE BLUE Finalizing Remote Installation 1. Turn the main gas knob ON, relight pilot fl ame, and turn fi replace ON. 2. Inspect gas connections around solenoid and regulator tower with a comercially available, non-corrosive leak check solution. 3. T urn fi replace of f and procee ...

  • Hearth and Home Technologies RCTS-MLT - page 5

    5 REMOTE RECEIVER The remote receiver has a 3-position slide switch: OFF/ REMOTE/ON (see Figure 7). Figure 7. Remote Receiver TRANSMITTER Important: Before operating remote control, transmitter and receiver must have matching security codes. See section ‘Matching Security Codes’. Important: Review ‘Thermo-Updating/Communication- Safety Featur ...

  • Hearth and Home Technologies RCTS-MLT - page 6

    6 MA TCHING SECURITY CODES It may be necessary to program the remote receiver to the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer . T o program the remote receiver: 1. Set the slide button on the receiver to the REMOTE position. 2. Push the LEARN button ( ...

  • Hearth and Home Technologies RCTS-MLT - page 7

    7 SETTING BUTTON Figure 9. Setting Button/Child Proof Lockout Setting ºF/ºC Scale The factory setting for temperature is degrees Fahrenheit (ºF) . T o change this setting to degrees Centigrade (ºC): 1. Remove the battery cover on the back of the transmit- ter and locate the “setting button” at the top center of battery compartment (see Figu ...

  • Hearth and Home Technologies RCTS-MLT - page 8

    8 Adjusting the Flame Height - Operates in ON or THERMO mode This remote control system allows the user to control the height of the FLAME when the gas valve is factory equipped with a FLAME CONTROLLER. 1. Press and release FLAME button to change fl ame height to HI (see Figure 8, Location #5), (a second fl ame icon appears). 2. Press again to re ...

  • Hearth and Home Technologies RCTS-MLT - page 9

    9 7. Set the SET temperature to at least 2º F (1º C) below the room temperature and the system fl ame will extin- guish. Thereafter, it should continue to cycle on and off thermostatically approximately every two minutes as the ROOM temperature changes, but only when the temperature differential between ROOM and SET temperatures differs at least ...

  • Hearth and Home Technologies RCTS-MLT - page 10

    10 THERMOST A T WIRE ASSEMBL Y PIEZO WHITE RED VA LV E PILOT THERMOCOUPLE THERMOPILE Figure 10. Standing Pilot Ignition Wiring Diagram Figure 1 1. Standing Pilot Ignition Wiring Diagram with Piggyback Wire Figure 12. Standing Pilot Ignition Wiring Diagram ON OFF ON/OFF SWITCH REMOTE SWITCH PIGTAIL OPTIONAL WALL SWITCH, THERMOSTAT OR REMOTE STANDING ...

Manufacturer Hearth and Home Technologies Category Universal Remote

Documents that we receive from a manufacturer of a Hearth and Home Technologies RCTS-MLT can be divided into several groups. They are, among others:
- Hearth and Home Technologies technical drawings
- RCTS-MLT manuals
- Hearth and Home Technologies product data sheets
- information booklets
- or energy labels Hearth and Home Technologies RCTS-MLT
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hearth and Home Technologies RCTS-MLT.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hearth and Home Technologies RCTS-MLT, service manual, brief instructions and user manuals Hearth and Home Technologies RCTS-MLT. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hearth and Home Technologies RCTS-MLT.

Similar manuals

A complete manual for the device Hearth and Home Technologies RCTS-MLT, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hearth and Home Technologies RCTS-MLT by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hearth and Home Technologies RCTS-MLT.

A complete Hearth and Home Technologies manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hearth and Home Technologies RCTS-MLT - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hearth and Home Technologies RCTS-MLT, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hearth and Home Technologies RCTS-MLT, that we can find in the current document
3. Tips how to use the basic functions of the device Hearth and Home Technologies RCTS-MLT - which should help us in our first steps of using Hearth and Home Technologies RCTS-MLT
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hearth and Home Technologies RCTS-MLT
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hearth and Home Technologies RCTS-MLT in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hearth and Home Technologies RCTS-MLT?

Use the form below

If you did not solve your problem by using a manual Hearth and Home Technologies RCTS-MLT, ask a question using the form below. If a user had a similar problem with Hearth and Home Technologies RCTS-MLT it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)