Manual a/d/s/ P650

14 pages 1.09 mb
Download

Go to site of 14

Summary
  • a/d/s/ P650 - page 1

    analog and digital systems P 4 5 0 / P 6 5 0 / P 8 5 0 owners manual 00-3009 REV A ©2001 analog and digital systems, inc. 300 wildwood avenue, woburn, massachusetts 01801 781.729.1140 www.adst.com ...

  • a/d/s/ P650 - page 2

    1 26 table of contents introduction 1 about this manual 2 features of your PowerPlateTM 2 warning and tips 3 system planning 4 signal sources 4 system configurations 6 mounting locations 11 installation 12 controls and connections 13 multi-crossTM crossover and configurations 16 tuning 17 troubleshooting 19 specifications 21 warranty information 22 ...

  • a/d/s/ P650 - page 3

    25 2 specifications amplifier section power output 4 W (watts) 1 50/channel 150/bridged channel pair power output 2 W (watts) 2 75/channel distortion all channels driven 0.1% 20Hz to 20,000Hz frequency response ±1dB 10Hz to 30,000Hz signal-to-noise ratio full bandwidth @ rated output power >90dB damping factor @ output connector full bandwidth ...

  • a/d/s/ P650 - page 4

    3 24 W arnings and tips Always disconnect the battery ground wire before doing any work on your vehicle. Reconnect the cable only after the installation is complete and the wiring has been checked to make sure that there are no problems. If your radio features a code type security system, be sure you know the code before disconnecting the battery! ...

  • a/d/s/ P650 - page 5

    23 4 T roubleshooting symptom possible cause action to take no output low or no remote turn-on input check remote turn-on voltage output at amplifier and cor rect as needed fuse blown check power wire integrity and reversed polarity, repair as needed and replace fuse power wires not connected check power wire and ground connections and repair or re ...

  • a/d/s/ P650 - page 6

    5 22 P450 system diagrams System 1 - P450 used in 4-channel mode with front and rear full range speakers. System 2 - P450 used in 2-channel bridged mode with full range speakers. ...

  • a/d/s/ P650 - page 7

    21 6 System 3 - Two P450’s; one is used to drive front tweeters and midrange drivers, the second is used in 2-channel bridged mode for subwoofers. Subwoofer level can be controlled by using the source’s front output for the first P450 and the rear output for the second P450. ...

  • a/d/s/ P650 - page 8

    7 20 System 1 – P650 used in 6-channel mode. Channels 1/2 are high-passed for front speakers. Chan- nels 3/4 are high-passed for rear speakers. Channels 5/6 are low-passed for subwoofers. Although shown with 4-channels of input, the source unit can be either 2- or 4-channel. System 2 – P650 used in 6-channel mode. Channels 1/2 are high-passed f ...

  • a/d/s/ P650 - page 9

    19 8 adjusting input sensitivity The input sensitivity setting is important to ensure proper performance, low noise levels, and maxi- mum system reliability. As a general rule, components at the "front end" of the system should be set as high as possible with the input sensitivity of the amplifier set as low as possible while still pro- v ...

  • a/d/s/ P650 - page 10

    9 18 P850 system diagrams System 1 – P850 used in 6-channel mode. Channels 1/2 are high-passed for front speakers chan- nels 3/4 are high-passed for rear speakers, and channels 5/6 and 7/8 are bridged low-pass for sub- woofers. Although shown with 4-channels of input, the source unit can be either 2- or 4-channel. System 2 – The P850 is used in ...

  • a/d/s/ P650 - page 11

    17 10 xover control 5/6 (P650) – The crossover selection for channels 5&6 has three possibilities: When the switch is in the left position, the crossover section of the amplifier is bypassed. Channel 5&6 output is full range. When the switch is the center position, channels 5&6 are filtered through a 12dB per octave high-pass crossove ...

  • a/d/s/ P650 - page 12

    11 16 installation 1. Disconnect the battery ground cable. Reconnect the ground cable only after the installation is complete and the wiring has been checked to make sure that there are no problems. If your radio features a code type security system, be sure you know the code before disconnecting the battery! 2. Run a minimum AWG #8 power wire dire ...

  • a/d/s/ P650 - page 13

    15 12 internal signal routing, cont’d Channels 5/6 input switch (P650 and P850) – selects input from three possibili - ties. When the switch is in the left position, channels 5/6 receive input from the 5/6 DIN inputs. When the switch is in the center position, channels 5/6 receive input from channels 1/2 RCA input. When the switch is in the rig ...

  • a/d/s/ P650 - page 14

    13 14 signal sources Due to the wide input level adjustment range, all a/d/s/ PowerPlates TM can be driven with either a conventional preamplifier drive signal or the amplified signal from a powered source unit. This makes the PowerPlate TM perfect for upgrading an OEM (Original Equipment Manufacturer) stereo system while retaining the factory inst ...

Manufacturer a/d/s/ Category Car Stereo System

Documents that we receive from a manufacturer of a a/d/s/ P650 can be divided into several groups. They are, among others:
- a/d/s/ technical drawings
- P650 manuals
- a/d/s/ product data sheets
- information booklets
- or energy labels a/d/s/ P650
All of them are important, but the most important information from the point of view of use of the device are in the user manual a/d/s/ P650.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals a/d/s/ P650, service manual, brief instructions and user manuals a/d/s/ P650. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product a/d/s/ P650.

Similar manuals

A complete manual for the device a/d/s/ P650, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use a/d/s/ P650 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of a/d/s/ P650.

A complete a/d/s/ manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual a/d/s/ P650 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the a/d/s/ P650, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the a/d/s/ P650, that we can find in the current document
3. Tips how to use the basic functions of the device a/d/s/ P650 - which should help us in our first steps of using a/d/s/ P650
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with a/d/s/ P650
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of a/d/s/ P650 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning a/d/s/ P650?

Use the form below

If you did not solve your problem by using a manual a/d/s/ P650, ask a question using the form below. If a user had a similar problem with a/d/s/ P650 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)