Manual Bunn VP17B

19 pages 0.75 mb
Download

Go to site of 19

Summary
  • Bunn VP17B - page 1

    OPERA TING & SERVICE MANUAL B UNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 www .bunnomatic.com VP17 VP17B BU N N ® 10860.0000 12/01 ©1996 Bunn-O-Matic Corporation ...

  • Bunn VP17B - page 2

    Page 2 INTRODUCTION This equipment will brew a half-gallon batch of coffee into an awaiting dispenser. It is only for indoor use on a sturdy counter or shelf. W ARRANTY Bunn-O-Matic Corp. (“Bunn”) warrants the equipment manufactured by it to be commercially free from defects in material and workmanship existing at the time of manufacture and ap ...

  • Bunn VP17B - page 3

    Page 3 10860 090800 # 00831.0000 # 00658.0000 USER NOTICES (cont.) CA UTION POUR IN W A TER ONL Y W ARMERS AND SURF A CES ARE HO T #02763.0000 ...

  • Bunn VP17B - page 4

    Page 4 ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. The brewer has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. Electrical Hook-Up (Model "B" Only) CAUTION – Improper electrical installation will dam ...

  • Bunn VP17B - page 5

    Page 5 COFFEE BREWING 1. Insert a BUNN ® filter into the funnel. 2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking. 3. Slide the funnel into the funnel rails. 4. Place an empty dispenser beneath the funnel. 5. Pour one pitcher of tap water into the screened area on top of the brewer. 6. When brewing is complet ...

  • Bunn VP17B - page 6

    Page 6 TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. • Inspection, testing, and repair of electrical equipment should be performed only by ...

  • Bunn VP17B - page 7

    Page 7 TROUBLESHOOTING (cont.) PROBLEM Water is not hot (cont.) Inconsistent beverage level in dis- penser Spitting or excessive steaming Dripping from sprayhead PROBABLE CAUSE REMEDY 4. Tank Heater 1. Syphon System 2. Lime Build-up CAUTION - Tank and tank compo- nents should be delimed regularly depending on local water condi- tions. Excessive min ...

  • Bunn VP17B - page 8

    Page 8 TROUBLESHOOTING (cont.) PROBLEM Beverage overflows dispenser Weak beverage Dry coffee grounds remain in the funnel Brewer is making unusal noises Cool beverage serving tempera- ture PROBABLE CAUSE REMEDY 1. Dispenser 1. Filter Type 2. Coffee Grind 3. Sprayhead 4. Funnel Loading 5. Water Temperature 1. Funnel Loading 1. Tank Heater 1. ON/OFF ...

  • Bunn VP17B - page 9

    Page 9 SERVICE This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem. WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service per ...

  • Bunn VP17B - page 10

    Page 10 P1263 Location: The control thermostat is located inside the trunk on the left side of the component bracket. Test Procedures: 1. Disconnect the brewer from the power source. 2. With a voltmeter, check the voltage across the blue wire on the control thermostat and the white wire on the tank heater. Connect the brewer to the power source. Th ...

  • Bunn VP17B - page 11

    Page 11 SERVICE (cont.) 10860 061501 LIMIT THERMOSTAT P1161.40 FIG. 4 LIMIT THERMOSTAT Location: The limit thermostat is located inside the rear of the hood on the tank lid. Test Procedures: 1. Disconnect the brewer from the power source. 2. Disconnect the blue and black wires from the limit thermostat. 3. With an ohmmeter, check for continuity acr ...

  • Bunn VP17B - page 12

    Page 12 If voltage is not present as described, refer to the Wiring Diagrams and check the brewer wiring har- ness. 5. With the black wire removed, remove the wire from the lower terminal. 6. Check for continuity across the center and lower terminal with the switch in the "ON" (upper) posi- tion. Continuity must not be present when the sw ...

  • Bunn VP17B - page 13

    Page 13 SERVICE (cont.) 10860 090800 TANK HEATER P1161.40 Location: The tank heater is located inside the tank and secured to the tank lid. Test Procedures: 1. Disconnect the brewer from the power supply. 2. With a voltmeter, check the voltage across the black and white wires on the tank heater. Connect the brewer to the power source. The indicatio ...

  • Bunn VP17B - page 14

    Page 14 Location: On Early VP17 Models the tank heater switch is located on the rear of the brewer on the upper left side of the trunk. On VP17B Models the tank heater switch is located on left side of the control panel. Test Procedure: 1. Disconnect the brewer from the power source. 2. Disconnect the black wire from the limit thermo- stat. 3. With ...

  • Bunn VP17B - page 15

    Page 15 SERVICE (cont.) 13. Set tank assembly inside the hood on mounting brackets and secure with two #8-32 screws. 14. Reconnect the wires to the limit thermostat, tank heater and the control thermostat. Refer to Limit Thermostat, Tank Heater and Control Thermostat sections in this manual when reconnecting wires. 15. Secure the sprayhead tube to ...

  • Bunn VP17B - page 16

    Page 16 WARMER ELEMENT(S) P1167 SERVICE (cont.) Location: The warmer element(s) is located under the warmer plate. Test Procedures: 1. Disconnect the brewer from the power source. 2. With a voltmeter, check voltage across the white wire to the power cord and the white/red, brown/ black or violet wire to the "ON/OFF" switch, with the " ...

  • Bunn VP17B - page 17

    Page 17 10860 061501 SCHEMATIC WIRING DIAGRAM VP17-1/-2/-3 10862.0003F 9/97 ©1997 BUNN-O-MATIC CORPORATION P2 P1 FRONT WARMER 100W WHI WHI P3 100W WHI BRN/BLK VIO WHI REAR WARMER WHI WHI 100W LOWER WARMER N WHI 120 VOLTS AC 2 WIRE SINGLE PHASE BLK BRN/BLK BLK VIO VP17-3 DUAL SIDE WARMER ASSY 1320W BLK TANK HEATER L1 GRN BLK BLU SW. & THERMOSTA ...

  • Bunn VP17B - page 18

    Page 18 SCHEMATIC WIRING DIAGRAM VP17-1/-2/-3 10862.0000B 9/00 ©1995 BUNN-O-MATIC CORPORATION P2 P1 FRONT WARMER WHI WHI P3 WHI BRN/BLK VIO WHI REAR WARMER WHI WHI LOWER WARMER N WHI 120 VOLTS AC 2 WIRE SINGLE PHASE BLK BRN/BLK BLK VIO 2 TOP or SIDE WARMERS AUXILIARY OUTLET (NOT AVAILABLE ON VP17-3) BLK TANK HEATER L1 GRN BLK HEATER SWITCH BLK BLU ...

  • Bunn VP17B - page 19

    Page 19 SCHEMATIC WIRING DIAGRAM VP17B-1/-2/-3 10862.0002F 9/00 ©1997 BUNN-O-MATIC CORPORATION P2 P1 FRONT WARMER WHI WHI P3 WHI BRN/BLK VIO WHI REAR WARMER WHI WHI LOWER WARMER N WHI 100 VOLTS AC 2 WIRE SINGLE PHASE BLK BRN/BLK BLK VIO 2 TOP or SIDE WARMERS AUXILIARY OUTLET (NOT AVAILABLE ON VP17B-3) BLK TANK HEATER L1 GRN BLK HEATER SWITCH BLK B ...

Manufacturer Bunn Category Coffeemaker

Documents that we receive from a manufacturer of a Bunn VP17B can be divided into several groups. They are, among others:
- Bunn technical drawings
- VP17B manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn VP17B
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn VP17B.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn VP17B, service manual, brief instructions and user manuals Bunn VP17B. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn VP17B.

Similar manuals

A complete manual for the device Bunn VP17B, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn VP17B by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn VP17B.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn VP17B - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn VP17B, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn VP17B, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn VP17B - which should help us in our first steps of using Bunn VP17B
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn VP17B
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn VP17B in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn VP17B?

Use the form below

If you did not solve your problem by using a manual Bunn VP17B, ask a question using the form below. If a user had a similar problem with Bunn VP17B it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)