English dropdown-ico

Manual Craftsman 536885211

17 pages 0.69 mb
Download

Go to site of 17

Summary
  • Craftsman 536885211 - page 1

    5.0 Horsepower 21 Inch Single Stage Auger Propelled SNOW THROWER Electric Start MODEL NO. 536.885211 I B ! ! Caution: Read and follow all Safety Rules and Operating Instructions before first use of this product, SEARS, ROEBUCK AND CO., Hoffman Estates, IL 60179 U.S.A. F001019M 04/27/99 ...

  • Craftsman 536885211 - page 2

    Table of Contents 2 Service and Adjustments 12-15 Warranty 2 Storage 16 Safety Rules 2-4 Troubleshooting 17 Contents of Shipping Carton 4 Snow Repair Parts 18-24 Assembly 5 Engine Repair Parts 25-29 Operation 6-10 Spanish(EspaSol) 30-46 Maintenance 11 Parts Ordering/Service Back Cover kvAv/_,1 -- | Ir.,_ _ | ik"J _ir.,_l i_ivllq_| I LIMITED TW ...

  • Craftsman 536885211 - page 3

    • Use only attachments and accessories approved by the manufacturer of the snow thrower (such as electric starter kits, etc.). • Never operate the snow thrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk; never run. • This snow thrower is for use on side- walks, driveways, and ot ...

  • Craftsman 536885211 - page 4

    REPAIPJADJUSTMENTS SAFETY • After striking a foreign object, stop the engine (motor). Turn key to OFF position and remove key to prevent accidental starting. Thoroughly inspect the snowthrower for any damage, and repair the damage before restarting and operating it. • If snow thrower should start to vibrate abnormally, stop engine (motor) and c ...

  • Craftsman 536885211 - page 5

    CAUTION: Always wear safety glasses or eye shields while assembling snow thrower. TOOLS REQUIRED FOR ASSEMBLY 1 - Knife to cut carton The figure to the right shows the snow thrower completely assembled. References to the right or left hand side of the snow thrower are from the viewpoint of the operator's position behind the unit. TO REMOVE SNO ...

  • Craftsman 536885211 - page 6

    KNOW YOUR SNOW THROWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER, Compare the illustrations with your SNOW THROWER to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Electric Start Ignition Off ignition On ..... Oil/Fuel Mixture Primer Button ...

  • Craftsman 536885211 - page 7

    HOW TO USE YOUR SNOW THROWER TO STOP YOUR SNOW THROWER • To stop the auger, release the auger control bar. NOTE: If the auger continues to creep, refer (To Adjust Auger Control Cable paragraph on page 12). • To stop the engine, turn key to the OFF position. TO CONTROL SNOW DISCHARGE • Turn the chute control rod to set the direction of the sno ...

  • Craftsman 536885211 - page 8

    DO NOT FILL THE FUEL TANK WITH GASOLINE THAT DOES NOT HAVE OIL MIXED IN IT. SHAKE THE GASOLINE CONTAINER BEFORE EACH FILLING OF THE FUEL TANK. 011 (1/2 cup or 3.2 o7.) Shake Can 1 U.S. gallon container _- • Pour 1 U.S. quart of fresh, clean, unleaded automotive gasoline to a gallon gasoline container. • Add 3.2 oz of clean, high quality, Crafts ...

  • Craftsman 536885211 - page 9

    "1/2 choke" position. When engine runs smoothly, move choke lever to "No Choke" Position. NOTE: Allow the engine to warm up for several minutes before blowing snow in temperatures below 0°F. WARM START • Be sure the choke is in the OFF posi- tion and putt the starter handle unlil the engine starts. • Do not prime a warm eng ...

  • Craftsman 536885211 - page 10

    SNOW THROWING TIPS • This snow thrower will propel itself forward when the handle is raised enough to cause the auger blades to contact the ground. The auger should stop when auger control bar is released. If it does not, refer to Adjust Auger Control Cable paragraph on page 12. • For most efficient snow throwing, turn the discharge chute defle ...

  • Craftsman 536885211 - page 11

    CUSTOMER RESPONSIBILITIES SERVICE RECORDS Fill in dates as you complete regular service SCHEDULE SERVICE DATES Before After As Before Begin Each first 12 Needed Storage r Each Use Hours Season Tighten All Screws & Nuts Check Spark Plug Check Drive Belts Lubricate Chute Control Flange Check Fuel p,/ Drain Fuel GENERAL RECOMMENDATIONS The warrant ...

  • Craftsman 536885211 - page 12

    CARBURETOR ADJUSTMENT The carburetor on this snow thrower is not adjustable. IMPORTANT: Ifyou think the carburetor is not operating properly, contact your nearest Sears service center. Z_ CAUTION: Never tamper with the engine governor which is factory set for proper engine speed. Over speeding the engine may increase the danger of personal injury a ...

  • Craftsman 536885211 - page 13

    • Remove the gas cap. • Remove the two bolts and nuts from the front lip of the top cover. Use a flat head screwdriver and a 3/8" wrench. • Remove the bolt from the front right side. Use a 5/16" and 3/8" wrench. • Remove the four screws on the left side of the top cover. Use a large flat head screwdriver. • Remove the bolt ...

  • Craftsman 536885211 - page 14

    Screw and nut to Idler Pulley be loosened Pulley Brake Pad • Move belt guide into position. The belt guide should be 3/32" from belt when belt is engaged as shown in next figure. • Reinstall belt cover. TO REPLACE THE DRIVE BELT The drive belt on this unit is of special construction and must be replaced with the same type belt available at ...

  • Craftsman 536885211 - page 15

    TO REPLACE THE SPARK PLUG NOTICE: This spark ignition system meets all requirements of the Canadian Interfer- ence-Causing Equipment Regulations. NOTICE: This engine complies with all cur-. ' rent Australian and New Zealand limitaions regarding electromagnetic interference. The spark plug is housed in the engine compartment under the top cover ...

  • Craftsman 536885211 - page 16

    WARNING: Never store your snow thrower indoors or in an enclosed, poorly ventilated area. If gasoline remains in the tank, fumes may reach an open flame, spark or pilot light from a furnace, water heater, clothes dryer, cigarette, etc. To prevent engine damage (if snow thrower is not used for more than 30 days) follow the steps below. SNOW THROWER ...

  • Craftsman 536885211 - page 17

    TROUBLE CAUSE CORRECTION Difficult starting Defective spark plug Replace defective plug Engine stalls Unit running on CHOKE Move choke lever to OFF positor Blocked fuel line or low on fuel Clean fuel line; check fuel sup- Engine runs ply; add fresh gasoline (gaso- erractically line/oil mixture if 2-cycle engine) or Water or dirt in fuel system Use ...

Manufacturer Craftsman Category Snow Blower

Documents that we receive from a manufacturer of a Craftsman 536885211 can be divided into several groups. They are, among others:
- Craftsman technical drawings
- 536885211 manuals
- Craftsman product data sheets
- information booklets
- or energy labels Craftsman 536885211
All of them are important, but the most important information from the point of view of use of the device are in the user manual Craftsman 536885211.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Craftsman 536885211, service manual, brief instructions and user manuals Craftsman 536885211. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Craftsman 536885211.

Similar manuals

A complete manual for the device Craftsman 536885211, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Craftsman 536885211 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Craftsman 536885211.

A complete Craftsman manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Craftsman 536885211 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Craftsman 536885211, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Craftsman 536885211, that we can find in the current document
3. Tips how to use the basic functions of the device Craftsman 536885211 - which should help us in our first steps of using Craftsman 536885211
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Craftsman 536885211
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Craftsman 536885211 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Craftsman 536885211?

Use the form below

If you did not solve your problem by using a manual Craftsman 536885211, ask a question using the form below. If a user had a similar problem with Craftsman 536885211 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)