-
Aiwa XR-EC10 - page 1
U XR-EC10 XR-EC12 8C-CL3-903-01 020301ASW-H-M For assistance and information (United States and Puerto Rico) Owner’ s record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below . Please refer to them when you contact your Aiwa dealer in case of difficulty . Model ...
-
Aiwa XR-EC10 - page 2
2 En W ARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’ s enclosure that may be ...
-
Aiwa XR-EC10 - page 3
3 En Outdoor Antenna Power lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as co ...
-
Aiwa XR-EC10 - page 4
4 En Before starting connection, check that the protective tag has been taken off (see page 3). Connection Plug in the AC power cord to the AC outlet after all other connections are made. 1 Connect the speaker cords to the speakers. Connect the copper cords to the + terminals and the silver cords to the – terminals. 2 Connect the speakers to the ...
-
Aiwa XR-EC10 - page 5
5 En PA RTS AND CONTROLS Main unit 1 4 5 6 8 3 2 7 5 VOLUME Adjusts the volume. 6 s CLEAR CD: stops playback. Radio: clears a preset station. CD E Starts and pauses play . f / r , t / g (TUNING DOWN, UP) CD: skips to a previous or a succeeding track when pressed, searches a track in fast forward or reverse playback when held down. Radio: manually t ...
-
Aiwa XR-EC10 - page 6
6 En Remote control 1 8 5 6 4 ! 9 # 0 @ 2 3 7 Buttons with the same or similar names on the main unit basically have the same function. 1 POWER 2 0–10, +10 CD: selects a track of the specified number . Radio: tunes in the station with the specified preset number . The numbered buttons take on these functions when pressed with SHIFT held down : CL ...
-
Aiwa XR-EC10 - page 7
7 En ADJUSTMENTS BEFORE OPERA TION Power Tu rning the unit on Press POWER 6 ST ANDBY/ON (POWER on the remote control). Alternatively , press TUNER/BAND, AUX, DISC DIRECT PLA Y or CD. Playback will start automatically if a disc is loaded. Tu rning the unit off Press POWER 6 ST ANDBY/ON again. The unit goes into standby . POWER 6 ST ANDBY/ON POWER ...
-
Aiwa XR-EC10 - page 8
8 En This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing CDs 1 Press CD1 z OPEN/CLOSE to open the disc tray . Place a disc with the label side up. • When loading an 8-cm disc, place it on the inner circle of the tray . z OPEN/CLOSE Disc tray number CD OPERA TIONS 2 To play two or three discs, load the second and third discs ...
-
Aiwa XR-EC10 - page 9
9 En Random/Repeat play In random play mode the unit plays all the tracks in random order . In repeat play mode it plays repeatedly all the discs or the track being played. Y ou can select random and r epeat a ll play at the same time. 1 Press RANDOM/REPEA T repeatedly on the remote control. The mode changes as follows: " " 1 ": Play ...
-
Aiwa XR-EC10 - page 10
10 En RADIO OPERA TIONS Manual tuning 1 Press TUNER/BAND repeatedly to select a band. The unit switches to the radio from any other function and alternates between FM and AM. 2 Press f or g repeatedly to tune in a station. " TUNE " is displayed when a station is tuned in. " STEREO " is displayed for FM stereo reception. To searc ...
-
Aiwa XR-EC10 - page 11
11 En Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that " MONO " is displayed. To cancel, r epeat the above so that “ STEREO ” is displayed. Tip : When FM stereo reception is poor , switching to monaural reduces noise. To switch the AM tuning inter val The default setting ...
-
Aiwa XR-EC10 - page 12
12 En TIMER OPERA TIONS Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press SET . 2 Within 6 seconds, press f or g to set the time. Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units. 3 Press SET . The time display sto ...
-
Aiwa XR-EC10 - page 13
13 En To check the timer setting Press TIMER on the remote control so that " 5 PLAY " appears on the display . After 6 seconds, the timer -on time, the source and the timer- activated duration are displayed for 6 seconds. To change the timer setting Reset the timer again. To cancel the timer Press TIMER on the remote control twice until & ...
-
Aiwa XR-EC10 - page 14
14 En Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. To clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty , use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or ...
-
Aiwa XR-EC10 - page 15
15 En Specifications MAIN UNIT CX-LEC10, CX-LEC12 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminal 75 ohms (unbalanced) AM tuning range 530 kHz to 1710 kHz (10 kHz step) 531 kHz to 1602 kHz (9 kHz step) AM usable sensitivity 350 µV/m AM antenna Loop antenna AMPLIFIER Power output 24 W + 24 W (40 Hz ...
-
Aiwa XR-EC10 - page 16
Printed in Malaysia NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy ...
Do you have a question concerning Aiwa XR-EC10?
Use the form below
If you did not solve your problem by using a manual Aiwa XR-EC10, ask a question using the form below. If a user had a similar problem with Aiwa XR-EC10 it is likely that he will want to share the way to solve it.