Manual Cisco Systems OC-12/STM-14

20 pages 0.33 mb
Download

Go to site of 20

Summary
  • Cisco Systems OC-12/STM-14 - page 1

    Corporate Headquarters: Copyright © 2004 Cisco Systems, Inc. All rights reserved. Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA Cisco IOS Software Configuration for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card This document describes the software con figurat io n procedure for the 1- port channelized OC-12/STM-4 (DS ...

  • Cisco Systems OC-12/STM-14 - page 2

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card Prerequisites for the 1-Port Channeliz ed OC- 1 2/ST M-4 (DS3) Line Card 2 Cisco IOS Release 12.0(8)S Prerequisites for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card The Cisco 1 2000 Series Rou ter must have at least one clock and sc heduler card (CSC) i ...

  • Cisco Systems OC-12/STM-14 - page 3

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 3 Cisco IOS Release 12.0(8)S (Remainder of displayed text omi tted from e xample) Ta b l e 1 sho ws the def ault OC-12 controller conf igura tion of a 1-port channeli zed OC-12/STM-4 (DS3) lin ...

  • Cisco Systems OC-12/STM-14 - page 4

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 4 Cisco IOS Release 12.0(8)S Configuring the DS3 Serial Interface After you v e rify the OC-12 controller co nfiguration, you can conf igure the associated DS3 channel and serial interfaces o ...

  • Cisco Systems OC-12/STM-14 - page 5

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 5 Cisco IOS Release 12.0(8)S The prompt changes to inter face conf igu ration mode. The follo wing e xample is for a 1-port channelized OC-12/STM-4 (DS3) line card in chassis slot 1: Router(co ...

  • Cisco Systems OC-12/STM-14 - page 6

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 6 Cisco IOS Release 12.0(8)S Y ou can connect the local (near -end) DS3 port to the remote (f ar-end) DS3 port using a third- party DSU. Then use the telnet command from the local DS3 port to ...

  • Cisco Systems OC-12/STM-14 - page 7

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 7 Cisco IOS Release 12.0(8)S The Cisco Remote Connection Management feature uses two Cisco-proprietary DS3 C-bit parity Far -End Alarm and Cont rol (FEAC) messages that ar e not us ed in the A ...

  • Cisco Systems OC-12/STM-14 - page 8

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 8 Cisco IOS Release 12.0(8)S Enabling Payload Scrambling Payload (data) scrambling con verts th e data receive d by the lo cal or remote DS3 ports from an y of the three supported thi rd-part ...

  • Cisco Systems OC-12/STM-14 - page 9

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 9 Cisco IOS Release 12.0(8)S Last clearing of "show interface" counters 1d16h Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits ...

  • Cisco Systems OC-12/STM-14 - page 10

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 10 Cisco IOS Release 12.0(8)S – show contr ollers oc12 slot/port:c hannel# V erify the Cisco Remote Connection Management configuration b y entering the show contr ollers oc12 slot/port:c h ...

  • Cisco Systems OC-12/STM-14 - page 11

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 11 Cisco IOS Release 12.0(8)S FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF ................ FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF ................ Router • Use the show protocol ...

  • Cisco Systems OC-12/STM-14 - page 12

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 12 Cisco IOS Release 12.0(8)S Using Loopback Commands The 1-port channelized OC-12 /STM-4 (DS3) line card supports loop back modes for both the OC-1 2 controller and for each of the associ at ...

  • Cisco Systems OC-12/STM-14 - page 13

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 13 Cisco IOS Release 12.0(8)S • Line—This loopback mode loops data from the receiv e path to the transmit path at the mux/demux part on the line card, returning al l recei ved data at the ...

  • Cisco Systems OC-12/STM-14 - page 14

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 14 Cisco IOS Release 12.0(8)S set to internal o n the local OC-12 controller in slot 1 with IP address 10.0.0 .2. Clock source is set to line on the remote OC-12 controller in slot 1 with IP ...

  • Cisco Systems OC-12/STM-14 - page 15

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card How to Configure the 1-Port Channe lized OC-12/STM-4 (DS3) Line Card 15 Cisco IOS Release 12.0(8)S Entering Errors in BER Tests T o insert intentional erro rs into the BER test stream, use the follo wing command syntax: bert errors [ no-of-err ors ], where the ...

  • Cisco Systems OC-12/STM-14 - page 16

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 16 Cisco IOS Release 12.0(8)S The follo wing example sho ws the information of a BER test that is still in prog ress: Router# show controller OC12 1/0:1 bert Interface Serial1/0:1 (DS3 port 1 ...

  • Cisco Systems OC-12/STM-14 - page 17

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card Configuration Examples for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card 17 Cisco IOS Release 12.0(8)S Configuration Examples for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card Figure 2 sho ws two 1-port channelized OC-12/S T M-4 (DS3) line card conf i ...

  • Cisco Systems OC-12/STM-14 - page 18

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card Configuration Examples for the 1-Port Channelized OC- 12/STM- 4 (D S3) Line Card 18 Cisco IOS Release 12.0(8)S Figur e 2 1 -P ort Channelized OC-12/S T M-4 (DS3 ) L i n e Ca rd In te rop e ra b i l it y Di a gra m The following e xample shows a typical conf i ...

  • Cisco Systems OC-12/STM-14 - page 19

    Cisco IOS Software Configuration for th e 1-Port Channelized OC-12/STM-4 (DS3) Line Card Additional References 19 Cisco IOS Release 12.0(8)S Additional References The follo wing sections provide r eferences related to the 1-port channelized OC-12/STM-4 (DS3) line card. Related Documents Technical Assistance Copyright © 200 4 Cisco Syst ems, Inc. A ...

  • Cisco Systems OC-12/STM-14 - page 20

    Cisco IOS Software Configuration for the 1-Port Chann eliz ed OC-12/STM -4 (DS3) Line Card Additional References 20 Cisco IOS Release 12.0(8)S ...

Manufacturer Cisco Systems Category Network Router

Documents that we receive from a manufacturer of a Cisco Systems OC-12/STM-14 can be divided into several groups. They are, among others:
- Cisco Systems technical drawings
- OC-12/STM-14 manuals
- Cisco Systems product data sheets
- information booklets
- or energy labels Cisco Systems OC-12/STM-14
All of them are important, but the most important information from the point of view of use of the device are in the user manual Cisco Systems OC-12/STM-14.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Cisco Systems OC-12/STM-14, service manual, brief instructions and user manuals Cisco Systems OC-12/STM-14. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Cisco Systems OC-12/STM-14.

A complete manual for the device Cisco Systems OC-12/STM-14, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Cisco Systems OC-12/STM-14 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Cisco Systems OC-12/STM-14.

A complete Cisco Systems manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Cisco Systems OC-12/STM-14 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Cisco Systems OC-12/STM-14, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Cisco Systems OC-12/STM-14, that we can find in the current document
3. Tips how to use the basic functions of the device Cisco Systems OC-12/STM-14 - which should help us in our first steps of using Cisco Systems OC-12/STM-14
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Cisco Systems OC-12/STM-14
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Cisco Systems OC-12/STM-14 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Cisco Systems OC-12/STM-14?

Use the form below

If you did not solve your problem by using a manual Cisco Systems OC-12/STM-14, ask a question using the form below. If a user had a similar problem with Cisco Systems OC-12/STM-14 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)