English dropdown-ico

Manual McCulloch Aug-42

17 pages 0.35 mb
Download

Go to site of 17

Summary
  • McCulloch Aug-42 - page 1

    INSTRUCTION MANUAL IMP ORT AN T IN FO RM A TIO N: Plea se read t hese inst ru ctio ns caref ull y and make sur e you under st and th em befo re usi ng thi s uni t. Ret ain t hese instr uctions for fut ure refer ence. MANUEL D’ INSTRUCTIO NS RENSEIGNEM ENTS IMPOR T AN TS: Avant d’ut il iser cet appareil , veuill ez li re at entivement les inst r ...

  • McCulloch Aug-42 - page 2

    2 ID ENTI FIC A TIO N (WHA T IS WH A T?) Chain Adjus tment T oo l (Bar T ool) Bar O il Fill Cap Chain Front H and Guar d Starter R ope ON/S T OP Switch Muffler Chok e/ Fast Idle Lever Fuel Mix Fill Cap Starter H ous ing Idle Speed Sc rew Bumper spik e Primer Bu lb Front Handle Guide Bar Adjusting Wheel Cy linder Cover Thrott le Lock out Rear Handle ...

  • McCulloch Aug-42 - page 3

    3 IDEN TIF ICA T ION OF SYM BOLS Mov e O N/ STOP s w itc h t o the ON pos ition. Slowly pres s pr imer bulb 6 times. Pull the s tarter rope shar ply 5 times w ith y our right hand. Pull th e star ter ro pe shar ply with your right hand until the engi ne starts. Pull c hoke/fas t idle lever out to the f ull extent (to the FULL C HO KE pos i- tion). ...

  • McCulloch Aug-42 - page 4

    4 S Keep all parts of y our body aw ay from the chain w hen the engine is running. S Keep childr en, by s tanders , and animals a minimum of 10 meters away from the work area. Do not allow other people or animals to be near the c hain s aw w hen star ting or operating the c hain saw. S Do not handle or opera te a chain s aw when you are fa tigued, ...

  • McCulloch Aug-42 - page 5

    5 MAINTAI N YOUR SAW IN G OOD WOR KIN G ORDE R S Hav e all c hain saw s erv ice pe rformed by a qualified s erv ic e dealer wi th the ex c eption of the items lis ted in the maintenance s ec tion of this manual . For ex ample, if impr oper tools are used to remove or hold the flywheel when s erv ic ing the clutc h, s truc tur al damage to the fly w ...

  • McCulloch Aug-42 - page 6

    6 S Do not attempt cuts s tart ing with the tip of the bar (plunge c uts ). S Watch for s hifting logs or other for c es that could c los e a c ut and pinc h or fall into c hain . S Us e t he R educed - - Kic kbac k Guide Bar and Low - - K ick bac k Chain spec ified for your s aw . MAINTAIN CONTROL Never reverse hand positions Stan d to the lef t o ...

  • McCulloch Aug-42 - page 7

    7 ASSE M BL Y Protec tiv e gloves (not pr ovided) s hould be worn during as sembly. A TTA CHIN G THE BUMPER SPI KE (If not already attac hed) The bumper s pike may be us ed as a piv ot when making a c ut. 1. Loosen and r emove bar knob c ompletely by lifting lev er and turning count ercloc k - wis e. Remov e clutc h c ov er . 2. Attach the bumper s ...

  • McCulloch Aug-42 - page 8

    8 CHAIN TENSION (Including unit s with chain a lready inst alled) WAR N I N G : Wear protec tiv e glov es when handl ing chai n. The c hain is s harp and can c ut y ou ev en whe n it is not mov ing. NOTE: When adjus ting c hain tension, make s ure the bar knob is finger tight only. Attempting to tens ion the chain w hen the bar knob is tight can c ...

  • McCulloch Aug-42 - page 9

    9 OPER A T ING YOUR UN IT BEFORE ST ARTING ENGINE WAR N I N G : Be s ure to read the fuel information in the safet y rules before y ou be- gin. If you do not understand the safety rules , do not attempt to f uel your unit. Contact an authoriz ed ser vic e dealer . BAR AND CHAIN LUBRICA TION The bar and c hain require c ontinuous lubri- cation. Lubr ...

  • McCulloch Aug-42 - page 10

    10 OFF HALF CHOKE /F AST IDLE LE VER FULL 6. Pull the star ter rope s harply wit h your right hand until t he engine star ts. 7. Allow the engine to r un for approx imately 30 sec onds. T hen, squeez e and releas e throttle trigger to allow engine to r eturn to idle speed. STARTING A WARM ENG INE 1. Move ON /STOP s witc h to the ON posi- tion. 2. P ...

  • McCulloch Aug-42 - page 11

    11 S Keep the engine at full s peed the entire time you ar e cutt ing. S Allow the c hain to cut for y ou. Ex ert only light downwar d press ure. S Releas e the throttle trigger as s oon as the cut is c ompleted, allowing the en- gine to idle. If you run the saw at full throttle without a c utting load, unnec es- sar y w ear c an occ ur . S T o av ...

  • McCulloch Aug-42 - page 12

    12 Import ant p oints S Cut only one log at a time. S Cut s hattered wood v ery c arefully; shar p pieces of wood could be flung toward oper- ator . S Us e a saw hors e to c ut small logs . Nev er allow anot her per son to hold t he log while cutting and nev er hold the log with y our leg or foot. S Do not c ut in an area where logs , limbs, and r ...

  • McCulloch Aug-42 - page 13

    13 S Be aler t for spr ingback . Watch out for branc hes that are bent or under press ure. Avoid being s truc k by the branch or the saw w hen the tens ion in the wood fibers is releas ed. S Keep a c lear wor k ar ea. F requently clear branc hes out of the way to av oid tripping over them. LIMBING S Alway s limb a tree after it is cut dow n. O nly ...

  • McCulloch Aug-42 - page 14

    14 After eac h us e, ensur e ON /STOP s witc h is in the STOP pos ition, then clean all s awdus t from the guide bar and spr ock et hole. T o maintain guide bar: S Move O N/STOP sw itc h to the STOP po si - tion. S Loosen an d remove b ar nuts an d c hain brak e. Remov e bar and c hain from s aw . S Clean the oil h oles an d bar groove af ter each ...

  • McCulloch Aug-42 - page 15

    15 STOR AGE WAR N I N G : Stop engine and allow to cool, and sec ure the unit before st oring or trans porting in a v ehicle. Store unit and fuel in an area wher e fuel v apors cannot r each spar ks or open flames from water heaters , electr ic motors or switc hes, furnac es, etc. Store unit w ith all guards in place. P osition s o that any s harp ...

  • McCulloch Aug-42 - page 16

    16 DECLAR A T ION OF CONF ORM ITY EC D eclaratio n of C onformi ty (O nly applies to Europe) We, H usqvarna O utdoor Products Italia, S.p.A . , V almadr era, It aly . T el: +39- - 0341 - - 20321 1, dec lare that the c hain saw model McC ull och X-tr e m e 8 -4 2 SAS - - - AV from ser ial numbers 2007 - - 181( N or D) 00001 and onwards (the y ear is ...

  • McCulloch Aug-42 - page 17

    17 TECHNICAL DA TA S HEET Engine X-tre me 8-4 2 Cy linder volume, c m 3 42 Stroke, m m 32 Idle speed, r pm 3,000 Rec ommended max. speed, unloaded, rpm 12,000 Power , kW 1,6 Ignition syst em Manufacturer I IDA T y pe of ignition s y stem Inductiv e Spark plug Champion Elec trode gap, mm 0,5 Fuel and lubri cation system Manufactur er Zama Carbur eto ...

Manufacturer McCulloch Category Chainsaw

Documents that we receive from a manufacturer of a McCulloch Aug-42 can be divided into several groups. They are, among others:
- McCulloch technical drawings
- Aug-42 manuals
- McCulloch product data sheets
- information booklets
- or energy labels McCulloch Aug-42
All of them are important, but the most important information from the point of view of use of the device are in the user manual McCulloch Aug-42.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals McCulloch Aug-42, service manual, brief instructions and user manuals McCulloch Aug-42. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product McCulloch Aug-42.

Similar manuals

A complete manual for the device McCulloch Aug-42, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use McCulloch Aug-42 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of McCulloch Aug-42.

A complete McCulloch manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual McCulloch Aug-42 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the McCulloch Aug-42, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the McCulloch Aug-42, that we can find in the current document
3. Tips how to use the basic functions of the device McCulloch Aug-42 - which should help us in our first steps of using McCulloch Aug-42
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with McCulloch Aug-42
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of McCulloch Aug-42 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning McCulloch Aug-42?

Use the form below

If you did not solve your problem by using a manual McCulloch Aug-42, ask a question using the form below. If a user had a similar problem with McCulloch Aug-42 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)