English dropdown-ico

Manual Sears 390.2514

16 pages 0.7 mb
Download

Go to site of 16

Summary
  • Sears 390.2514 - page 1

    SEARS OWNER'S MANUAL MODEL NO. 390.2514 390.2518 CAUTION: Read and Follow All Safety Rules and Operating Instructions Before First Use of This Product. Save This Manual For Future Reference. I:RRFTSMRN ° PROFESSIONAL "HYDROGLASS ''® SHALLOW WELL JET PUMP • Safety Instructions • Installation • Operation • Troubleshootin ...

  • Sears 390.2514 - page 2

    READ AND FOLLOW SAFETY INSTRUCTIONS! This is the safety aler'c symbol. When you see this symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury: DANGER warns about hazards that will cause serious personal injury, death or major property damage ff ignored. WARNING warn ...

  • Sears 390.2514 - page 3

    CONTENTS Safety .............................................................................................. 2 Warranty/Introduction ................................................................... 3 Pump Performance ........................................................................ 3 Major Components .................................... ...

  • Sears 390.2514 - page 4

    MAJOR COMPONENTS / PIPING MAJOR COMPONENTS AND WHAT THEY DO NOTICE: Use Teflon tape supplied with the pump for making all threaded connections to the pump. Impeller and Jet Impeller turns with motor shaft, causing water to fly out from its rim by centrifugal force. Impeller rotation creates a vacuum which pulls in more water. Part of the water is d ...

  • Sears 390.2514 - page 5

    ELECTRICAL Disconnect power before working on pump, motor, pressure switch, or wiring. Motor Switch Settings If the motor can operate at either 115 or 230 volts, it is set at the factory to 230 volts. Do not change motor voltage setting if line voltage is 230 volts, or if you have a single voltage motor. NOTICE: Never wire a 115 volt motor to a 230 ...

  • Sears 390.2514 - page 6

    ELECTRICAL WIRING CONNECTIONS [_.WARNING_ Fire hazard. Incorrect voltage can cause a fire or seriously damage the motor and voids the warranty. The supply voltage must be within ± 10% of the motor nameplate voltage. NOTICE: Dual-voltage motors are factory wired for 230 volts. If nec- essary, reconnect the motor for 115 volts, as shown. Do not alte ...

  • Sears 390.2514 - page 7

    INSTALLATION / OPERATION INSTALLATION SEARS jet pumps should be used with Captive Air* Tanks (See Figure 7). I_IMINGpLU8 PRESSURE $WITGH TO,_ICE BUILT-IN ( VALVE __. 1-114" pLASTIC pIp_ pLASTIC FtPE ADAPTER* PUMPTOTANK SIDE VIEW ;ApTNE AIF_ TANK Figure 7 For mounting pump to tank, purchase tank fittings Kit No. 2788. SEARS Captive Ai_ Tanks ar ...

  • Sears 390.2514 - page 8

    SERVICE MAINTAINING YOUR PUMP Lubrication It is not necessary to lubricate the pump or its motor. The motor bearings are lubricated for life. The mechanical shaft seal in the pump is water lubricated and self-adjusting. Draining for Winter When the pump is to be disconnected from service, or is in dan- ger of freezing, it must be drained. The pump ...

  • Sears 390.2514 - page 9

    SERVICE C. With finger pressure press seat firmly and squarely into cav- ity. See Figure 12A. Polished face of seat faces inside of pump. If seat will not locate properly, place cardboard washer over polished face and use piece of 3/4" standard pipe for press- hag purposes. See Figure 12B. Figure 12B 483 0194 D. Dispose of cardboard washer and ...

  • Sears 390.2514 - page 10

    REPAIR PARTS 29 28 I 1 / 26 2 3 3A 7 8 lO 25 25A 23 766 1194 22 21 19 20 ]0 ...

  • Sears 390.2514 - page 11

    REPAIR PARTS 1/2 HP 3/4 HP Key Model Model Part No. 390,2514 390.2518 Description 1"* 2 3* 3A 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21" 22 23 24 25* 25A* 26 27 28* 29 J218-953C 17351-0009 WC78-41T L176-47P U9-399 U 109-6A J 105-40PE J1-39P U30-542SS C19-54SS U9-201 N32P-66 N34P-19 N76-29P J20-18 N176-28PB U37-673P U111-212T U9-226 ...

  • Sears 390.2514 - page 12

    TROUBLESHOOTING CHART PROBLEM POSSIBLE CAUSES REMEDIES Motor will not run. 1. Disconnect switch is off. 1. Be sure switch is on. 2. Fuse is blown. 2. Replace fuse. 3. Starting switch is defective. 3. Replace starting switch. 4. Wires at motor are loose, 4. Refer to instroctions on wiring. disconnected, or wired incorrectly. Check and tighten all wi ...

  • Sears 390.2514 - page 13

    13 ...

  • Sears 390.2514 - page 14

    14 ...

  • Sears 390.2514 - page 15

    15 ...

  • Sears 390.2514 - page 16

    SEARS OWNER'S MANUAL MODEL NO. 390.2514 390.2518 The model number of your Shallow Well Jet Pump will be found on the pump body. When requesting service or ordering parts, always give the following information: • Product Type • Model Number • Part Number • Part Description CRRFTSMRW PROFESSIONAL "HYDROGLASS ''® SHALLOW W ...

Manufacturer Sears Category Water Pump

Documents that we receive from a manufacturer of a Sears 390.2514 can be divided into several groups. They are, among others:
- Sears technical drawings
- 390.2514 manuals
- Sears product data sheets
- information booklets
- or energy labels Sears 390.2514
All of them are important, but the most important information from the point of view of use of the device are in the user manual Sears 390.2514.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Sears 390.2514, service manual, brief instructions and user manuals Sears 390.2514. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Sears 390.2514.

Similar manuals

A complete manual for the device Sears 390.2514, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Sears 390.2514 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Sears 390.2514.

A complete Sears manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Sears 390.2514 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Sears 390.2514, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Sears 390.2514, that we can find in the current document
3. Tips how to use the basic functions of the device Sears 390.2514 - which should help us in our first steps of using Sears 390.2514
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Sears 390.2514
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Sears 390.2514 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Sears 390.2514?

Use the form below

If you did not solve your problem by using a manual Sears 390.2514, ask a question using the form below. If a user had a similar problem with Sears 390.2514 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)