Manual Sony Ericsson VPL-PX30

19 pages 0.31 mb
Download

Go to site of 19

Summary
  • Sony Ericsson VPL-PX30 - page 1

    WORLD WORLD WORLD PR O T OCOL MANU AL MODEL .......... VPL-PX20 VPL-PX30 VPL-VW10HT LCD D A T A/VIDEO PROJECT OR .............. DEST. VERSION 1.0 Projector Fir mw are ARC32 VPL-PX20/PX30 LCD DATA PROJECTOR VPL-VW10HT LCD VIDEO PROJECTOR F or General Release ...

  • Sony Ericsson VPL-PX30 - page 2

    WARNING!! AN INSULATED TRANSFORMER SHOULD BE USED DURING ANY SERVICE TO AVOID POSSIBLE SHOCK HAZARD, BECAUSE OF LIVE CHASSIS. THE CHASSIS OF THIS RECEIVER IS DIRECTLY CONNECTED TO THE AC POWER LINE. SAFETY-RELATED COMPONENT WARNING !! COMPONENTS IDENTIFIED BY A ! MARK ON THE SCHEMATIC DIAGRAMS, EXPLODED VIEWS AND IN THE PARTS LIST ARE CRITICAL TO S ...

  • Sony Ericsson VPL-PX30 - page 3

    1 VPL-PX20/PX30 VPL-VW10HT Table of Contents 1. Introduction ....................................................................... 1 2. Communication Specifications ........................................ 2 <RS-232C Communication Signal> .......................................................................... 2 3. Command Block Format .. ...

  • Sony Ericsson VPL-PX30 - page 4

    ...

  • Sony Ericsson VPL-PX30 - page 5

    1 VPL-PX20/PX30 VPL-VW10HT 1. Introduction This protocol manual describes the basic configuration and basic operations of various commands used for projector. Projector can be controlled using the commands in the List of Commands provided in Section 9 “COMMANDS”. Using an external CONTROLLER , etc., inputs can be switched and the power can also ...

  • Sony Ericsson VPL-PX30 - page 6

    2 VPL-PX20/PX30 VPL-VW10HT 2. Communication Specifications <RS-232C Communication Signal> . Full duplex communication channels (Flow control not performed.) . Start-stop synchronism system . Baud rate: 38.4 kbps (bits per second) . The bit configuration is defined as follows. 1 START Bit + 8 DATA Bits + 1 PARITY Bit + 1 STOP Bit EVEN Parity.. ...

  • Sony Ericsson VPL-PX30 - page 7

    3 VPL-PX20/PX30 VPL-VW10HT 3. Command Block Format The code from B0 to B (n) + 2 as described below are transmitted. 1  B0 Start Code 2 SENDER (To) Index 9  Bm + 1 Check SUM 0  Bm + 2 End Code B1 Peripheral Index B2 B3 B4 B5 3 SENDER (From) Index B6 Peripheral Index B7 B8 B9 B10 67 Data Length Total Data Length B16 Data L ...

  • Sony Ericsson VPL-PX30 - page 8

    4 VPL-PX20/PX30 VPL-VW10HT 4. Data of Code 1 1 1 1 1 Start Condition 2 2 2 2 2 INDEX Header / * -- RECEIVER INDEX -- * / / * -- SENDER INDEX -- * / / * -- Command -- * / Note: CMD1 and CMD2 are assigned with different commands for each unit. Consequently, there is no compatibility of commands between units. For details of the commands, refer to the ...

  • Sony Ericsson VPL-PX30 - page 9

    5 VPL-PX20/PX30 VPL-VW10HT 5 5 5 5 5 Data Size 3 Note: Error when 80 to FF hex codes are included. 6 6 6 6 6 Data Bn = B16 + 1 Bm = B16 + Total Data Length 7 7 7 7 7 Check SUM XOR is the exclusive OR. It is as follows when calculated by 1 bit. Taking A XOR B = C; AB C 000 101 011 110 <Example of Calculation> When 0XA5 (165) and 0XA5 (165) are ...

  • Sony Ericsson VPL-PX30 - page 10

    6 VPL-PX20/PX30 VPL-VW10HT 5. Connection <RS-232C Connection> Communication is enabled by the use of a D-Sub 9 Pin cross (reverse) cable. The pin assignment of D-Sub 9 Pin and D-Sub 25 Pin is as follows. Pins indicated as D-Sub 25 Pin are not used. Assured cable length: 15 m (However, assurance may not be applicable for some cables.) The soft ...

  • Sony Ericsson VPL-PX30 - page 11

    7 VPL-PX20/PX30 VPL-VW10HT 6. Communication Procedure 6-1. Outline of Communication All communication between CONTROLLER (PC, etc.) and DEVICE (PROJECTOR) is performed by the command block format. Communication is started by the issue of a command at CONTROLLER and ended when the return data is sent to CONTROLLER after DEVICE receives the command. ...

  • Sony Ericsson VPL-PX30 - page 12

    8 VPL-PX20/PX30 VPL-VW10HT 7. Communication Rules . When sending a command from CONTROLLER, the return data (CMD1 = 10 hex or CMD1 = each category value, CMD2 = 03 hex) from PROJECTOR should be received first before sending the next command. Even if the next command is sent before receiving the return data, since PROJECTOR will not be able to recei ...

  • Sony Ericsson VPL-PX30 - page 13

    9 VPL-PX20/PX30 VPL-VW10HT 8. Approximate Return Waiting Times Note: The times shown in this table are when communication is performed in the condition that it will not be interrupted by some reason. CMD1 00 00 01 01 01 03 03 CMD2 00 01 01 00 01 00 00 DATA1 _  _  00 00 00 00 01 DATA2 ...

  • Sony Ericsson VPL-PX30 - page 14

    ...

  • Sony Ericsson VPL-PX30 - page 15

    11 VPL-PX20/PX30 VPL-VW10HT 11 9. Commands FUNCTION CMD1 CMD2 DATA1 DATA2 PX20/30 VW10 DATA3 DATA4 DATA5 DATA6 DATA7 DATA8 DATA9 Power Status ACK EACH ACK 03h ACK/NAK DATA CATEGORY VALUE 00 ACK 00 DUMMY OO 01 NAK 01 UNDEFINED OO COMMAND 04 SIZE ERROR OO 05 SELECT ERROR OO 06 RANGE OVER OO 0A NOT APPLICABLE OO O __ ___ O O O COMMON COMM NAK COMM ERR ...

  • Sony Ericsson VPL-PX30 - page 16

    12 VPL-PX20/PX30 VPL-VW10HT 12 FUNCTION CMD1 CMD2 DATA1 DATA2 PX20/30 VW10 DATA3 DATA4 DATA5 DATA6 DATA7 DATA8 DATA9 Power Status 00 FIXED 32 INPUT-A OO 02 FIXED 00 FIXED 00 COMPUTER OO 01 COMPONENT OO 02 DTV-YPBPR OO 03 DTV-GBR 00 FIXED 33 INPUT-B O 02 FIXED 00 FIXED 00 COMPUTER O _ ___ __ __ O 01 COMPONENT O 02 DTV-YPBPR O 03 DTV-GBR 00 FIXED 80 ...

  • Sony Ericsson VPL-PX30 - page 17

    13 VPL-PX20/PX30 VPL-VW10HT 13 FUNCTION CMD1 CMD2 DATA1 DATA2 PX20/30 VW10 DATA3 DATA4 DATA5 DATA6 DATA7 DATA8 DATA9 Power Status 00 FIXED 33 INPUT-B O 00 FIXED 00 00 00 03 00 FIXED 00 COMPUTER O __ ___ ___ O 01 COMPONENT O 02 DTV-YPBPR O 03 DTV-GBR 00 FIXED 80 GAIN RED OO 00 FIXED 00 00 00 FF 00 FIXED 00~FF 0~255 O __ ___ O O O 00 FIXED 81 GAIN GR ...

  • Sony Ericsson VPL-PX30 - page 18

    14 VPL-PX20/PX30 VPL-VW10HT 14 FUNCTION CMD1 CMD2 DATA1 DATA2 PX20/30 VW10 DATA3 DATA4 DATA5 DATA6 DATA7 DATA8 DATA9 Power Status MEMORY 03h SET 00h RESET MEMORY NO CATEGORY 00 RESET 01 Channel Memory OO 02 Status Memory OO 03 Set Memory OO SAVE MEMORY NO 01 SAVE 04 W/B ALL OO 05 W/B LOW OO 06 W/B HIGH OO 07 W/B CUSTOM1 O 08 W/B CUSTOM2 O 09 W/B CU ...

  • Sony Ericsson VPL-PX30 - page 19

    15 VPL-PX20/PX30 VPL-VW10HT 15 15Bit Category x0 x1 x2 x3 x4 x5 x6 x7 x8 x9 xA xB xC xD xE xF 0x 1x VOLUME VOLUME AUDIO POWER CONTRAST CONTRAST COLOR COLOR BRITNESS BRITNESS + + + + + _ _ _ _ _ MUTING ON/OFF +_ +_ + _ UP DOWN HIGH LOW HIGH LOW BRIGHT DARK 2x HUE HUE SHARPNESS SHARPNESS PICTURE STATUS STATUS MENU VIDEO INPUT A INPUT B POWER POWER +_ ...

Manufacturer Sony Ericsson Category Projector

Documents that we receive from a manufacturer of a Sony Ericsson VPL-PX30 can be divided into several groups. They are, among others:
- Sony Ericsson technical drawings
- VPL-PX30 manuals
- Sony Ericsson product data sheets
- information booklets
- or energy labels Sony Ericsson VPL-PX30
All of them are important, but the most important information from the point of view of use of the device are in the user manual Sony Ericsson VPL-PX30.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Sony Ericsson VPL-PX30, service manual, brief instructions and user manuals Sony Ericsson VPL-PX30. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Sony Ericsson VPL-PX30.

Similar manuals

A complete manual for the device Sony Ericsson VPL-PX30, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Sony Ericsson VPL-PX30 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Sony Ericsson VPL-PX30.

A complete Sony Ericsson manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Sony Ericsson VPL-PX30 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Sony Ericsson VPL-PX30, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Sony Ericsson VPL-PX30, that we can find in the current document
3. Tips how to use the basic functions of the device Sony Ericsson VPL-PX30 - which should help us in our first steps of using Sony Ericsson VPL-PX30
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Sony Ericsson VPL-PX30
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Sony Ericsson VPL-PX30 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Sony Ericsson VPL-PX30?

Use the form below

If you did not solve your problem by using a manual Sony Ericsson VPL-PX30, ask a question using the form below. If a user had a similar problem with Sony Ericsson VPL-PX30 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)