English dropdown-ico

Manual Amana W10296137A-SP

16 pages 3.85 mb
Download

Go to site of 16

Summary
  • Amana W10296137A-SP - page 1

    1 W10300459A W10296137A-SP DR YER SAFETY ......................................................................... 2 INST ALLA TION REQUIREMENTS ............................................. 3 T ools and Parts ...................................................................... 3 Location Requirements ............................................. ...

  • Amana W10296137A-SP - page 2

    2 DR YER SAFETY You You can be killed or seriously injured if you don't immediately can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Your safety and the safet ...

  • Amana W10296137A-SP - page 3

    3 INST ALLA TION REQUIREMENTS T ools and Parts Gather the requir ed tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Flat-blade screwdriver ■ #2 Phillips head ■ screwdriver Adjustable wrench that ■ opens to 1" (25 mm) or hex-head socket wrench (for adjusting dryer feet) L ...

  • Amana W10296137A-SP - page 4

    4 Installation clearances: The location must be lar ge enough to allow the dryer door to open fully . Dryer Dimensions A B D C 43 3 / 8 " (1102 mm) *26" (660 mm) 29" (737 mm) 15 1 / 4 " (387 mm) 29" (737 mm) *27 3 / 4 " (705 mm) 43 3 / 8 " (1102 mm) 22 3 / 4 " (578 mm) 43 3 / 8 " (1102 mm) *27 3 / 4 &quo ...

  • Amana W10296137A-SP - page 5

    5 Install Leveling Legs W ARNING Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so can result in back or other injury. 1. T o avoid damaging the oor , use a large at piece of cardboar d from the dryer carton. Place car dboard under the entire back edge of the dryer . See illustration. 2. Firmly grasp t ...

  • Amana W10296137A-SP - page 6

    6 Electrical Connection Power Supply Cord W ARNING Fire Hazar d Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wir e) to center terminal (silver). Ground wir e (green or bar e wire) must be connected to green gr ound connector ...

  • Amana W10296137A-SP - page 7

    7 3. Install strain relief. Style 1: Power supply cord strain r elief Remove the screws fr om a 3/4" (19 mm) UL listed strain relief ■ (UL marking on strain relief). Put the tabs of the two clamp sections (C) into the hole (B) below the terminal block opening so that one tab is pointing up (A) and the other is pointing down (D), and hold in ...

  • Amana W10296137A-SP - page 8

    8 3. Connect neutral ground wir e (E) and the neutral wire (C) (white or center wire) of power supply cor d under center , silver -color ed terminal block screw (B). Tighten scr ew . B C E 4. Connect ground wire (F) (gr een or bare) of power supply cor d to external ground conductor screw (A). Tighten scr ew . A F 5. Connect the other power supply ...

  • Amana W10296137A-SP - page 9

    9 4. Tighten strain relief scr ews. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down scr ew . 6. Y ou have completed your electrical connection. Now go to “V enting Requir ements.” 4-wire connection: Dir ect Wire IMPORT ANT : A 4-wire connection is required for mobile homes and where local codes d ...

  • Amana W10296137A-SP - page 10

    10 3-wire connection: Dir ect wire Use where local codes permit connecting cabinet-gr ound conductor to neutral wire. Direct wir e cable must have 5 ft. (1.52 m) of extra length so dryer can be moved if needed. Strip 3½" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If using 3-wire cable with gr ound wire ...

  • Amana W10296137A-SP - page 11

    11 4. Connect the other wires to outer terminal block scr ews. Tighten screws. 5. Tighten strain relief scr ews. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down scr ew . 7. Connect a separate copper wire (G) fr om the external ground conductor screw (A) to an adequate gr ound, as determined by a qual ...

  • Amana W10296137A-SP - page 12

    12 Clamps: Use clamps to seal all joints. ■ Exhaust vent must not be connected or secured with scr ews ■ or other fastening devices that extend into interior of vent and catch lint. Do not use duct tape. Clamp Exhaust: Recommended hood styles. Acceptable hood style. 4" (102 mm) 2 ½" (64 mm) 4" (102 mm) 4" (102 mm) B A C A. ...

  • Amana W10296137A-SP - page 13

    13 Level Dryer Check the levelness of the dryer . Check levelness rst side to side, then front to back. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. NOTE: It might be necessary to level the dryer again after it is moved into its nal position. Connect ...

  • Amana W10296137A-SP - page 14

    14 11. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close the door . If you do not feel heat, turn off dryer , and check the following: There may be 2 household fuses or cir cuit breakers for ■ the dryer . Check that both fuses are intact and tight, or that both circuit b ...

  • Amana W10296137A-SP - page 15

    15 6. Be certain to keep car dboard spacer center ed between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges wer e just removed. 7. Attach door hinges to dryer door so that the lar ger hole is at the bottom of the hinge. 8. Remove door strike (E) from cabinet. Use a small, at-blade screwdriver to gently ...

  • Amana W10296137A-SP - page 16

    16 W10300459A W10296137A-SP © 2009 12/09 All rights reserved Printed in U.S.A. ...

Manufacturer Amana Category Clothes Dryer

Documents that we receive from a manufacturer of a Amana W10296137A-SP can be divided into several groups. They are, among others:
- Amana technical drawings
- W10296137A-SP manuals
- Amana product data sheets
- information booklets
- or energy labels Amana W10296137A-SP
All of them are important, but the most important information from the point of view of use of the device are in the user manual Amana W10296137A-SP.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Amana W10296137A-SP, service manual, brief instructions and user manuals Amana W10296137A-SP. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Amana W10296137A-SP.

Similar manuals

A complete manual for the device Amana W10296137A-SP, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Amana W10296137A-SP by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Amana W10296137A-SP.

A complete Amana manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Amana W10296137A-SP - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Amana W10296137A-SP, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Amana W10296137A-SP, that we can find in the current document
3. Tips how to use the basic functions of the device Amana W10296137A-SP - which should help us in our first steps of using Amana W10296137A-SP
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Amana W10296137A-SP
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Amana W10296137A-SP in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Amana W10296137A-SP?

Use the form below

If you did not solve your problem by using a manual Amana W10296137A-SP, ask a question using the form below. If a user had a similar problem with Amana W10296137A-SP it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)