-
Ubiquiti Networks PBE-5AC-620 - page 1
High-Performance Integrated InnerFeed ™ airMAX ® ac Bridge Model: PBE-5AC-500 ...
-
Ubiquiti Networks PBE-5AC-620 - page 2
Introduction Thank you for purchasing the Ubiquiti Netw orks® PowerBeam ™ . This Quick Start Guide is designed to guide you through the installation, and show you how to access the airOS® Configuration Interface. This Quick Start Guide also includes the warranty terms and is for use with the PowerBeam5ac , modelPBE-5AC-500. Package Contents ...
-
Ubiquiti Networks PBE-5AC-620 - page 3
Hardware Overview Bottom View Cable Door Rear Housing T echnology Ethernet Port Release Button Slot Dish Bracket Release Button Dish Reflector Alignment Pins Reset Button Antenna Feed Radome Reset Button T o reset to factory defaults, press and hold the Reset button for more than 10 seconds while the P owerBeam is already poweredon. Alternativ e ...
-
Ubiquiti Networks PBE-5AC-620 - page 4
Release Button After you assemble the Po werBeam, check the Release button; it should be fully engaged in the Release Button Slot of the Rear Housing . This ensures that the Antenna Feed is locked into place . If you need to remove the Antenna Feed , you must depr ess the Release button first. LEDs Signal The default values are shown below: LED wil ...
-
Ubiquiti Networks PBE-5AC-620 - page 5
Application Examples The Pow erBeam mounted outdoors with the Dish Reflector installed provides directional outdoor cover age (gain is reflector-dependent). The Pow erBeam mounted outdoors without the Dish Reflector installed provides outdoor-to-indoor cov erage using the 3 dBi Antenna Feed only . Installation Requirements • 13 mm wrench • Shie ...
-
Ubiquiti Networks PBE-5AC-620 - page 6
Installation 1. Align and insert the tabs of the Dish Bracket into the slots of the Dish Reflector . Rotate the Dish Bracket counter-clockwise until the tabs lock into place. 20 10 10 0 2. Line up the Alignment Pins of the Rear Housing with the alignment holes of the Dish Bracket . Insert the pins and push until they lock intoplace. 20 10 10 0 * ...
-
Ubiquiti Networks PBE-5AC-620 - page 7
3. Push in the sides of the Cable Door and detach it from the Rear Housing . 20 10 0 10 4. Attach the Antenna Feed : a. I nsert the Antenna Feed into the Rear Housing , and push until it locks into place with a click. b. Lightly pull the Antenna Feed to ensure that it is locked into place and the Release button is fully engaged. Release Button Bott ...
-
Ubiquiti Networks PBE-5AC-620 - page 8
5. Connect the Ethernet cable: a. Connect an Ethe rnet cable to the Ethernet Port of the Antenna Feed . b. Re-attach the Cable Door to the Rear Housing . 20 10 0 10 6. Slide the Pole Clamp onto the Dish Brack et . 20 10 10 0 ...
-
Ubiquiti Networks PBE-5AC-620 - page 9
7. Insert the U-Bolt into the Pole Clamp and Dish Brack et . Secure each end of the U-Bolt with a Flange Nut. 20 10 10 0 25 N-m Note: The mounting assembly can accommodate a Ø 32 - 56 mm pole. 8. Align the arrows on the bott oms of the Radome and Dish Reflector so the Drain Holes on the Radome point downward . Snap the Radome onto the Dish Reflect ...
-
Ubiquiti Networks PBE-5AC-620 - page 10
9. Connect the other end of the Ethernet cable from the PowerBeam t o the Ethernet port labeled POE on the Gigabit PoEAdapter . 10. Connect an Ethernet cable from your LAN or computer to the Ethernet port labeled LAN on the Gigabit PoE Adapter . 11. Connect the Power Cord to the pow er port on the Gigabit PoE Adapter . C onnect the other end of ...
-
Ubiquiti Networks PBE-5AC-620 - page 11
Accessing airOS Verify c onnectivity in the airOS Configuration Interface. 1. Make sure that your host machine is connected via Ethernet to the Po werBeam. 2. Configure the Ethernet adapter on your host syst em with a static IP address on the 192.168.1.x subnet. 3. Launch your web browser and type https://192.168.1.20 in the address field. P ress e ...
-
Ubiquiti Networks PBE-5AC-620 - page 12
Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer's responsibility to make sure the device is operated within local country regulatory requirements. The Output Power field is provided t o the professional installer to assist in meeting regulatory requirements. ...
-
Ubiquiti Networks PBE-5AC-620 - page 13
Specifications PowerBeam PBE-5A C-500 Dimensions Radome Excluded Radome Included 520 x 520 x 308 mm (20.47 x 20.47 x 12.13") 525 x 525 x 315 mm (20.67 x 20.67 x 12.40") Weight Radome Excluded Radome Included 2.35 kg (5.18 lb) 3.15 kg (6.95 lb) Operating Frequency Worldwide: 5150 - 5875 MHz USA: 5725 - 5850 MHz Gain 27 dBi Networking Inter ...
-
Ubiquiti Networks PBE-5AC-620 - page 14
Safety Notices 1. Read, follow , and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer . W ARNING: Do not use this product in location that can be submerged by water . W ARNING: A void using this product during an electrical storm. There may be a remote risk of electric shock from light ...
-
Ubiquiti Networks PBE-5AC-620 - page 15
Limited W arranty UBIQUITI NETWORKS, Inc (“UBIQUITI NET WORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation. UBIQUITI NETWORKS’ sole and exclusive obligat ...
-
Ubiquiti Networks PBE-5AC-620 - page 16
Disclaimer EXCEPT FOR ANY EXPRESS W ARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND IT S AND THEIR THIRD P ARTY DA T A, SERVICE, SOFTWARE AND HARDW ARE PROVIDERS HEREBY DISCLAIM AND MAKE NO OTHER REPRESENT A TION OR WARRANTY OF ANY KIND, EXPRESS, IMPLIED OR ST A TUTORY , INCL UDING, BUT NOT LIMITED TO, REPRESENT A TIONS, GUARANTEE ...
-
Ubiquiti Networks PBE-5AC-620 - page 17
Note Some countries, states and provinces do not allo w exclusions of implied warranties or conditions, so the abov e exclusion may not apply to you . Y ou may have other rights that vary from country to country, state to state, or province t o province. Some countries , states and provinces do not allow the exclusion or limitation of liability for ...
-
Ubiquiti Networks PBE-5AC-620 - page 18
This radio transmitter FCC ID: SWX-NBEM5A C has been approved by FCC to operate with the antenna types listed belo w with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain gr eater than the maximum gain indicated for that type, are strictly prohibited ...
-
Ubiquiti Networks PBE-5AC-620 - page 19
Les utilisateurs devraient également noter que radars haute puissants sont alloués comme principaux utilisateurs (c’est-à-dire les utilisateurs de priorité) des bandes et 5650 à 5850 MHz et que ces radars pourraient causer des interférences ou dommages aux dispositifs LAN. Cet émetteur radio (IC: 6545A-NBEM5AC) a été approuvée par Indus ...
-
Ubiquiti Networks PBE-5AC-620 - page 20
RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dis ...
-
Ubiquiti Networks PBE-5AC-620 - page 21
Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación. Es responsabil ...
-
Ubiquiti Networks PBE-5AC-620 - page 22
Declaration of Conformity Česky [Czech] UBIQUITI NET WORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NET WORKS erklærer herved, at følgende udstyr UBIQUITI NET WORKS device, overholder de væsentlige krav ...
-
Ubiquiti Networks PBE-5AC-620 - page 23
Italiano [Italian] Con la presente UBIQUITI NETWORKS dichiara che questo UBIQUITI NET WORKS device, è conforme ai requisiti essenziali ed alle altr e disposizioni pertinenti stabilite dalla direttiva 1999/5/CE. Latviski [Latvian] Ar o UBIQUITI NETWORKS dek lar , ka UBIQUITI NET WORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citi ...
-
Ubiquiti Networks PBE-5AC-620 - page 24
www .ubnt.com ©2013-2014 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo , airMAX, airOS, InnerFeed, P owerBeam, and TOUGHCable are trademarks or registered trademarks of UbiquitiNetworks, Inc. in the United States and in other countries. All other trademarks are the prope ...
У вас вопрос, касающийся Ubiquiti Networks PBE-5AC-620?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Ubiquiti Networks PBE-5AC-620, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Ubiquiti Networks PBE-5AC-620 со всей вероятностью он захочет поделиться методом ее решения.