Инструкция обслуживания Alpine TDM-7574E

19 страниц 0.45 mb
Скачать

Перейти на страницу of 19

Summary
  • Alpine TDM-7574E - page 1

    EN DE FR ES IT SE R R ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel.: (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U.S.A. Tel.: 1-800-ALPINE-1 (1-800-257-4631) ALPINE ELECTRONICS OF CANADA, INC. Suite 203, 7300 Warden Ave. Markham, Ontario ...

  • Alpine TDM-7574E - page 2

    ...

  • Alpine TDM-7574E - page 3

    1 -EN Contents Operating Instr uctions W ARNING W ARNING .................................................. 2 CA UTION ................................................... 2 PRECA UTIONS ......................................... 2 Basic Operation Detaching the Front Panel .................................. 4 Attaching the Front Panel ............... ...

  • Alpine TDM-7574E - page 4

    2 -EN WARNING The e xclamation point within an equilateral triangle and "W ARNING" are intended to aler t the user to the presence of impor tant operating instructions. F ailure to heed the instructions will result in se vere injur y or death. DO NOT DISASSEMBLE OR AL TER. Doing so may lead to accident, fire or electric shock. KEEP SMALL ...

  • Alpine TDM-7574E - page 5

    3 -EN T ape Head Cleaning Periodic cleaning (approximately every 20 hours of use) of the tape head with a wet type head-cleaning cassette tape (available at audio stores) is necessary for best performance. Fuse Replacement When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder . If the fuse blows more t ...

  • Alpine TDM-7574E - page 6

    4 -EN Basic Operation Detaching the Fr ont P anel 1 Press the PWR (P ower) b utton to tur n off the power . 2 Press the (Release) button until the front panel pops out. 3 Grasp the left side of the front panel and pull it out. NO TES • The front panel may become hot (especially the connector terminals). This is not a malfunction. • T o pr otect ...

  • Alpine TDM-7574E - page 7

    5 -EN 2 Press and hold the A.S.U . (Automatic Setup) button f or at least 3 seconds to activate the A.S.U . mode. "ASU" blinks in the displa y . The unit automatically perf or ms the follo wing operations. 1. Activates the A uto Memor y mode. 2. Gradually sets the Bass, T reb le, Balance and F ader controls to their center positions. 3. G ...

  • Alpine TDM-7574E - page 8

    6 -EN 4 Press the DN g or f UP button to automatically seek f or a station downward or upward respectiv ely . The unit will stop on the ne xt station it finds. Press the same button again to seek the ne xt station. Manual Storing of Station Presets 1 Select the radio band and tune in a desired radio station you wish to store in the preset memory . ...

  • Alpine TDM-7574E - page 9

    7 -EN A utomatic Memory of Station Presets 1 Press the SOURCE button until the r adio frequency appears in the displa y . 2 Press the BAND button repeatedly until the desired radio band is displa yed. Each press changes the radio bands as f ollows: → F1 → F2 → AM 3 Press and hold the A. ME button f or at least 2 seconds. The frequency on the ...

  • Alpine TDM-7574E - page 10

    8 -EN Inser ting/Ejecting Cassette 1 Inser t a cassette tape into the slot with the open side f acing r ight. When the cassette is loaded, the pla yer automatically star ts tape pla yback and indicates "T APE" in the display . 2 Press the Eject ( c ) button when y ou want to eject the cassette tape. NOTES • When power is turned off or t ...

  • Alpine TDM-7574E - page 11

    9 -EN F ast Forward and Re wind 1 Press the DN g or f UP button during tape pla y to fast rewind or f orward the tape respectively . The tape side indicator or blinks indicating the direction of the tape. When the end of the tape is reached in the f ast rewind mode, the pla yer stops automatically and begins pla ying from the beginning of the same ...

  • Alpine TDM-7574E - page 12

    10 -EN Contr olling CD Chang er (Optional) The CD controls on the TDM-7574E will function only when a CD Changer (M-Bus) is connected. 1 Press the SOURCE button to activ ate the CD Changer . The display sho ws the disc number and trac k number . NOTE T o start play or pause playback, pr ess the : / J button. 2 When a 6-disc CD Changer is connected: ...

  • Alpine TDM-7574E - page 13

    11 -EN M.I.X. (Random) Pla y 1 Press and hold the M.I.X. button in CD pla y for at least 2 seconds to turn on the M.I.X. mode. When this mode is turned on, the tracks on the currently pla ying disc will be played bac k in a random sequence. T o cancel the M.I.X. mode, press and hold the M.I.X. button f or at least 2 seconds. The M.I.X. indicator di ...

  • Alpine TDM-7574E - page 14

    12 -EN Inf or mation CD CD Changer not functioning. • Out of operating temperature range +50˚C (+120˚F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool. CD playbac k sound is wavering. • Moisture condensation in the CD Module. - Allow enough time for the condensation to evaporate (about 1 hour). Unable to fast f orw ...

  • Alpine TDM-7574E - page 15

    13 -EN Indication for CD Changer • Protective circuit is activated due to high temperature. - The indicator will disappear when the temperature returns to within operation range. • Malfunction in the CD Changer . - Consult your Alpine dealer . Press the magazine eject button and pull out the magazine. Check the indication. Insert the magazine a ...

  • Alpine TDM-7574E - page 16

    14 -EN Installation and Connections Before installing or connecting the unit, please read the follo wing and pages 2 and 3 of this manual thor oughly for pr oper use . W arning USE ONL Y VEHICLES WITH A 12 VOL T NEGA TIVE (–) GROUND. Check with your dealer if you are not sure. Failure to do so may result in fire or electric shock. BEFORE WIRING, ...

  • Alpine TDM-7574E - page 17

    15 -EN 3 Slide the TDM-7574E into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashbo ...

  • Alpine TDM-7574E - page 18

    16 -EN Installation and Connections Connections Antenna To power antenna To amplifier or equaliser Ignition Key Front right Rear right CD Changer (Sold Separately) Speakers Amplifier Rear left Front left Battery TDM-7574E A DIN Connector PIN Configuration. Grey SPEAKER RIGHT FRONT Blue POWER ANT REMOTE TURN-ON Red IGNITION Y ellow BATTER Y Black GN ...

  • Alpine TDM-7574E - page 19

    17 -EN 1 Antenna Receptacle 2 Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicab le. NOTE This lead should be used only for contr olling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal pr ocessor , etc. 3 Remote Turn-On Lead (Blue/White) Connect this lead to t ...

Производитель Alpine Категория Cassette Player

Документы, которые мы получаем от производителя устройства Alpine TDM-7574E мы можем разделить на несколько групп. Это в частности:
- технические чертежи Alpine
- инструкции обслуживания TDM-7574E
- паспорта изделия Alpine
- информационные брошюры
- энергетические этикетки Alpine TDM-7574E
Все из них важны, однако самую важную информацию с точки зрения пользователя мы найдем в инструкции обслуживания Alpine TDM-7574E.

Группа документов, определяемая как инструкции обслуживания, делится также на более подробные типы, такие как: Инструкции монтажа Alpine TDM-7574E, инструкции обслуживания, короткие инструкции или инструкции пользователя Alpine TDM-7574E. В зависимости от потребностей, Вам необходимо поискать требуемый документ. На нашем сайте Вы можете просмотреть самую популярную инструкцию использования изделия Alpine TDM-7574E.

Похожие инструкции обслуживания

Полная инструкция обслуживания устройства Alpine TDM-7574E, как должна выглядеть?
Инструкция обслуживания, определяемая также как пособие пользователя, или просто "руководство" - это технический документ, цель которого заключается в использовании Alpine TDM-7574E пользователями. Инструкции пишет, как правило технический писатель, языком, доступным для всех пользователей Alpine TDM-7574E.

Полная инструкция обслуживания Alpine, должна заключать несколько основных элементов. Часть из них менее важная, как например: обложка / титульный лист или авторские страницы. Однако остальная часть, должна дать нам важную с точки зрения пользователя информацию.

1. Вступление и рекомендации, как пользоваться инструкцией Alpine TDM-7574E - В начале каждой инструкции, необходимо найти указания, как пользоваться данным пособием. Здесь должна находится информация, касающаяся местонахождения содержания Alpine TDM-7574E, FAQ и самых распространенных проблем - то есть мест, которые чаще всего ищут пользователи в каждой инструкции обслуживания
2. Содержание - индекс всех советов, касающихся Alpine TDM-7574E, которое найдем в данном документе
3. Советы по использованию основных функций устройства Alpine TDM-7574E - которые должны облегчить нам первые шаги во время использования Alpine TDM-7574E
4. Troubleshooting - систематизированный ряд действия, который поможет нам диагностировать а в дальнейшем очередность решения важнейших проблем Alpine TDM-7574E
5. FAQ - чаще всего задаваемые вопросы
6. Контактные данные Информация о том, где искать контактные данные производителя / сервисного центра Alpine TDM-7574E в данной стране, если самостоятельно не получится решить проблему.

У вас вопрос, касающийся Alpine TDM-7574E?

Воспользуйтесь формуляром, находящимся ниже

Если с помощью найденной инструкции Вы не решили свою проблему с Alpine TDM-7574E, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Alpine TDM-7574E со всей вероятностью он захочет поделиться методом ее решения.

Перепишите текст с картинки

Комментарии (0)