SPECIFICA TIONS Number of Wheels: 2 F ront, 1 Rear Wheel Diameter : 3/4" F ront, 5/16" Rear Signal: 26.995 mHz Dual, F ront Mounted DC Motors Wingspan: 13-7/8" T ail Wingspan: 5-7/8" Propeller Size: 2-3/8" Diameter 2-Channel T ransmitter Overall Length: 11-1/2" Weight: 1-1/2 LBS. Overall Height: 4-1/ 4" Flight Tim ...
Harbor Freight Tools 95149 - page 3
12. Before fl ying: P erf or m a distance check to be cer tain that you can maintain r adio control at least 25’ from T r ansmitter to Air plane with the Antenna collapsed. 13. Do not trim the Airplane’ s Antenna. T rimming the Antenna would affect the control range . 14. NiCad Batteries must be disposed of pr operly . Do not incinerate . Batte ...
Harbor Freight Tools 95149 - page 4
ASSEMBL Y 1. Carefully push the T ail Landing Gear (6) into its slot, being careful not to prick a finger on the end of the gear wire. See Figure 1. Figure 1 Figure 2 2. Hold the Fuselage (4) with the bottom side up in one hand and carefully push the Main Landing Gear (5) into the slot provided. T uck Battery (8) into Batter y Compar tment (12) bei ...
Harbor Freight Tools 95149 - page 5
Figure 3A Figure 3B 4. While holding the Fuselage (4) in one hand, gently slide the T ail Wing (7) into the slot on the Rudder (13) using an easy back and f or th motion. See Figure 4. Figure 4 5. Bef ore Flight T est, cover the Fuselage Battery Compar tment (12) with the Batter y Compar tment Cover (9). SKU 95149 - F or technical questions, please ...
Harbor Freight Tools 95149 - page 6
TRANSMITTER/B A TTER Y CHARGER ASSEMBL Y 1. Attach Antenna (14) by threading it into the top of the T ransmitter/Batter y Charger (15). See Figure 5. 2. Note how the F emale Battery Connector (3B) connects to the T r ansmitter/Batter y Charger (15) in order to recharge. See Figure 5. Figure 5 Figure 6 3. Remov e T ransmitter Batter y Compar tment C ...
Harbor Freight Tools 95149 - page 7
CHARGING When the Red LED light flashes, it is time to recharge the batteries. T o char ge Rechargeable Batteries: T ur n the T ransmitter P ower Switch to OFF . Remov e the Batter y (8) through the bottom of the Fuselage (4). Plug the Female Batter y Connector (3B) into the por t on the back of the T ransmitter/Batter y Charger (15). See Figure 5. ...
Harbor Freight Tools 95149 - page 8
ASSEMBL Y DIA GRAM P ar t number 15, the T ransmitter/Battery Charger and par t number 16, the T r ansmitter Battery Compar tment Cover are not sho wn in the above Assemb ly Diagram. NO TE: Some par ts are listed for illustration purposes only , and are not av ailable individually as replacement par ts. A TT A CH RECEIPT OR COPY OF RECEIPT T O THIS ...
