0.64 mb

of 10

Summary
  • Kenwood KAC-X811D - page 1

    KA C-X811D KA C-PS811D SUBWOOFER PO WER AMPLIFIER 7 page 2-9 INSTR UCTION MANU AL © B64-2794-00/00 (MV) 3.KAC-X811D_M_1US.indd 04.1.9, 2:17 PM 1 ...

  • Kenwood KAC-X811D - page 2

    2 English Sa fety pre cautions 2 W ARNING T o prevent injury or fire, take the following precautions: • When extending the ignition, batter y, or ground wires, mak e sure to use automotive- grade wires or other wires with a 8 mm² (A WG 8) or more to prevent wire deterioration and damage to the wire coating. • T o prevent a short circuit, ne ve ...

  • Kenwood KAC-X811D - page 3

    English 3                        ? ...

  • Kenwood KAC-X811D - page 4

    4 English                  �             Connection CENTER UNIT (CD receiver , etc.) RCA cable ground terminal RCA cable* Lead terminal* Battery Ground wire* * Commerci ...

  • Kenwood KAC-X811D - page 5

    English 5 Controls 1 Fuse (25 A × 3) 2 Battery terminal 3 Ground terminal 4 Pow er control terminal Controls the unit ON/OFF . NOTE Controls the unit power . Be sure to connect it with all the systems. 5 Speaker output t erminals As this unit accepts speakers with a minimum impedance of 1 ohm, connect speakers with 1-ohm or higher impedance to the ...

  • Kenwood KAC-X811D - page 6

    6 English                        ? ...

  • Kenwood KAC-X811D - page 7

    English 7 Con trol an Amp from Center Unit Y ou can control the sound by controlling amplifiers from the Center Unit. 1 Enter AMP Control mode Select the AMP Control mode by following the ' AMP Control' procedure given on the Operation Manual of the Center Unit. NOTE Use the set item and value operation buttons by f ollowing the instructi ...

  • Kenwood KAC-X811D - page 8

    8 English The acoustic properties of vehicle compartment tend to cause oscillation due to resonance or unclearness of sound due to standing waves at certain frequencies. The band reject filter can solve the problems of r esonance or unclear sound with minimum influence on the sound quality because it eliminates only the frequencies causing resonanc ...

  • Kenwood KAC-X811D - page 9

    English 9 Specifications Specifications subject to change without notice. Audio Section ......................................................................................................................................... KAC-X811D RMS Power Output (+B = 14.4 V , CEA-2006) (4 Ω) (1.0 % THD+N) .................................................. ...

  • Kenwood KAC-X811D - page 10

    3.KAC-X811D_M_1US.indd 04.1.9, 2:18 PM 10 ...

Kenwood Speaker

:
-
-
-
-
-






1.
2.
3.
4.
5.
6.

Captcha

(0)