Bedienungsanleitung Sherwood AX-5103

13 Seiten 0.71 mb
Download

Zur Seite of 13

Summary
  • Sherwood AX-5103 - page 1

    Caution regarding placement (Except for U.S.A. and Canada) To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below. Left and right panels : 5 cm Rear panel : 10 cm Top panel : 20 cm Congratulations on Your Purchase! Your new high fideli ...

  • Sherwood AX-5103 - page 2

    3 READ THIS BEFORE OPERA TING Y OUR UNIT Units shipped to the U.S.A and Canada are designed for operation on 120 Volts AC only. Observe all safety precaution for use of a polarized AC plug. However, some products may be supplied with a non polarized plug. CAUTION : To prevent electric shock, match wide blade of plug to wide slot, insert fully. FOR ...

  • Sherwood AX-5103 - page 3

    4 CONTENTS Introduction • UNPACKING AND INSTALLATION | 2 • READ THIS BEFORE OPERATING YOUR UNIT | 3 System Connections | 5 Front Panel Controls | 7 DIGI LINK III System Remote Controls | 8 • REMOTE CONTROL OPERATION RANGE | 9 • LOADING BATTERIES | 9 Operations • LISTENING TO A PROGRAM SOURCE | 10 • RECORDING | 12 Troubleshooting Guide | ...

  • Sherwood AX-5103 - page 4

    5 ENGLISH AC OUTLET 230V~50Hz SWITCHED 100W(0.43A) MAX. AC INPUT 230V~50Hz 190W PHONO CD TUNER TAPE 1 /MD IN OUT IN OUT TAPE 2 MONITOR DIGI LINK SPEAKER A SPEAKER B AVIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. WARNING : SHOCK HAZARD-DO NOT OPEN. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIST ...

  • Sherwood AX-5103 - page 5

    6 AC OUTLET 230V~50Hz SWITCHED 100W(0.43A) MAX. AC INPUT 230V~50Hz 190W PHONO CD TUNER TAPE 1 /MD IN OUT IN OUT TAPE 2 MONITOR DIGI LINK SPEAKER A SPEAKER B AVIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. WARNING : SHOCK HAZARD-DO NOT OPEN. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. GND ...

  • Sherwood AX-5103 - page 6

     BALANCE CONTROL KNOB Adjust the stereo balance between left and right speakers. • The center position is the normal condition.  TONE DIRECT SWITCH Press this switch to bypass the tone (bass and treble) circuitry for pure sound.  LOUDNESS SWITCH Press this switch to emphasize the sound of frequencies that are difficult to hear at low vol ...

  • Sherwood AX-5103 - page 7

    8 DIGI LINK III System Remote Controls • You can remotely control not only this amplifier but also Sherwood compatible components bearing the DIGI LINK II or III logo . • For system remote control operation, first make the DIGI LINK connections. • In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD player or tape deck, CD ...

  • Sherwood AX-5103 - page 8

    REMO TE CONTROL OPERA TION RANGE 9 LO ADING B A TTERIES Remove the cover. 1 Load two batteries matching the polarity. 2 • Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. • Remove the batteries when they are not used for a long time. • Do not use the rechargeabl ...

  • Sherwood AX-5103 - page 9

    Operations LISTENING T O A PROGRAM SOUR CE 10 Before operation In the standby mode, turn the power on. 1 Select the desired input source. 3 Switch the desired speakers on. 2 • Enter the standby mode. • The STANDBY indicator lights up. This means that the amplifier is not disconnected from the AC mains and a small amount of current is retained t ...

  • Sherwood AX-5103 - page 10

    11 Operate the selected component for playback. 4 Adjust the volume to a comfortable listening level. 5 To emphasize the sound of frequencies that are difficult to hear at low volume levels. 8 To listen to a program source without the tone effect. 9 Adjust the tone (bass and treble). 6 To mute the sound temporarily. 10 To listen with the headphones ...

  • Sherwood AX-5103 - page 11

    12 RECORDING Select the desired input as recording source except for TAPE 1/MD and TAPE 2 MONITOR. 1 Select the desired input as recording source except for TAPE 2 MONITOR. 1 Start recording on the tape deck or the MD recorder connected to TAPE 1/MD. 2 Set the TAPE 2 MONITOR button to on. 2 Start play on the desired input. 3 Stat recording on the t ...

  • Sherwood AX-5103 - page 12

    13 T roubleshooting Guide If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our service organization. PROBLEM POSSIBLE CAUSE REMEDY No power No sound No recording • The AC input cord is disconnected • Poor connection at AC wall outlet or the outlet ...

  • Sherwood AX-5103 - page 13

    14 Specifications • Power output, 8 Ω , THD 0.3 %, 40 Hz  20 kHz | 2 X 100 W • Total harmonic distortion, 8 Ω , 100 W, 1 kHz | 0.03 % • Intermodulation distortion 60 Hz : 7 kHz = 4 : 1 SMPTE, 8 Ω , 100 W | 0.05 % • Input sensitivity, 47 k Ω PHONO (MM) | 3.0 mV CD, TUNER, TAPE | 200 mV • Phono input overload, THD 0.5 %, 1 kHz | 200 ...

Produzent Sherwood Kategorie Stereo Amplifier

Dokumente, die wir vom Produzenten des Geräts Sherwood AX-5103 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Sherwood
- Bedienungsanleitungen AX-5103
- Produktkarten Sherwood
- Informationsbroschüren
- oder Energieetiketten Sherwood AX-5103
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Sherwood AX-5103.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Sherwood AX-5103, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Sherwood AX-5103. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Sherwood AX-5103 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Sherwood AX-5103, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Sherwood AX-5103 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Sherwood AX-5103 verständlich ist.

Eine gänzliche Bedienungsanleitung von Sherwood sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Sherwood AX-5103 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Sherwood AX-5103 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Sherwood AX-5103, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Sherwood AX-5103 - die uns die ersten Schritte während der Nutzung von Sherwood AX-5103 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Sherwood AX-5103 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Sherwood AX-5103 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Sherwood AX-5103?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sherwood AX-5103 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sherwood AX-5103 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)