-
U-Line SP18 - page 1
® MANU AL DEFROST COMBO ® MODELS ICE MAKERS CO29 CO1175 USE AND CARE GUIDE SP18 BI95 BI2115 BI98 U-LINE.COM The Built-In Under counter Leader Since 1962 ...
-
U-Line SP18 - page 2
Introduction to U-Line FOR PRODUCT ASSIST ANCE, CALL 1-800-779-2547 MIL WAUKEE, WI U.S.A. Serial/Serie: Model/Modele: HIGH SIDE DESIGN PRESSURE 300 PSI LOW SIDE DESIGN PRESSURE 140 PSI REFRIGERA TOR AND/ BTL LISTED 674R OR FREEZER HOUSEHOLD U C L R US www .u-line.com 1 2 Intr oduction Congratulations on y our purchase of a U-Line r e frigeration pr ...
-
U-Line SP18 - page 3
U-Line Use and Care Guide ii ...
-
U-Line SP18 - page 4
1 U-Line Use and Care Table of Contents i - Introduction .......................... .................... ..................... .......................... ................. ................... .................... ............ i Read and save this Use and Care Guide. ..................... ..................... .......................... ............ ...
-
U-Line SP18 - page 5
U-Line Safety Precautions 2 IMPOR T ANT IMPOR T ANT • PLEASE READ all instru ctions befor e installing, operating, or servicing the appliance. • Proper installation pr ocedures must be follo wed when completing an instal lation or relocation of a unit. Consult the installation guide b efor e any installation begins. U-Line contact inform ation ...
-
U-Line SP18 - page 6
3 U-Line Combo Model and Ice MakerProduct Fea tures 3 Pr oduct Featur es Ice Mak ers Featur e: High ice production and storage. BI2115 and BI98 models pr oduce up to 25 pounds of ice per da y and store 25 pounds. BI95 and SP18 models pr oduce up to 23 pounds of ice per da y and store 12 pounds. Combo ® Models pr oduce up to 18 pounds of ice per da ...
-
U-Line SP18 - page 7
U-Line Product Operation 4 OFF ON 1 Pr oduct Operation T o turn the unit on or off: Press the r ocker sw itch located below the temperature contr ol dial in the center of the grille (2), inside the door on t he fro nt panel, or behind the grille. IMPOR T ANT IMPOR T ANT On ice maker equipped units, it is possible that dir t or scale will dislodg e ...
-
U-Line SP18 - page 8
5 U-Line Product Operation T o check the actual pr oduct temperatur e in the unit. 1. Partially fill a plastic (non breakable) b ottle with water . 2. In sert an accurate thermometer . 3. Tighten the bottle ca p secur ely . 4. Place the bottle in the de sire d area f or 24 hours. 5. Avoid opening the unit during the testi ng period. 6. Aft er 24 ho ...
-
U-Line SP18 - page 9
U-Line Ice Makers 6 OFF ON 2 1 5I c e M a k e r Ice Mak er Adjustment Ice Cube Thickness Adjustment. Inter val - A s Required On ice mak er equipped models, adjust the cube size by changing water amount injected into the ice mak er assembly as follows: T o turn off ice production: Raise the bin arm into an upright and lock ed position. The unit w i ...
-
U-Line SP18 - page 10
7 U-Line Combo® Models and Ice Mak ers Maintenance 1 6 Maintenance For Models with adjustable lev eling feet: 1. Use a level to check the levelness of the uni t from fr ont to back and from side to side . Place th e le ve l along top edge and sid e edge as show n (1). 2. If the unit is not lev el, rotate the adjustabl e lev eling legs to raise or ...
-
U-Line SP18 - page 11
U-Line Combo® Models and Ice Mak ers Maintenance 8 1 2 4 Remo ving and Installing Door Shelves For models equpped with door shelv es: To r e m o v e t h e d o o r s h e l f : 1. Grasp shelf in center , and lift until the she lf notches (1) clear the pins (2). 2. Carefully pull the shelf awa y from the door . T o install the door s helf: 1. Holding ...
-
U-Line SP18 - page 12
9 U-Line Standard Door Alignment and Reversal 7 Standard Doors Door Alignment and Adjustment Align and adjust the door if it is not lev el, or is not sealing prope rly . If the door is not sealed the unit ma y not cool properl y , or excessiv e fr ost ma y form in the interior . IMPOR T ANT IMPOR T ANT Properly aligned, the door’ s gasket should ...
-
U-Line SP18 - page 13
U-Line Standrd Door Alignment and Reversal 10 Install bottom hing e: 1. If you ha ve a plate hinge, reorient the pivot scr ew so it pr otrudes the opposite dir ection form the hinge. Remove the pivot scre w from the hinge. T urn the plate ov er and reinstall the scre w . 2. Al ign hinge outer ed ge with cabinet. For models with a plate hinge , the ...
-
U-Line SP18 - page 14
11 U-Line Self-Closing Door Alignment and Reversal 1/8" (3.175 mm) 1 23 4 8 Self-Closing Doors Door Alignment and Adjustment Align and adjust the door if it is not lev el, or is not sealing prope rly . If the door is not sealed the unit ma y not cool properl y , or excessiv e fr ost ma y form in the interior . IMPOR T ANT IMPOR T ANT • Prope ...
-
U-Line SP18 - page 15
U-Line Self-Closing Door Alignment and Reversal 12 3 4 ULI 5 NO TCH 1 2 T o re verse the door: Remo ve door : 1. Hold door to k eep it fr om falling. 2. Remove hinge screw pin (1) from top hinge using a Phillips scre wdriver . 3. Remov e door b y tilting f orwar d and liftin g door off bo ttom hinge closer inser ts. 4. Reinstall hinge scr ew pin (1 ...
-
U-Line SP18 - page 16
13 U-Line Combo® Models and Ice Mak ers Cleaning To d e f r o s t : 1. Disconnect po wer to the unit. 2. For combo mode ls remov e all products from the interior . 3. Remove ice buck et and discard ice. 4. Pl ace towel or other absorbent materialon bottom of ice bin. For combo models also place i n bottom of unit. 5. Fill the ice buck et half full ...
-
U-Line SP18 - page 17
U-Line Combo® Models and Ice Mak ersCleaning 14 Condensor Cleaning Interv al - Every Six Months T o maintain ope rational effici ency , keep the fr ont grille free of dust and lint, and clean the condenser ev er y three months. Depending on envir onmental conditions, mor e or less fr equent cleaning ma y be necessary . WA R N I N G Disconnect elec ...
-
U-Line SP18 - page 18
15 U-Line Combo® Models and Ice Mak ers Service 10 Ser vice Prob lem P ossible Ca use and Remedy Interior Light Does Not Illuminate. The light bulb ma y be defective.(See MAINTENA CE) Light Remains on When Door is Closed. Adjust light actuator bracket ob bottom of doo r . Unit Develops Frost on Internal Surfaces. Unit is a manual defrost model tha ...
-
U-Line SP18 - page 19
U-Line Warranty 1. U-Line Corporation ("U- Line") warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase. U-Line further wa rrants the sealed system (consisti ng of the com pressor , the condenser , the evaporator , the hot gas bypass valve, the dryer and the co ...
-
U-Line SP18 - page 20
® ABOUT U-LINE Building on 45 y ears, U-Line has captivated those with an a ppreciation f o r the finer things with exceptional design, inspired inno vations and atte ntion to e v en the smallest details. U-Line is synony mous with pr emium built-in undercounter ice making, r efrigeration and wine storage appli- ances, the U-Line Corporation is co ...
Haben Sie eine Frage bezüglich U-Line SP18?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit U-Line SP18 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit U-Line SP18 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.