Bedienungsanleitung Yamaha MV6

20 Seiten 1.37 mb
Download

Zur Seite of 20

Summary
  • Yamaha MV6 - page 1

    MIXER Owner’ s Manual Thank you f or purchasing the Y AMAHA MV12/6 Mix er . The MV12/6 mix er is designed to pro v ide the user with an ideal balance of operabilit y , functionality , and simplicity . In orde r to get the most out of your MV12/6 mix er and its functions, and to enjoy y ears of t r ouble-free use, please read this Ow ner’ s M an ...

  • Yamaha MV6 - page 2

    MV12/6 — Owner’ s Manual FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connect ...

  • Yamaha MV6 - page 3

    MV12/6 — Owner’ s Manual Important Read the following before operating the MV12/6 Important 1 W arnings • Do not place a container with liquid or small metal objec ts on t op of this unit. Liquid or metal objects inside this unit are a fir e and electrical shock hazard. • Do not allow water t o enter this unit or allow the unit to bec ome w ...

  • Yamaha MV6 - page 4

    MV12/6 — Owner’ s Manual 2 MV12/6 Features • The MV12/6 offers 12 input channels that can be mix ed into stere o, monaural, or t o four group outputs. • A MONITOR jack offers easy c onnection to a sub amp for monito r- ing. I t allows monit oring of the main ster e o output, T APE IN inpu t and the signals from groups 1-2, 3-4. • The mixe ...

  • Yamaha MV6 - page 5

    MV12/6 — Owner’ s Manual Front & Rear Panels 3 q y tt o u e ii r r w Channels 1-8 (Monaural) Channels 9-12 (Stereo) Response [dB] +5 +10 +15 – 15 – 10 – 5 0 Frequency [Hz] 10k 1k 100 20k 20 +20 – 20 Front & Rear Panels Channel Control Section q GAIN Control Adjusts the inpu t level of the sig nal entering the mix er t o an optim ...

  • Yamaha MV6 - page 6

    MV12/6 — Owner’ s Manual 4 Front & Rear Panels y EFFECT Control Controls the level of the signal sent from each channel to the EFFECT bus. This control is located aft er the channel fad er so its level will also be affected by the channel fader setting. When a st ereo channe l is used, L and R channel signals are c ombined and sent t o the ...

  • Yamaha MV6 - page 7

    MV12/6 — Owner’ s Manual Front & Rear Panels 5 q i !5 w !3 !0 er !1 !4 !2 t o y u q ST Master Fader Controls the level of the signal that is sent to the ST OUT jacks. w MONO Control Controls the level of the signal (the monaural sig nal that is formed by c ombining the signals from the STEREO bus) that is sent to the MONO OUT jack. e GROUP ...

  • Yamaha MV6 - page 8

    MV12/6 — Owner’ s Manual 6 Front & Rear Panels u DIGIT AL EFFECT • PROGRAM Select Switch Selects a program from the built-in digital effects. VOCAL ECHO 1 VOCAL ECHO 2 VOCAL ECHO 3 VOCAL ECHO 4 VOCAL REVERB 1 VOCAL REVERB 2 VOCAL REVERB 3 VOCAL REVERB 4 • P ARAMETER Control Controls paramet ers (effect level, speed, etc.) of the selecte ...

  • Yamaha MV6 - page 9

    MV12/6 — Owner’ s Manual Front & Rear Panels 7 q INPUT Jacks (CH 1-8) Both balanced XLR typ e and E uro-block c onnectors ar e supplied. • XLR T ype (1:Ground, 2:Hot, 3:Cold) • Euro-block connectors ( : Hot, : Cold, G: Ground) U se Input Select Switch to mat ch the input to the type of mic or dev ice connected t o the INPUT jack. • MI ...

  • Yamaha MV6 - page 10

    MV12/6 — Owner’ s Manual 8 Front & Rear Panels t SEND Jacks • AUX1, AUX2 These are impedanc e balanced phone typ e output jacks with a nominal output/impedance of +4dB/ 600 Ω . The A UX1, 2 bus sig nals ar e output from the ir respectiv e jacks. These jacks can be used to send the signal to monitor system suc h as a cue-bo x. • EFFECT ...

  • Yamaha MV6 - page 11

    MV12/6 — Owner’ s Manual Front & Rear Panels 9 !1 MONO OUT Jack This signal is the monaural mix of the STEREO bus’ s stereo signal. Its level is co ntrolled with the MONO control. T wo ty pes of j acks ar e pro vided; balanced XLR typ e and E uro-block c onnectors. • XLR type (1: Ground, 2: Hot, 3: Cold) No minal output/impedance +4dB/6 ...

  • Yamaha MV6 - page 12

    MV12/6 — Owner’ s Manual 10 Front & Rear Panels ■ Changing the connector panel’ s location. The mixer allo ws attachment of the connecto r panel to either the rear or to the t op-side of the mixer t o pro vide optimum location of the connectors when installing the unit. The connector pane l is attached on the rear of the unit when it is ...

  • Yamaha MV6 - page 13

    MV12/6 — Owner’ s Manual About the Accessories 11 About the Accessories Euro-block Connectors If you decide to use E uro-block connectors, please use the supplied connectors and attac h as shown in the illustration below . q T urn the PO WER switch OFF . w Loosen the screws holding the c ov er in place and r emov e the co v er . Euro-block conn ...

  • Yamaha MV6 - page 14

    MV12/6 — Owner’ s Manual ST OUT AUX 1 SEND AUX 2 (PRE) SEND INSERT IN INSERT OUT PHONES TAPE IN REC OUT INPUT MONO OUT 12 Applications Applications Example 1) Basic Setup Procedure q Connect line input devices or micro pho nes t o the INPUT jacks and connect a pow er amp , that is connected t o the main sp eake rs, to the ST OUT J a cks. w U se ...

  • Yamaha MV6 - page 15

    MV12/6 — Owner’ s Manual ST OUT AUX 1 SEND AUX 2 (PRE) SEND PHONES TAPE IN REC OUT INPUT GROUP OUT   1   2   3   4 Applications 13 Example 2) Banquet Room Setup Using Independent Speakers Procedure q Connect line input devices or micro pho nes t o the INPUT jacks and connect a pow er amp , that is connected t o the main sp eake rs, to t ...

  • Yamaha MV6 - page 16

    MV12/6 — Owner’ s Manual Frequency response 20Hz — 20kHz +1dB, -3dB @+4dB, 600 Ω (INPUT GAIN Control at minimum level) T otal harmonic distortion <0.1% (THD+N) @+14dB, 20Hz — 20kHz, 600 Ω Hum & Noise -128dB Equivalent input noise -95dB Residual output noise -64dB (68dB S/N) ST OUT : Master fader and one channel fader at nominal l ...

  • Yamaha MV6 - page 17

    MV12/6 — Owner’ s Manual Supplement 15 ■ Input Specifications Input Input GAIN Input Nominal Input level Connector type connectors Select Switch Control impedance impedance Sensitivity *1 Nominal Max. bef ore clipping MIC (+48V) -60 -80 dB (0.078mV) -60 dB (0.775mV) -40 dB (7.75mV) MIC 50-600 Ω INPUT LINE -34 3k Ω mics & -54 dB (1.55m ...

  • Yamaha MV6 - page 18

    MV12/6 — Owner’ s Manual 16 Supplement 192 308 482 18.7 Units: mm Dimensions ...

  • Yamaha MV6 - page 19

    MV12/6 — Owner’ s Manual Supplement 17 CH INPUT 1~4ch INPUT [-60~+10dB] INSERT OUT [0dB] PAD HA GAIN [-60dB~-16dB] [-34dB~+10dB] [0dB] Lo Mid Hi 3-Stage EQ PEAK Ch.Fader [-10dB] BA [0dB] [0dB] 1-2 3-4 ST [-6dB] PAN POST AUX1 AUX2 EFFECT INSERT IN [0dB] MIC(+48V) MIC LINE +48V BA CH INPUT 5~8ch PAD ST INPUT 9/10ch, 11/12ch [-34~+10dB] L R HA HA ...

  • Yamaha MV6 - page 20

    Y AMAHA CORPORA TION Pro Audio & Digital Musical Instrument Division P .O. Box 3, Hamamatsu, 430-8651, Japan V639260 R2 1 CP 20 NP Printed in T aiwan ...

Produzent Yamaha Kategorie Musical Instrument

Dokumente, die wir vom Produzenten des Geräts Yamaha MV6 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Yamaha
- Bedienungsanleitungen MV6
- Produktkarten Yamaha
- Informationsbroschüren
- oder Energieetiketten Yamaha MV6
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Yamaha MV6.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Yamaha MV6, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Yamaha MV6. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Yamaha MV6 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Yamaha MV6, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Yamaha MV6 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Yamaha MV6 verständlich ist.

Eine gänzliche Bedienungsanleitung von Yamaha sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Yamaha MV6 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Yamaha MV6 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Yamaha MV6, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Yamaha MV6 - die uns die ersten Schritte während der Nutzung von Yamaha MV6 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Yamaha MV6 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Yamaha MV6 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Yamaha MV6?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Yamaha MV6 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Yamaha MV6 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)