-
Electrolux HE 3160 - page 1
CHDE 3160 HE 3160 Cooker Hood Operating and Installation Instructions ...
-
Electrolux HE 3160 - page 2
2 Contents Safety warnings 3 For the User 3 For the Installer 3 Description of the Appliance 5 Extractor version 5 Filter V ersion 6 Control Panel 7 Maintenance and care 8 Cleaning the hood 8 Metal grease filter 8 Removing the metal grease filter 8 Charcoal filter 9 Changing the light bulb 1 0 What to do if 1 1 Service and Spare Parts 1 2 Guarantee ...
-
Electrolux HE 3160 - page 3
3 Safety warnings For the User The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep fryi ...
-
Electrolux HE 3160 - page 4
4 When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole. National and regional building regulations impose a number of restrictions on using hoods and fuel-burning appliances connected to a chimney , such as coal or oil room- ...
-
Electrolux HE 3160 - page 5
5 A B Description of the Appliance The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter . Y ou will need an original AEG charcoal filter for this function (A vailable from your local AEG Service Force Centre). Extractor version In this version fumes are extracted to the ...
-
Electrolux HE 3160 - page 6
6 E E E Filter version The air is filtered through a charcoal filter and returned to the kitchen. Y ou will need an original AEG charcoal filter for the filtering function. (Available from your local AEG Service Force Centre). Remove the grease filters, first pull the handles upwards, then extract the filter outwards. Fig. 3 . Fit t ...
-
Electrolux HE 3160 - page 7
7 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. T urn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappea ...
-
Electrolux HE 3160 - page 8
8 Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild deter- gent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motor s protect ...
-
Electrolux HE 3160 - page 9
9 Dishwasher Place grease filters in dishwasher . Select the most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry . When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur , this does not have any impact on its performan ...
-
Electrolux HE 3160 - page 10
10 W arning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe th ...
-
Electrolux HE 3160 - page 11
11 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working Check that: effectively.. The fan speed is set high enou ...
-
Electrolux HE 3160 - page 12
12 Service and spare par ts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Y our call will be automatically routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further info ...
-
Electrolux HE 3160 - page 13
13 Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser , which must be verified by purchase invoice or similar documentation.The guarantee does not cover commercial use. ...
-
Electrolux HE 3160 - page 14
14 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Senlis +33 (0) 44 62 29 29 Germany Nürnberg +49 (0) 800 234 7378 Italy Pordenone +39 (0) 800 ...
-
Electrolux HE 3160 - page 15
15 T echnical S pecifications Dimensions: (in cm): Height 40 Width 59,9 Depth 27 Maximum absorbed power: 200 W Motor absorption: 120 W Lighting: 2 x 40 W Length of the cable: 150 cm Mounting accessories included 1 Flange Ø 100 mm 1 Flange Ø 120 mm 2 Hooks 2 rails 1 Deflector 2 W ashers 4 wood-screws 5 x 45 mm 4 W all plugs Ø 8 mm 1 Metal-screw 2 ...
-
Electrolux HE 3160 - page 16
16 Installing the hood between cupboards with hanging rails Remove the grease filters. Fig. 6 . T ake of f the visor G . Fig. 13 . Mount the two hanging rails directly underneath the edge of the cupboard using three screws 4,5 x 16 mm in each rail. Distance from first hole to front edge of the cupboards sides must be 153 mm. Fig. 8 . ? ...
-
Electrolux HE 3160 - page 17
17 Installing the hood to the wall It is possible to fix the hood in position, if necessary , by only att aching it to the rear wall. Proceed as follows: Drill four Ø 8mm holes on the wall as indicated. Fig. 10 . Insert the four wall plugs supplied into these holes. Screw the two mountings hooks P into the top two wall plugs. Fig. 1 1 ...
-
Electrolux HE 3160 - page 18
18 Fix the base spacer M to the wall with the two screws R 5x45 provided using either the long or the short arm, depending on the depht of the side cupboards. Do not tighten the screws fully . Fig. 1 1 . Fix the hood to the wall by means of the two hooks P previously mounted, but first move the upper brackets S so that the front panel of th ...
-
Electrolux HE 3160 - page 19
19 Draw a line with a pencil on the middle of the internal side of the furnituture door . Fig. 14. Fit the visor upon the internal side of the furniture door so that the line previously marked on it, is visible through the two triangles holes located on the mid upper and lower side of the visor , having care to respect the distance from the ...
-
Electrolux HE 3160 - page 20
LI1W1C ed. 03/04 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www .aeg.hausgeraete.de http://www .aeg.co.uk © Copyright by A E G From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group ...
Haben Sie eine Frage bezüglich Electrolux HE 3160?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Electrolux HE 3160 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Electrolux HE 3160 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.