Bedienungsanleitung Rubbermaid 1S84

16 Seiten 4.27 mb
Download

Zur Seite of 16

Summary
  • Rubbermaid 1S84 - page 1

    RUBBERMAID 7' x 10' 6" RESIN STORAGE BUILDING ASSEMBL Y INSTRUCTIONS Pre-Assembly: • Review the parts list and make sure that no parts are missing. • Review ALL assembly steps before beginning instructions. • Level the area where the shed will be located. • Areas of "fill dirt" should be tamped/compacted to prevent ...

  • Rubbermaid 1S84 - page 2

    Level construction site before beginning assembly of shed. A foundation may be constructed if desired. 1 FLOOR PLAN: Size the construction site to fit the entire floor . Allow clearance for opening front and back doors. OPTIONAL STEP: If desired, recessed anchor locations (8 places) can be used to anchor the shed floor to a foundation after Step 6. ...

  • Rubbermaid 1S84 - page 3

    3 Place the Floor Panel (J-5H51) on the foundation. Connect two Repeat Floor Panels (K-5H52), install Screws (AA) 14 places. Optional Step: If desired, recessed anchor locations (8 places) can be used to secure the Floor to the Foundation, see Step 1. Using a utility knife, cut the long sides of each wall slot tab and then use a screwdriver to knoc ...

  • Rubbermaid 1S84 - page 4

    5 Using a screwdrive r , punch out the screw holes on the top of Left Side Panel (C) 2 places . Connect Left Side Panel (C) into Front Floor (J-5H51). C C Screw Holes click 6 Lubricate dovetails on Left Front Panel (H) 4 places with liquid soap. Connect Left Front Panel (H) into dovetails of Left Side Panel (C), engage snaps on bottom of Left Front ...

  • Rubbermaid 1S84 - page 5

    9 Using a screwdriver , punch out the screw holes on the top of the Left Side Panel (C) 2 places. Align lap joint between Left Side Panels. Connect Left Side Panel (C) into Repeat Floor (K-5H52). C C C C click 10 Install Wall Connectors (Q) 5 places. 2 1 C C 1 2 C Q C 11 Lubricate dovetails on Left Back Panel (E) 4 places with liquid soap. Connect ...

  • Rubbermaid 1S84 - page 6

    13 14 15 16 Lubricate dovetails on Right Back Panel (G) 4 places with liquid soap. Connect Right Back Panel (G) into dovetails of Right Side Panel (D), engage snaps on bottom of Right Back Panel (G) into Repeat Floor (K-5H52). E G D 1 2 1 2 NOTE: Front Gable and Doors not shown. Engage lap joint between Left Back Panel (E) and Right Back Panel (G) ...

  • Rubbermaid 1S84 - page 7

    17 18 19 20 Set the Left Door Panel (AK) face down on the ground. Slide the Hinge Reinforcement (PP) into the hole on the top door pin. The Hinge Reinforcement (PP) will slide in until it is below the end of the door pin. AK PP AK AK PP Starting at the top of the door , slide the Door Reinforcement (NN) onto the groove located on the handle side of ...

  • Rubbermaid 1S84 - page 8

    21 22 23 24 Install Left Door Panel (K) inserting the lower hinge pin into Front Floor (J-5H51) socket, lift the left end of the Gable (M) enough to insert the top hinge pin on Left Door Panel (K) into the Gable (M) socket. M 3 1 2 K 4 Install Right Door Panel (F) inserting the lower hinge pin into Front Floor (J-5H51) socket, lift the right end of ...

  • Rubbermaid 1S84 - page 9

    25 26 27 28 Apply Ridge T ape (HH) to Ridge Cap (GG) 2 places. Snap Ridge Cap (GG) onto the Ridge Beam Assembly covering the seam. GG HH HH GG RS RL GG RS RL Place the Ridge Beam Assembly into cups at the top of each Gable (M). Align slots in Ridge Beam Assembly with holes in Gable (M) tab at back, install Bolt (BB), Washer (CC), and Nut (DD) 1 pla ...

  • Rubbermaid 1S84 - page 10

    29 30 Align slots in Ridge Beam Assembly with holes in Gable (M) tab, install Bolt (BB), Washer (CC), and Nut (DD) 1 place, ONL Y TIGHTEN NUT “FINGER” TIGHT . Bolt Head Washer Nut Plastic T ab on Gable DD CC BB M M R Using a screwdrive r , punch out the screwholes on the Left Skylight Roof Panel (AN ) 6 places. Attach the Skylight (L) to the Le ...

  • Rubbermaid 1S84 - page 11

    Lubricate roof snaps on left side of the front Gable (M) 4 places. Raise the Left Roof Panel (N) onto the left side of the shed assembly , the arrows on the Roof Panel should face the inside of the shed and point towards the Ridge Beam Assembly . R M N 31 32 Using (2) stepstools (1 inside shed, 1 outside shed), lift the bottom of the Roof Panel abo ...

  • Rubbermaid 1S84 - page 12

    Raise the Left Skylight Roof Panel (AN) onto the left side of the shed assembly , the arrows on the Roof Panel should face the inside of the shed and point towards the Ridge Beam Assembly. Using (2) stepstools (1 inside shed, 1 outside shed), lift the bottom of Left Skylight Roof Panel (AN) above horizontal and guide into the Ridge Beam Assembly . ...

  • Rubbermaid 1S84 - page 13

    Install Roof Connectors (T) 8 places. Y ou may need to lift the roof panels to avoid the 2"x6" lumber . 35 T 1 2 2 1 Engage all snaps between the Roof Panels and Gables. Then engage all snaps between Roof Panels and Wall Panels. 36 1 1 2 2 ...

  • Rubbermaid 1S84 - page 14

    Repeat Steps 29-35 for Right Roof of shed. 37 Install Screws (AA) 16 places in front and back Gable (M). 38 Back of shed shown Caution: When installing screws do not overtighten. See Steps 30, 31 See Step 29 See Step 32 See Step 33 AA (16) AP P P N R P L While 1 person holds down the bottom of the Roof, install Screws (AA) 12 places in screw holes ...

  • Rubbermaid 1S84 - page 15

    88.09" 128.85" 94.63" ...

  • Rubbermaid 1S84 - page 16

    Customer Service T oll Free: 1-888-895-2110 M–F 8:30 AM to 5:00 PM EST or visit us at www .rubbermaid.com 1869756 W e hope you enjoy your Rubbermaid ® 7' x 10' 6" Storage Building! For more information on all Rubbermaid ® products, go to www .rubbermaid.com Printed in U.S.A. © 2012 Rubbermaid Incorporated Huntersville, NC U.S.A. ...

Produzent Rubbermaid Kategorie Outdoor Storage

Dokumente, die wir vom Produzenten des Geräts Rubbermaid 1S84 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Rubbermaid
- Bedienungsanleitungen 1S84
- Produktkarten Rubbermaid
- Informationsbroschüren
- oder Energieetiketten Rubbermaid 1S84
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Rubbermaid 1S84.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Rubbermaid 1S84, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Rubbermaid 1S84. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Rubbermaid 1S84 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Rubbermaid 1S84, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Rubbermaid 1S84 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Rubbermaid 1S84 verständlich ist.

Eine gänzliche Bedienungsanleitung von Rubbermaid sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Rubbermaid 1S84 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Rubbermaid 1S84 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Rubbermaid 1S84, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Rubbermaid 1S84 - die uns die ersten Schritte während der Nutzung von Rubbermaid 1S84 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Rubbermaid 1S84 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Rubbermaid 1S84 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Rubbermaid 1S84?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Rubbermaid 1S84 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Rubbermaid 1S84 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)