Bedienungsanleitung Proxim 70443r2

15 Seiten 0.65 mb
Download

Zur Seite of 15

Summary
  • Proxim 70443r2 - page 1

    P/N 70443r2 T sunami QuickBridge II T1/E1 V ersion 2.2 Quick Inst all Guide ...

  • Proxim 70443r2 - page 2

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 2 Introduction The QuickBridge is a com plete kit for enabling a wire less broad bandwidth link between two locations. The equipment is pre-configured at the factory to be mount ed and con ne cted to your LAN network. Both ends of the link ar ...

  • Proxim 70443r2 - page 3

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 3 STEP 2. UNPACK THE SHIPPIN G B OX CONTENTS The product’s shipping boxes shoul d be left intact and shelte red until arrival at the installation site. Carefully unpack the Tsunami QuickBridge II shipment and che ck fo r any shipping damage ...

  • Proxim 70443r2 - page 4

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 4 STEP 3. PRE-ASSEMBLE HARD WARE Proxim recommends that you pre-assemble the radio mounting hardware on the ground to familiarize yourself with the equipment and check for any possible d amaged or missing components before mounting the radios ...

  • Proxim 70443r2 - page 5

    Tsunami QuickBridge II T1/E1 Quick Install Guide 4. Place the other mounting bracket se ction on the two bracket mounting screws and loosely secure them with the bolts supplied. These bolts are used later to mo unt the radio unit to a pole (as shown in the second figure below). STEP 4. CONNECT THE CABLE S When you initially install the radios, y ou ...

  • Proxim 70443r2 - page 6

    Tsunami QuickBridge II T1/E1 Quick Install Guide 3. Connect the RJ45 connector on the inte rface cable to the RJ45 port on the back of the radio. Hand-tighten the connector nut; do not use the wrench to tighten the connector. Connect the other end of the interface cable to the Power & Ethernet Adapter. 4. Connect an RJ45 connecto r from a sta n ...

  • Proxim 70443r2 - page 7

    Tsunami QuickBridge II T1/E1 Quick Install Guide To connect the Power & Ethernet Adapter to a switch or a hub, use a crossover Ethernet cable . 5. If your installed radio is connected to a swit ch or a h ub, connect your PC to the same switch or hub . Each PC is used to configure and control its associ ated ra dio. 6. Connect the Power & Et ...

  • Proxim 70443r2 - page 8

    Tsunami QuickBridge II T1/E1 Quick Install Guide P OLYPROPYLENE F IBER S OUND A BSORPTION P AD STEP 6. INSTALL THE SOFTWARE The QuickBridge II include s configuration software (the QuickBridge Manager), which provides basic setup and operating capabilities. Before installing the software, be sure you have configured the radios as described in “St ...

  • Proxim 70443r2 - page 9

    Tsunami QuickBridge II T1/E1 Quick Install Guide 4. The Choose Install Folder screen is di splayed. The recommended installation directory is C:Program FilesQuickBridge Manager 2.1 . Click Next when you have made your select ion or to acce pt the default folder. 5. The Choose Shortcut Folder screen is displayed; click Next when you have made your ...

  • Proxim 70443r2 - page 10

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 10 2. Connect the PC to the Master unit; start the Manager program by clicking on the QuickBr idge Ma nager icon. You can connect to the Slave unit as well; however, this guide steps you through the initialization process by locally connecti ...

  • Proxim 70443r2 - page 11

    Tsunami QuickBridge II T1/E1 Quick Install Guide Mounting the Radio to a Pole The radio is designed to mount dire ctly to a pole. Using optional mounting b ra ckets, you can mount the radio to a wall or other flat surface (see “Mount ing the Radio to a Flat Surfa ce”). 1. Remove the nuts you loosely attached in “Pre-Assem ble Mounting Hardwar ...

  • Proxim 70443r2 - page 12

    Tsunami QuickBridge II T1/E1 Quick Install Guide Configuring the QuickBridge Radios ESTABLISHING A CONNECTION From the Connection window, cli ck on Discover Radio(s) . The QuickBridge Manag er program should discover all local radios and display the IP addre ss of each discovered unit in the Radio(s) Available field. Notes: • If you want to conne ...

  • Proxim 70443r2 - page 13

    Tsunami QuickBridge II T1/E1 Quick Install Guide 4. If the wireless link is establis hed, you can select either the Local or Remo te device to control from the Selected Radio box. Note: The Selected Radio box is available on all configuration win do ws. It indicates which radio is currently sele cted, Local or Remote . You can change the curre ntly ...

  • Proxim 70443r2 - page 14

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 14 REVIEWING THE MAST ER UNIT’S STATUS From the Link Status window, review the current status of both ends of the QuickBridg e link; in this case, the locally connected radio (Master) and the remote radio (S lave). This window is updated as ...

  • Proxim 70443r2 - page 15

    Tsunami QuickBridge II T1/E1 Quick Install Guide Copyright © 2005 Proxim Corporation. All rights reserved. 15 TECHNICAL SUPPORT If you are having a problem using a Tsunami QuickBri dge pr oduct and cannot resolve it with the information in “Troubleshooting” in the Installation and Management manual, gather the following information and contact ...

Produzent Proxim Kategorie Network Router

Dokumente, die wir vom Produzenten des Geräts Proxim 70443r2 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Proxim
- Bedienungsanleitungen 70443r2
- Produktkarten Proxim
- Informationsbroschüren
- oder Energieetiketten Proxim 70443r2
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Proxim 70443r2.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Proxim 70443r2, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Proxim 70443r2. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Proxim 70443r2 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Proxim 70443r2, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Proxim 70443r2 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Proxim 70443r2 verständlich ist.

Eine gänzliche Bedienungsanleitung von Proxim sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Proxim 70443r2 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Proxim 70443r2 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Proxim 70443r2, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Proxim 70443r2 - die uns die ersten Schritte während der Nutzung von Proxim 70443r2 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Proxim 70443r2 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Proxim 70443r2 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Proxim 70443r2?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Proxim 70443r2 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Proxim 70443r2 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)