-
Baumatic B602.1 - page 1
1 B602.1/B604.1/ B609.1 60 cm Gas fan-assisted oven ...
-
Baumatic B602.1 - page 2
User Manual for your Baumatic B602.1BL/W B604.1SS B609.1SS 60 cm Gas fan-assisted oven NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference; for ...
-
Baumatic B602.1 - page 3
3 Contents E n v i r o n m e n t a l n o t e 4 Important safety informa tion 5 – 8 S p e c i f i c a t i o n s 9 P r o d u c t s p e c i f i c a t i o n s 9 S t a n d a r d a c c e s s o r i e s 1 0 O p t i o n a l e x t r a s 1 0 E l e c t r i c a l d e t a i l s 1 0 Control panel 1 1 B e f o r e f i r s t u s e 1 2 Setting the time of day (B609 ...
-
Baumatic B602.1 - page 4
Environmental note 4 o The packaging materials that Baum atic uses are environmentally friendly and can be recycled. o Please discard all packaging mate rial with due regard for the environment. ...
-
Baumatic B602.1 - page 5
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the info rmation contained in this booklet, please contact the Baumatic Technical Department. General Information o This appliance is ...
-
Baumatic B602.1 - page 6
6 Warning and safety instructions o This appliance complies with all current European safety legislation. Baumatic do wish to emphasise that this compliance does not remove the fact that the appliance surfaces will become hot during use and re tain heat after operation. Child Safety o Baumatic strongly recommend that babies and young children are p ...
-
Baumatic B602.1 - page 7
7 o Do not place heavy objects on the oven door or lean on the oven door when it is open, as th is can cause damage to the oven door hinges. Nobody should be allowed to sit or stand on any part of the oven. o Do not heat up unopened food containers, as pressure can build up which may cause the container to burst. o Do not place flammable or plastic ...
-
Baumatic B602.1 - page 8
Cleaning o Cleaning of the oven should be carried out on a regular basis. o Great care should be taken whils t using this appliance and when following the cleaning procedure. o IMPORTANT: The appliance must be disconnected from the mains before following the cleaning procedure. Installation This appliance must be correctly installed by a suitably q ...
-
Baumatic B602.1 - page 9
Specifications ( IMPORTANT: The above drawing does not show the ventilation requirements that are necessary for installing this appliance, please refer to the installation instru ctions for this information). Product Dimensions Aperture Dimensions Height: 591 mm 580 mm – 583 m m Width: 597 mm 556 mm - 560 mm Depth: 525 mm 550 mm Cooling fan o A t ...
-
Baumatic B602.1 - page 10
10 Standard accessories o Removable side racks o 2 x safety shelves o Enamelled drip tray with handle o Trivet o LPG conversion jets Optional extras o BPS1 Pizza stone Electrical details Rated Voltage: 230 Vac 50 Hz Supply Connection: 13 A (double pole switched fused outlet with 3mm contact gap) Fuse rating: 3 amp Max Rated Inputs: 0.075 kW Mains S ...
-
Baumatic B602.1 - page 11
Control Panel B602.1/B604.1 B609.1 11 ...
-
Baumatic B602.1 - page 12
Before first use o To remove any residue from the oven that may have been left from the manufacturing process, you should select the gas oven and set it to its maximum temperature setting. o It is perfectly normal for a smell to be produced during this process. o You should make sure that any windows in the room are left open during this process. o ...
-
Baumatic B602.1 - page 13
Switching the gas oven on The oven has electric ignition, to lig ht it you should do the following:- o Open the door of the appliance. o Push the oven function and te mperature control knob down slightly and then turn it anti clockwise to the word MAX. o Whilst it is pointed to the MAX position, fully push down this knob and hold it down. o The gas ...
-
Baumatic B602.1 - page 14
Switching the gas grill on The grill has electric ignition, to light it you should do the following:- o Open the door of the oven and fit the grill defllector to the front of the appliance. o Push the oven function and temperature control knob down slightly and then turn it anticlockwise to the grill symbol (shown above) o Whilst it is pointed to t ...
-
Baumatic B602.1 - page 15
Operation of the fan o After igniting the oven and shutti ng the door of the appliance, check to make sure that the fa n on the rear wall of the oven cavity is turning. o IMPORTANT: If there is a power cut wh ilst the oven is in use, then you should immediately turn the oven off until power is restored. o If the cooling fan does not operate and the ...
-
Baumatic B602.1 - page 16
16 Warnings o Keep the oven door op en when using the grill function and make sure that the grill deflector is fitted. o Do not use aluminium foil to cover the grill pan or heat items wrapped in aluminium foil under the grill. The high reflectivity of the foil could potentially damage the grill element. o You should also never line the base of your ...
-
Baumatic B602.1 - page 17
Setting a countdown time (B609.1SS only) o Press button (C) and the numbers on the timer display will begin to advance and a symbol will illuminate. o Use buttons (B) and (C) to adjust the time on the timer display, until it shows the length of time that you want the oven to countdown for. o The maximum countdown time that can be set is 99 minutes ...
-
Baumatic B602.1 - page 18
Using the minute minder (B602.1 & B604.1) The minute minder can be used independently of an oven cooking function for a time period of up to 60 minutes. o To set the timer, turn the knob fully clockwise until it stops and then turn it back anticloc kwise to the required time. o The time period that has been set will expire when the control knob ...
-
Baumatic B602.1 - page 19
Cleaning and maintenance Cleaning operations must only be carried ou t when the oven is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. o The oven should be th oroughly cleaned before it is operated for the first time and after each use. This will avoid residual food stuffs becoming baked on ...
-
Baumatic B602.1 - page 20
Replacing the oven bulb IMPORTANT: The oven must be disconnected from your mains supply before you attempt to either remove or replace the oven bulb. o Remove all oven shelves and the drip tray to make it easier to access the bulb. o Remove the light cover by turning it anti-clockwise. o Unscrew the bulb clockwise and remove it from its holder. o R ...
-
Baumatic B602.1 - page 21
Removing the oven door for cleaning To facilitate the cleaning of the insi de of the oven and the outer frame of the oven, the door ca n be removed as follows:- o The hinges (A) have two movable bolts on them (B) . o If you raise both of the movable bolts (B) , then the hinges (A) are released from the oven housing. o You should grip the sides of t ...
-
Baumatic B602.1 - page 22
Removing the inner door glass for cleaning o Do not use any abrasive cleaner that could cause damage. o Remember that if the surface of the glass panel becomes scratched, this could lead to a dangerous failure. o To facilitate cleaning, the door glass can be lifted out after removing the fixing screws and tu rning the metal stoppers that hold the g ...
-
Baumatic B602.1 - page 23
o To connect the oven power cord, loosen and remove the cover on the terminal block, in order to gain access to the contacts inside. Make the connection, securi ng the cord in place with the cable clamp provided and then immediately close the terminal block cover again. o If you have to change the oven power cord, the earthing (yellow/green) conduc ...
-
Baumatic B602.1 - page 24
Installing the oven into the kitchen cabinet Positioning the appliance o Ensure that the aperture that you will be fitting the oven into is of the size given in the above diagram. o The oven must be fitted into an oven housing with the ventilation cut-outs shown in the “Ventilati on requirements” section on the next page. o Ensure that the rear ...
-
Baumatic B602.1 - page 25
Ventilation requirements o You should remove the rear pa nel of the housing unit before attempting to install the oven. A full depth shelf must be incorporated into the housing and positioned 50 mm below the support shelf for the appliance. o A minimum ventilation gap of 90 mm must be allowed between the rear of the support shelf an d the rear of t ...
-
Baumatic B602.1 - page 26
Additional built under ventilation requirements o Remove the horizontal strengthen ing support at the upper front housing unit. o If your housing unit incorporates a domestic lower drawer, this must be made non-functioning with a ventilated false front. o A 5 mm ventilation gap must be allowed between the top of the appliance and the unde rside of ...
-
Baumatic B602.1 - page 27
Gas connection This appliance must be installed by a competent person in accordance with the current versions of the following UK (United Ki ngdom) or ROI (Republic of Ireland) Regulations and Safety Standards or their European Norm Replacements. Important information o This oven is supplied to run on natural gas only and cannot be used on any othe ...
-
Baumatic B602.1 - page 28
28 o Ensure that the room containing the oven is well ventilated, keep natural ventilation holes. o Prolonged intensive use of the appliance may call for additional ventilation. o This oven is not fitted with a device for discharging the products of combustion. Ensure that the ventilation rules and regulations are followed. o Your oven must stand o ...
-
Baumatic B602.1 - page 29
Gas connection ALL INSTALLATION AND SERVICE WORK MUST BE CARRIED OUT BY A CORGI REGISTERED ENGINEER. 29 o Prior to in stallation, ensure that the gas supply conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The ad justment conditions for this appliance are stated on the rati ng plate which can be found on ...
-
Baumatic B602.1 - page 30
Gas adjustment (Conversion to LPG and gas adjustment) IMPORTANT: Your appliance must be disconnected from t he electric and gas supply before completing this process. Power inputs Natural Gas LPG Oven 2.74 kW (injector size 115) 2.74 kW (injector size 80) Grill 2.4 kW (injector size 115) 2.4 kW (injector size 80) Gas details Gas Connection Type: 1/ ...
-
Baumatic B602.1 - page 31
o Remove the grill burner. o Replace the injector with one suitable for LPG (see power inputs information). It is recommended that the appropriate thread sealant is used; always check for gas tightness after assembly. o Re-fix the grill burner, no further adjustments are necessary. o Remove the control panel cover from the top of the appliance. o R ...
-
Baumatic B602.1 - page 32
32 o Adjust the bypass setting until the correct flame picture is achieved. o Refit the control knob, then turn it to the Max position and then back to Min several times, checking that the flame is maintained. o Fully open and close the oven d oor several times and check that the flame is maintained. o Turn the appliance off and disco nnect it from ...
-
Baumatic B602.1 - page 33
I am getting condensation in my oven * Steam and condensation is a natu ral by product of cooking any food with high water content, su ch as frozen food, chicken etc. * You may get condensation in the oven cavity and forming between the oven door glasses. This is not necessarily a sign that the oven is not working correctly. * Do not leave food in ...
-
Baumatic B602.1 - page 34
34 Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Ba umatic appliance com es complete with a free 12 month guarantee cove ring bot h parts an d labour costs resulting from defective materials or workmanship. Baumatic also gives you the opportun ity to automatically extend the guarantee period for a further 12 months at no extra cost, ...
-
Baumatic B602.1 - page 35
Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Advice Telephone +44 118 933 6933 E-mail : sales@baumatic.co.uk technical@b ...
-
Baumatic B602.1 - page 36
36 ...
Haben Sie eine Frage bezüglich Baumatic B602.1?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Baumatic B602.1 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Baumatic B602.1 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.